Jura D6 Manual de usuario

D6 – Quick Reference Guide

These short instructions do not replace the ‘D6 Instructions for Use’.

Make sure you read and observe the safety information and war-

nings first in order to avoid hazards.

Ten minutes after milk preparation, the D6 prompts you to perform

milk system rinsing.

Precondition: M-RINSE / CAPPUCC. is displayed (example).

TPlace a receptacle under the fine foam frother.

TTouch the Maintenance symbol cfor approximately

2 seconds until OPEN SWITCH appears.

TTurn the switch to the mposition.

The fine foam frother is rinsed.

CLOSE SWITCH

TTurn the switch to the °position.

CAPPUCC. (example)

To ensure that the fine foam frother always works properly, you

must clean it daily when you have been preparing milk

If the wrong cleaning agent is used, the machine could be damaged

and/or traces could be left behind in the water.

TUse only original JURA maintenance products.

EJURA milk system cleaner is available from specialised dealers.

Precondition: CAPPUCC. is displayed (example).

TTouch the P symbol for approximately 2 seconds until

RINSE appears on the display.

TPress the Rotary Switch to enter the programme item.

M-RINSE

TTurn the Rotary Switch until M-CLEAN is displayed.

TPress the Rotary Switch.

CLEANER / WATER

TRemove the milk pipe from the milk container or milk cooler.

Rinsing the fine foam

frother

Cleaning the fine foam

frother

CAUTION

D6 – Quick Reference Guide

TPour 250 ml of fresh water into a receptacle and add 1 capful

of milk system cleaner.

TImmerse the milk pipe in the receptacle.

TPlace a receptacle under the fine foam frother.

TPress the Rotary Switch.

M-CLEAN, OPEN SWITCH, the light segment on the

switch lights up.

TTurn the switch to the mposition.

The fine foam frother and the milk pipe are cleaned.

CLOSE SWITCH

TTurn the switch to the °position.

WATER

TRinse the receptacle thoroughly, fill it with 250 ml of fresh

water and immerse the milk pipe in the water.

TEmpty the other receptacle and place it under the fine foam

frother once more.

TPress the Rotary Switch.

OPEN SWITCH

TTurn the switch to the mposition.

The fine foam frother and the milk pipe are rinsed with fresh

water.

CLOSE SWITCH

TTurn the switch to the °position.

CAPPUCC. (example)

To make sure the fine foam frother works properly, and in the inte-

rests of hygiene, it must be dismantled and rinsed daily if you have

been preparing milk. Your D6 will not prompt you to dismantle and

rinse the frother.

TRemove the milk pipe and rinse it thoroughly under running

water.

TCarefully remove the fine foam frother from the Connector

System©by twisting slightly.

Dismantling and rinsing

the fine foam frother

D6 – Quick Reference Guide

TDismantle the fine foam frother into its individual parts.

TRinse all the parts under running water. If there are severely

dried-on milk residues, firstly immerse the individual parts

in a solution of 250 ml cold water and 1 capful of JURA milk

system cleaner. Then rinse the parts thoroughly.

TRe-assemble the fine foam frother.

EEnsure that all individual parts are correctly and firmly con-

nected to ensure optimum operation.

TFirmly attach the fine foam frother to the Connector Sys-

tem©.

Your D6 no longer has to be descaled if you are using the CLARIS

Smart filter cartridge.

EOnce the filter cartridge stops working (depending on the

water hardness setting), the D6 will prompt you to change the

filter.

ECLARIS Smart filter cartridges are available from specialised

dealers.

Precondition: FILTER / CAPPUCC. is displayed (example).

TOpen the water tank cover.

TRemove and empty the water tank.

TOpen the filter holder and remove the old CLARIS Smart

filter cartridge.

TInsert a new CLARIS filter cartridge Smart into the water

tank, exerting slight pressure.

TClose the filter holder. It will click into place audibly.

TFill the water tank with fresh, cold water and reinsert the

tank.

The machine has automatically detected that you have just

inserted/changed the filter cartridge.

OPEN SWITCH, the light segment on the switch lights

up.

