Kalorik USK STP 1 Manual de usuario
Steam press
Prensa de planchar
USK STP 1
120V~60Hz 1350W
2
USK STP 1 - 070502
IMP RTANT SAFEGUARDS
1. READ ALL INSTRUCTI NS
2. Use the appliance only for its intended use.
3. Chec that your mains voltage corresponds to that stated on the
appliance.
4. To protect against electrical shoc do not immerse cord, plugs, or
appliance in water or other liquid.
5. The power switch must always be put in “OFF” position before
plugging or unplugging from the outlet. Never yan the cord to
disconnect form the outlet; instead, grasp the plug and pull to
disconnect.
6. Do not allow the cord to touch the hot surfaces. Let the
appliance cool down completely before putting it away.
7. Always disconnect the appliance from the electrical outlet when
filling with water or emptying and when not in use. Be careful to
avoid spilling water on the appliance when filling.
8. Do not operate the appliance with a damaged cord or plug or
after the appliance has been dropped or damaged in any
manner. To avoid the ris of electric shoc , do not disassemble
the appliance, ta e it to a qualified serviceman for examination
and repair. Incorrect reassembly can cause a ris of electric
shoc when the appliance is used.
9. Close supervision is necessary when the appliance is used by or
near children.
10. Burns can occur from touching hot metal parts, hot water or
steam.
11. If the appliance is not operating normally, disconnect from the
power supply and have the appliance serviced by an authorized
service center.
12. Do not let the cord hang over the edge of counters.
13. Always put the appliance in a secure place on a table or counter
when using.
14. Do not move the appliance without unplugging it first.
3
USK STP 1 - 070502
15. Use distilled water in the appliance. Do not use perfumed or
products containing alcohol in the appliance.
16. This appliance must be grounded. Do not alter the plug or
attempt to defeat this feature.
17. This appliance IS N T intended for use by young children or infirm
persons unless they have been adequately supervised by a
responsible person to ensure that they can use the appliance
safely.
18. Young children should be supervised to ensure that they D N T
play with the appliance.
SPECIAL INSTRUCTI NS
• To avoid a circuit overload, do not operate another high
wattage appliance on the same circuit.
• If an extension cord is absolutely necessary, a 10-ampere cord
should be used. Cords rated for less amperage may overheat.
Care should be ta en to arrange the cord so that it cannot be
pulled or tripped over.
SAVE THESE INSTRUCTI NS
P LARIZED PLUG INSTRUCTI NS
This appliance has a polarized plug (one blade is wider than the
other). To reduce the ris of electric shoc , this plug will fit into the
polarized outlet only one way. If the plug does not properly fit into
the outlet at first, reverse it. If it still does not fit, contact a competent
qualified electrician. Do not attempt to modify the plug in any way.
4
USK STP 1 - 070502
PART DESCRIPTI N
1. Handle
2. Loc ing nob
3. Burst of steam button
4. Pressing plate
5. Ironing board
6. Control panel
A. Power light (red)
B. Ready light (green)
C. Steam ready light (yellow)
D. ON/OFF switch
E. Temperature selector
7. Water tan
8. Ironing board cover
9. Pressing cushion
10. Spray bottle
11. Water bea er
5
USK STP 1 - 070502
BEF RE USE
Set the appliance on a sturdy wor surface. Unloc the loc ing nob.
FILLING THE WATER TANK
Use preferably demineralised water. If you want to use the steam
function fill the water tan as follows:
1) Unplug the steam press from the outlet to let it cool down.
2) The pressing plate must be lifted to the raised (up) position.
3) Slide the water tan towards the front of the unit. It will not come
completely out so do not force it to do so. Using the water
bea er, slowly pour the distilled water into the water tan . Never
overfill the water tan . The water level can be seen through the
front of the tan .
4) Be careful to avoid spilling water onto the steam press when
filling.
5) Slide the water tan bac in.
6) When pressing, unplug the appliance before refilling.
