KeepGuard KG Series Manual de usuario
This KeepGuard cam is the best-selling scouting camera which is designed for activity and is resistant against water and snow. It is
equipped with built-in infrared LEDs, so that it can be triggered by any movement in a location, then take high quality pictures or
video clips. Please refer to the notes below and instructions in this manual to ensure that you are completely satisfied with this
product.
Quick Start 2
Notes 3
View Drawings 4
Camera Overview 5
Standard Accessories 6
Power Supply 7
SD Card 7
Operational Modes 8
Settings 9~16
Mounting and Positioning 17
Specification 18
Warranty Card 19
KEEPTIME
Applicable models：KG790
Contents
Highly Recommended by Outdoor Explorers - KeepGuard Wildlife Scouting Cam KG Cams Instruction Book
1
Move the latches and open the front cover
Load 8 lithium AA or alkaline AA batteries
Insert the SD card
Switch to the SETUP Mode
Press MENU key
Press UP key to select Camera or Video Mode
Put it good position
Switch to the ON Mode and it have started working
KEEPTIME
Quick Start
2
1. When setting camera parameters, please put camera in Setup mode.
2. Do not set the camera directly from ON to Setup.
3. To replace the battery, SD card, firstly turn camera to OFF model.
4. Color of Indicator
1) When camera is updating, indicator light flashes green.
2) The indicator light flashes red when it is turned on or ready for operation.
3) low battery, the indicator light blue.
4) long standby time, the indicator flashes purple.
5. Batteries need to use dry batteries, can not use rechargeable batteries.
6. When the SD card is inserted into camera, make sure that the SD card is not in the unprotected state.
7. When using an external power supply, make sure that voltage is correct.
8. Please take out the battery for long time unused, so as to avoid leakage of the battery time is too long.
9. Camera can not be directly immersed in water, can not be placed in the environment of strong acid and alkali.
10. Finger can not press the Fresnel lens.
11. Keep the lens and battery compartment clean.
12. Do not use sharp hard objects to attack the screen and so on.
KEEPTIME
Notes
3
View Drawings
KEEPTIME
4
Camera Overview
KEEPTIME
「IR LED」
「LDR」
「PIR」
「Lens」
「LED Indicator」
「lock catch」
「Display Screen」
「Operation Part」
「Battery Case」 「ON-OFF Key」
5
1× Security Case 1×Adapter 1×Micro-Lens / Wide-angel Lens 1×Cradle Head 1×solar panel
KEEPTIME
Standard Accessories
1×Belt 1×USB 1×Case 1×Manual
Other Accessories
6
After opening the two latches on the right side of the camera,
you will see that it has 8 battery slots. For maximum battery
life, we recommend using 8 lithium AA or alkaline AA batteries.
Please be sure to insert each battery with correct polarity
(negative or“flat”end against the long spring of each battery
slot).
Insert the SD card ( OFF mode ) before beginning to operate the
camera. SD card is supported up to maximum 64GB capacity.
KEEPTIME
Power Supply
SD Card
64G
B
7
●「SETUP」Mode
In the SETUP mode you can check and change the settings of the cam with the help of built-in LCD. Moving the power switch to the
SETUP position will turn on the LCD display and you will see an information screen.
The cam has three basic operational modes: 「OFF」, 「ON」 and 「SETUP」
●「OFF 」Mode
When cam in OFF mode, you can do the following:
• replacing the SD card or batteries
• connecting cam with other device by USB port
It will occur a little of power consumption under OFF mode. If you won't use it for a long time, please take batteries off.
●「ON」Mode
Once in ON mode no manual controls are needed or possible (the control keys have no effect). The cam will take photos or videos
automatically (according to its current parameter settings) when it is triggered by the PIR sensor′s detection of activity in the area it covers.
TT
3M 1080P
0000/0888
Camera Mode
Time Stamp ON
Time Scan ON
SD Card Battery Level
Video Mode
Image Resolution of Photos Taken Audio Rec ON Video Resolution Available Video
Recording Time
KEEPTIME
Operational Modes
8
Clock
Mode
Image Size
Set Exit
Set Clock
OK
Set
MENU
Set Exit
Mode
OK
Video
MENU
Press OK and use UP/DOWN keys ( to change the setting )
and LEFT/RIGHT keys ( to move to the next field ) to set the
hour ( 24-hr format only, “00”=midnight,“12”=noon)
and minute, and then (on the lower row ),the year,month
and date. Once all settings are made, press OK to save.
Dual
Camera Selects whether still photos or video clips are captured when
the camera is triggered. “Dual”=Camera+Video
Set Exit
Image Size
OK
8M
MENU
16M
3M Selects resolution for still photos from 3 to 16 megapixels.
Higher resolution produces better quality photos, but creates
larger files that take up more of the SD card capacity.
KEEPTIME
Settings
9
Capture Number
Image Quality
Image Format
Set Exit
Capture Number
OK
9
MENU
Set Exit
Image Quality
OK
Fine
MENU
Selects how many photos are taken in sequence per trigger
in Camera mode. This setting affects photos taken in Field
Scan mode as well.
Super Fine Selects image resolution (in pixels per frame). Higher
resolution produces better quality, but creates larger files
that take up more of the SD card capacity (fills up faster).
Image Format
4:3
Set Exit
OK MENU
KEEPTIME
Settings
Normal
16:9
10
Otros manuales para KG Series
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Cámara digital de KeepGuard
