Kalorik USK FT 2 Manual de usuario
br
Deep fat fryer
Freidora
Friteuse
USK FT 2
120V~ 1500W
2
USK FT 2 071026
IMPORT NT S FEGU RDS
When using electrical appliances, basic safety precautions should
al ays be follo ed, including the follo ing:
Electrical
• Please RE D THESE INSTRUCTIONS carefully before using the
appliance.
• Please S VE THESE INSTRUCTIONS for your future reference.
• Check that the mains voltage corresponds to that stated on the
appliance.
• Never leave the appliance unsupervised hen in use. Keep out
of the reach of children.
• Never move the appliance by pulling the cord. Make sure the
cord cannot get caught in any ay. Do not ind the cord
around the appliance and do not bend it.
• Do not let the po er cord hang over the edge of a table or ork
surface.
• Do not let the po er cord come in contact ith the hot parts of
the appliance.
• Al ays attach the plug to the appliance first, then plug the cord
into the all outlet. To disconnect, turn any control to ‘OFF’ then
remove the plug from the all outlet.
• Never add ater to your oil.
• Only use the appliance for domestic purposes.
• Never use the appliance on or near hot surfaces, such as a gas or
electric hob or oven.
• Never use the appliance in a heated oven.
• Never use the appliance outside and al ays place it on a dry
level surface.
• Never use accessories, hich are not recommended by the
producer. They could constitute a danger to the user and risk
damaging the appliance.
• Do not touch hot parts or surfaces of the appliance. Use the
handle provided
3
USK FT 2 071026
• From time to time check the cord for damage. Never use the
appliance if cord or appliance sho any signs of damage or
malfunction. All repairs or adjustments to this unit must be carried
out by an authorized service center or a competent qualified
electrician.
• Only use the appliance for deep-frying in the manner described
in this instruction booklet. Only cook fryable and consumable
foodstuff.
• Ensure that your food is as dry as possible before frying.
• Never operate the appliance ithout oil in it. Ensure that the oil
level is al ays bet een the minimum and maximum marks inside
the bo l. Never overfill the bo l as hot oil might be ejected.
• Do not use outdoors.
• Extreme caution must be used hen moving fryer containing hot
oil.
• Be sure handles are properly assembled to basket and locked in
place. See Basket Assembly Instructions.
• The container is designed for use ith this appliance. It must
never be used on a range top.
• Do not set a hot container on a et or cold surface.
• Do not use a cracked container or a container having a loose or
eakened handle.
• Keep this appliance clean at all times as it comes into direct
contact ith food.
• Unplug from outlet hen not in use and before cleaning. Allo to
cool before putting on or taking off parts, and before cleaning
the appliance.
• The main housing, inner bo l, lid, basket and handle can be
ashed by hand or in the dish asher. Ensure that all the parts are
completely dry before reassembling.
• To protect against electric shock DO NOT immerse the control
panel, plug or po er cord in ater or any other liquid and never
place it in the dish asher.
• Wait until the appliance is completely cool before moving,
cleaning or storing it. Al ays take the appliance by the carrying
handles. Al ays unplug the appliance before handling it.
• Your fryer is supplied ith a grease filter lid. The filter does not
need replacing. The lid can be cleaned in hot soapy ater or in
4
USK FT 2 071026
a dish asher. Al ays ensure that the lid is completely dry before
replacing the lid onto the fryer.
• Take particular care of the glass bo l, do not drop it onto a hard
surface.
• Do not clean container ith cleansers, steel ool pads, or other
abrasive material
Fire prevention
• Make sure the hot parts of the appliance are not exposed to
inflammable materials, such as curtains, tablecloths, ... as a fire
might occur.
• Never cover the appliance ith any kind of material.
• REMARK: the deep fryer can reach high temperatures hen in
use. Oil and fat preparations might catch fire if overheated. Be
extremely careful never to leave your deep fryer in use for long
periods. Do not forget to s itch off the appliance once your
preparation is ready and the fryer is no longer in use. Before
pulling the mains plug, s itch the temperature selector to the
lo est position.
• Provide proper ventilation hen using the appliance.
S VE THESE INSTRUCTIONS!
5
USK FT 2 071026
POL RIZED PLUG INSTRUCTIONS
This appliance has a polarized plug (one blade is ider than the
other). To reduce the risk of electric shock, this plug ill fit into the
polarized outlet only one ay. If the plug does not properly fit into
the outlet at first, reverse it. If it still does not fit, contact a competent
qualified electrician. Do not attempt to modify the plug in any way.