USE
• Ma e sure the loc ing nob is in the open position (UNLOCK)
allowing free movement of the pressing plate before plugging in
the appliance.
• Lift the pressing plate to the fully raised (up) position.
• Plug the appliance into an electric outlet.
• Press “ON/OFF” and the red power light will turn on.
TEMPERATURE SETTINGS
• You can chose the temperature setting according the cloth to
press (see table below).
• Press the *SELECT* arrow buttons to choose the ind of fabric you
wish to press. Press to move selection to higher setting and
press to move selection to lower setting. If you doubt, have a
loo at the garment label.
• When the green ready light goes off, the pressing plate has
reached the temperature for the desired setting.
6
USK STP 1 - 070502
• When changing the setting from a higher selection to a lower
setting allow several minutes for the pressing plate to cool
sufficiently after ma ing the change.
Kind of textile Temperature Steam
Nylon 100°C / 212°F N
Silk 130°C / 266°F N
Rayon 140°C / 284°F N
Wool 160°C / 320°F YES
Cotton 200°C / 392°F YES
Linen 210°C / 410°F YES
N TE: You may find it more efficient to arrange your fabrics from
those requiring the lowest setting to those requiring the highest
setting and proceed accordingly. This will avoid any unnecessary
delay or wait for the pressing plate to cool.
STEAM C NTR L
• Steam is produced only when the yellow steam ready light is on.
• The green ready light goes off when the unit has reached the
desired temperature. The yellow steam ready light will come on
when the unit is ready to produce steam.
• If this is the first time you are using the steam press or you have
been storing it for some time, lift the pressing plate into the raised
position and press the burst of steam button several times until the
steam begins to flow.
• The burst of steam function can only be used when the steam
ready light is on AND the steam press is in a slightly opened
position. Do not use the burn of steam function when the steam
press is closed, or you may damage the unit.
•
Do not press the burst of steam button for more than 5 seconds or
water may drip on your garment.
7
USK STP 1 - 070502
PRESSING
• Ma e sure the loc ing nob (2) is in the open position (UNLOCK).
• Lift the handle (1). The pressing plate (4) moves to the up position.
• Carefully arrange the garment to be pressed onto the ironing
board (5).
• Grasp the handle of the pressing plate(4) and lower it onto the
ironing board (5), capturing the garment between the two halves
of the steam press.
• For lightly creased garments, simply lowering the handle and
allowing the pressing plate to rest on the ironing board will be
sufficient. Return to the open position. For very creased garments,
continue to grasp the handle and press downward until the
pressing plate is pushed to its lowest position, then open the press.
• If the temperature is set high enough you may give the fabric a
burst of steam by pressing the burst of steam button (3) to
remove stubborn wrin les. Lower the pressing plate until it is about
two inches from the garment. Press the burst of steam button for
about 3-5 seconds. After releasing the burst of steam button you
may fully lower the pressing plate.
N TE: Do not press the burst of steam button when the pressing
plate is in its lowest (closed) position.
• After a few seconds, lift the handle and raise the pressing plate
bac to the raised position.
USING THE SPRAY B TTLE
Lightly spray the garment before placing it on the ironing board. This
helps to distribute an even, fine mist over the fabric, preparing it to
be pressed, and removing all wrin les.
USING THE PRESSING CUSHI N
Some garments have been constructed with details, such as darts,
curved seams and shoulder pads, which are not intended to be
pressed flat. A pressing cushion is supplied with your steam press for
use with these areas.
• Use the cushion whenever pressing areas where no creases are
desired or to shape tailored garments.
• Place the area to be pressed onto the ironing board.
8
USK STP 1 - 070502
• Place the pressing cushion under the dart, seam etc.
• Ma e sure the area to be pressed is raised and lower the pressing
plate. The raised area is the only area the plate should contact.
N TE: Do not attempt to lower the pressing plate to its lowest
position or loc the pressing plate against the ironing board with
the pressing cushion in place. You MAY DAMAGE the steam press
by doing so.
•
Raise the pressing plate after a few seconds.
