V1.0 | 24.03.2020 |Page 5
Please contact your reseller to know the LEDs behavior if the applicave soware
installed on the Wanesy™ Wave is not the one ocially provided by KERLINK.
For more informaon on the Quick start of Wanesy™ Wave Gateway, please consult the Kerlink
Wiki: hp://wikikerlink.fr/wanesy-productline/wave
The power supply of the Wanesy™ Wave 868 must be a limited source of power.
Note that some countries in Europe may have specic frequency ranges, EIRP and
duty cycles regulaons.
Check the local regulaons before installing and commissioning the Wanesy™ Wave
868.
For other countries, outside Europe, check the frequency range, the maximum EIRP
and duty cycle allowed.
The power supply of the Wanesy™ Wave 915 must be a limited source of power.
Note that:
KERLINK IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Some condions have to be respected to maintain the FCC compliance of the devices
in the USA. Please contact your reseller to have details.
For other countries, check the specic regulaons regarding maximum EIRP and duty
cycle allowed.
7. Declaraon of Conformity
7.1 Wanesy™ Wave 868
Simplied EU Declaraon of Conformity
Hereby, Kerlink, declares that the radio equipment type Wanesy™ Wave 868 is in compliance with
Direcve 2014/53/EU.
The full text of the EU Declaraon of Conformity is available at the following internet address:
www.kerlink.com/support
In Europe, the Wanesy™ Wave 868 staon must comply with the ERC 70-03 requirements
regarding duty cycle and maximum EIRP. They are summarized in the following table:
ERC 70-03 Frequency (MHz) Power Duty cycle
h6 868-868,6 14dBm ERP 1%
7.1 Wanesy™ Wave 915
The Wanesy™ Wave 915 is in compliance with FCC regulaons.
The associated FCC idener of the Wanesy™ Wave 915 is:
Model: Wanesy™ Wave
FCC ID: 2AFYS-KLKWAVE915