SHORT CORD INSTRUCTIONS
A short po er supply cord is provided to reduce the hazards resulting
from becoming entangled in, or tripping over a longer cord. Do not
use the appliance ith an extension cord.
OTHER GUIDELINES BOUT THE
PPLI NCE
BEFORE USING THE FRYER FOR THE FIRST TIME
• Remove the lid, basket, handle and any accessory from the
appliance and packaging.
• Clean the lid, the interior bo l, the basket, the handle and the
main housing ith arm soapy ater and dry thoroughly.
DISM NTLING THE DEEP F T FRYER
• Remove the control panel from the appliance. To do this, gently
pull the control panel up ards until it clicks.
• Take the interior bo l ith your t o hands and pull it up.
Remove
the dustcover, basket and handle and any packaging form the
appliance.
6
USK FT 2 071026
SSEMBLING THE DEEP F T FRYER
• Place the main housing on a dry level surface.
• Replace the bo l until it rests on the three stops located on the
inside of the main housing. Ensure that the bo l is centered
correctly and level.
• Replace the control panel and the accessories. To replace the
control panel, firmly slide the control panel do n ard into the
location grooves on the back of the main housing. You ill hear a
“click” hen the control panel is correctly located. NOTE: The
appliance ill only operate hen the control panel is correctly
fitted.
• Place the bo l back in the outer jacket (ensuring the hook for the
basket is at the front) and then replace the control panel and
element. To replace the control panel, firmly slide the control
panel do n ard into the location grooves on the back of the
outer jacket. You ill hear a “click” hen the control panel is
correctly located. NOTE\: The appliance ill only operate hen
the control panel is correctly fitted to the outer jacket. Remove
the dustcover, basket and handle and any packaging form the
appliance.
B SKET SSEMBLY INSTRUCTIONS
• To assemble the basket handle ready for frying, lift the basket
handle and rotate in the direction of the arro sho n on the
basket hinge. When the handle is in the correct position, you ill
hear it “click” into place. Please see fig 1 belo .
• To unlock the basket handle (for storage etc), gently squeeze the
t o parallel bars together hilst at the same time gently lifting the
basket handle and rotate the basket handle in the opposite
direction of the arro sho n on the hinge. Please see fig 2 belo .
7
USK FT 2 071026
USING YOUR FRYER
• We advise that you use liquid oil, hich is recommended for
deep fat frying.
• Ensure the appliance is s itched off and that the bo l is
dry. Slo ly add the oil to the fryer until the required level is
reached (bet een the minimum and maximum marks).
• Set the temperature control knob to the temperature you
require. S itch on the appliance.
• When the oil is heating, the light on the front of the control
box ill be illuminated. When the oil reaches the desired
temperature, the light ill go out. The appliance is fitted
Fig 1
Lift the basket handle and rotate in
the direction of the arro sho n on
the basket hinge. When the handle
is in the correct position, you ill
hear it “click” into place.
Fig 2
To unlock the basket handle, gently
squeeze the t o parallel bars
together hilst at the same time
gently lifting the basket handle and
rotate the basket handle.
8
USK FT 2 071026
ith a thermostat to regulate the temperature. This ill
cycle on and off hilst in use to keep the temperature
constant. As a result of this, the light ill also cycle on and
off to indicate hen the appliance is heating the oil and
hen the desired oil temperature has been reached. For
best results, al ays ait until the appliance is at the correct
temperature before adding the food.
• Place the food to be fried carefully in the basket. Gently
lo er the basket into the oil. For “crisper” results, e
recommend using the fryer ithout the lid. WARNING: Be
careful of spitting hot oil. With the basket positioned on the
hook, place the food to be fried carefully in the basket. With
the handle attached to the basket, gently lo er the basket
into the oil. WARNING\: If using the deep fat fryer ithout
the dustcover, be careful of spitting hot oil.
• Al ays s itch off the appliance and unplug from the po er
supply after use or hilst unattended.
• This fryer is fitted ith overheat protection. Should you
accidentally s itch ON your deep fat fryer ithout oil or fat,
or ithout the minimum amount of oil/fat required, the
deep fat fryer ill automatically cut-out, to stop the
appliance overheating.
• If this should happen, firstly s itch-off and unplug the deep
fat fryer. Wait until the element cools do n. Locate the
reset hole on the bottom of the main housing directly under
the control panel, place your finger inside the hole area
and push up ard onto the small red button. This ill reset
the deep fat fryer. Your deep fat fryer is no ready to use.