ST RING
• Water may be left in the water tan , because it will not drip out if
the machine is stored in an upright position. However, it is
recommended that if the machine will be stored for some time,
that all the water in the unit should be drained by pressing the
burst of steam button until all of the water is pumped out.
• Press “ON/OFF”, the red power light will go out. Disconnect the
plug from the outlet. Leave appliance in open position.
• Wait for the steam press to cool completely (approximately 30
minutes).
• When cool, lower the pressing plate onto the ironing board
pushing the handle to its lowest position.
• Turn the loc ing nob to the loc ed position. This should prevent
the steam press from opening while being moved or stored.
• Loosely wrap the electric cord
and place it in the opening at
the front of the base of the
ironing board. You are now ready
to store the unit.
CLEANING
• To clean the pressing plate, place the pressing cushion in the
center of the ironing board. Place a clean towel over the
pressing cushion and the ironing board. Set the temperature
control to its maximum setting. When the ready light comes on
and the steam ready light goes off, gently lower the pressing
plate onto the pressing cushion. With water in the water tan ,
press the burst of steam button 6 to 7 times. Be careful to avoid
9
USK STP 1 - 070502
touching the hot metal surfaces or leaving your hand in the bursts
of steam.
• Once the pressing plate has cooled down you can clean the
surface with a damp cloth. DO NOT use any abrasives on the
pressing plate. This pressing plate has a non-stic coating that will
assist in cleaning.
• The ironing board cover is removable for normal washing. You
can rinse the ironing board cover with mild detergent and warm
water.
SAFETY FEATURES
The multiple function safety features of this appliance turn off electric
power to the heater when the pressing plate has been left against
the ironing board for about 10 seconds. You will hear a warning
beep. If the pressing plate is left in the open (up) position without use
after approximately 15 minutes, the unit will be automatically shut-
off. In either case, to restore the unit, you have to press “ON/OFF”
again.
TR UBLE SH TING
PR BLEM CAUSE S LUTI N
Steam press cannot
be opened with the
handle
Loc ing nob is in
loc ed position
Turn the loc ing nob
to the unloc ed
position
Steam press
becomes warm but
D ES N T remove
wrin les.
Temperature setting
is not high enough for
the fabric
attempted.
Gradually increase
the temperature until
obtaining the desired
results.
Temperature has not
been selected
Ma e a proper
selection.
Press D ES N T get
warm.
Press is not plugged
into an outlet.
Plug the appliance
in.
10
USK STP 1 - 070502
Automatic Shut- ff
has engaged. The
pressing plate has
been raised for more
than 15 minutes
without use.
Press “ON/OFF”
again.
Water Level is too
low.
Fill the water tan . No Steam
Controls have not
been properly set.
If suitable for the
fabric, ma e a
selection to a higher
temperature. Wait for
the steam ready light
to come on. If not
use spray misting
bottle as directed.
Water drips from the
pressing plate.
Burst of steam button
has been pressed too
long.
Don t press the burst
of steam button
more than 5 seconds
continuously.
The handle will not
move into the
automatic maximum
pressure position.
Item on the ironing
board is too thic to
use this pressure.
Use lighter pressure
on thic er items. Use
added steam for
wrin les.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Idiomas:
Otros manuales de Hierro de Kalorik
Kalorik
Kalorik TKG SIS 1002 Manual de usuario
Kalorik
Kalorik USK DA 31067 Manual de usuario
Kalorik
Kalorik USK DA 1 Manual de usuario
Kalorik
Kalorik USK DA 31066 Manual de usuario
Kalorik
Kalorik TKG SI 1004 Manual de usuario
Kalorik
Kalorik SIS 40516 Manual de usuario
Kalorik
Kalorik USK STP 23783 Manual de usuario
Kalorik
Kalorik USK SIT 25803 Manual de usuario
Kalorik
Kalorik TKG DAT 1000 Manual de usuario
Kalorik
Kalorik USK DA 31750 Manual de usuario