To ensure this does not happen again, please read
instruction leaflet carefully.
• Should you ish to use solid fat, turn the temperature knob
to its lo est position. Cut the solid fat into cubes of size 15-
20mm. Ensure there is enough solid fat cubes to cover the
heating element. S itch on the deep fat fryer and rotate
the temperature dial until the light comes on. After the light
goes off, rotate the dial again until it comes on. Repeat this
9
USK FT 2 071026
until all the oil is melted. After all the oil is melted, the
temperature dial can be set to the desired cooking
temperature. Be careful, never to add too much solid fat
and al ays ensure that the level is bet een the min and
max marks. Note – if you do not add enough solid fat, the
reset button may operate as detailed in the above section.
CLE NING
General
• Unplug the deep fat fryer and ait until the unit is
completely cool before cleaning. Sho care hen
touching the heating element. This may still be hot after
some time.
• Follo the section ‘Dismantling the deep fat fryer'.
• Never use bleaching agents to clean any part of the fryer
(or other strong alkali solutions).
• THOROUGHLY dry all parts after cleaning.
• Change the oil regularly. Pour out the old oil. Please
consider the environment hen disposing of the oil.
• After cleaning, follo the section ‘Assembling the deep fat
fryer’.
Care of the Control box & Heating Element
• DO NOT IMMERSE THE CONTROL BOX IN ANY LIQUID.
• Do not use strong detergents or abrasive cloths/liquid, as
this ill damage the surface of the control box and heating
element
• Clean the surface of the control box by iping it ith a soft
damp cloth. Then, thoroughly dry the surface ith a clean
dry cloth
• Once completely cool, ipe any excess oil from the
heating element ith a tissue.
10
USK FT 2 071026
Care of the Glass Bowl
• Do not use strong detergents or abrasive cloths/liquid, as
this ill damage the bo l.
• Clean the bo l ith arm soapy ater. The bo l is suitable
for cleaning in the dish asher. If there is still some residue
then it may help to soak the parts for a short time.
Care of the main housing, Lid & Basket
• Do not use bleaching agent to clean these parts, as this ill
damage the unit.
Hand ashing – This is our recommended method of
cleaning these parts.
• Clean these parts in arm soapy ater.
• If there is still some residue then it may help to soak the
parts for a short time.
Dishwashing
• NOTE – Prolonged dish ashing may dull the finish of the
unit. To minimize this, e recommend that the main housing
is dish ashed by itself and at the lo est temperature
setting.
• THOROUGHLY dry all parts after cleaning.
• Leave the lid to drain properly before replacing the lid onto
the bo l.
STORING
• Wait until the deep fat fryer is completely cool before
storing.
• The unit can be stored ith the oil inside. Ensure that the lid
is positioned correctly to avoid dust getting into the oil.
Check that there is no ater in your oil before reusing the
oil.
Otros manuales para USK FT 2
1
Tabla de contenidos
Idiomas:
Otros manuales de Freidora de Kalorik
Kalorik
Kalorik MAXX AFO 52484 SS Manual de usuario
Kalorik
Kalorik USK FT 2 Manual de usuario
Kalorik
Kalorik USK FT 23816 Manual de usuario
Kalorik
Kalorik SMART FRYER PRO Manual de usuario
Kalorik
Kalorik MAXX AFO 47631 SS Manual de usuario
Kalorik
Kalorik MAXX PLUS FT 47822 SS MAXX PLUS FT 47824 SS MAXX PLUS FT 50876... Manual de usuario
Kalorik
Kalorik USK FT 4 Manual de usuario
Kalorik
Kalorik FT 44466 Manual de usuario
Kalorik
Kalorik FT 46587 Manual de usuario
Kalorik
Kalorik MAXX Plus FT 50928 OW Manual de usuario
Kalorik
Kalorik MAXX Plus Manual de usuario
Kalorik
Kalorik MAXX AFO 46045 SS Manual de usuario
Kalorik
Kalorik TKG FTL 1500 B Manual de usuario
Kalorik
Kalorik FT 42139 Manual de usuario
Kalorik
Kalorik FT 47456 Manual de usuario
Kalorik
Kalorik MAXX KIA 47735 Guía de referencia rápida
Kalorik
Kalorik PRO Manual de usuario
Kalorik
Kalorik MAXX AFO 46045 SS Manual de usuario
Kalorik
Kalorik FT 46689 BK Manual de usuario
Kalorik
Kalorik MAXX AFO 52096 BK Manual de usuario