TPlace a receptacle under the fine foam frother.

Inserting/changing the

filter

D6 – Quick Reference Guide

TTurn the switch to the mposition.

FILTER RINSING, water flows out of the fine foam fro-

ther.

Rinsing of the filter stops automatically.

CLOSE SWITCH

TTurn the switch to the °position.

CAPPUCC. (example)

After 180 preparations or 80 switch-on rinses, the D6 will prompt

you to clean it.

If the wrong cleaning agent is used, the machine could be damaged

and/or traces could be left behind in the water.

TUse only original JURA maintenance products.

EThe cleaning programme lasts approximately 20 minutes.

EDo not interrupt the cleaning programme. The quality of

cleaning will be impaired if you do so.

EJURA cleaning tablets are available from specialised dealers.

Precondition: CLEAN / CAPPUCC. is displayed (example).

TTouch the Maintenance symbol cfor approximately

2 seconds.

EMPTY TRAY appears on the display.

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

PRESS RINSE

TPlace a receptacle under the coffee spout.

TTouch the Maintenance symbol c.

CLEANING, water flows out of the coffee spout.

The operation is interrupted, ADD TABLET.

TOpen the cover of the filler funnel for the cleaning tablet.

Cleaning the machine

CAUTION

D6 – Quick Reference Guide

TInsert a JURA cleaning tablet into the filler funnel.

TClose the cover of the filler funnel.

TTouch the Maintenance symbol c.

CLEANING, water flows out of the coffee spout several

times.

The operation stops automatically.

EMPTY TRAY

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

CAPPUCC. (example)

The D6 builds up deposits of limescale over time and automatically

prompts you to descale it when necessary. The degree of calcifica-

tion depends on the hardness of your water.

If the descaling agent comes into contact with the skin or eyes, this

can cause irritation.

TAvoid contact with the skin or eyes.

TRinse off the descaling agent with clean water. Should you get

any descaling agent in your eye, see a doctor.

If the wrong descaling agent is used, the machine could be dama-

ged and/or traces could be left behind in the water.

TUse only original JURA maintenance products.

If the descaling operation is interrupted, there may be damage to

the machine.

TAllow the descaling programme to run to the end.

If the descaling agent comes into contact with sensitive surfaces

(e.g. marble), damage cannot be ruled out.

TClean up any splashes immediately.

EThe descaling programme lasts approximately 45 minutes.

EJURA descaling tablets are available from specialised dealers.

Precondition: DESCALE / CAPPUCC. is displayed (example).

TTouch the Maintenance symbol cfor approximately

2 seconds.

EMPTY TRAY appears on the display.

Descaling the machine

JCAUTION

CAUTION

D6 – Quick Reference Guide

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

AGENT IN TANK

TRemove and empty the water tank.

TCompletely dissolve 3 JURA descaling tablets in a receptacle

holding 500 ml of water. This may take several minutes.

TPour the solution into the empty water tank and insert it

into the machine.

OPEN SWITCH, the light segment on the switch lights

up.

TPlace a receptacle under the fine foam frother.

TTurn the switch to the mposition.

DESCALE appears and water flows out of the fine foam

frother repeatedly. The Maintenance symbol cflashes

during the descaling operation.

The operation is interrupted, CLOSE SWITCH.

TTurn the switch to the °position.

DESCALE. The descaling operation is continued.

The operation is interrupted, EMPTY TRAY.

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

FILL TANK

TEmpty the receptacle and place it under the coffee spout

and fine foam frother.

TRemove the water tank and rinse it thoroughly.

TFill the water tank with fresh, cold water and reinsert the

tank.

OPEN SWITCH, the light segment on the switch lights

up.

TTurn the switch to the mposition.

DESCALE

The operation is interrupted, CLOSE SWITCH.

TTurn the switch to the °position.

DESCALE

The operation is interrupted, DESCALE.

Water flows out of the coffee spout.

EMPTY TRAY

D6 – Quick Reference Guide

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

CAPPUCC. (example)

EIf the descaling operation stops unexpectedly, rinse the water

tank thoroughly.

Coffee beans may be covered with a slight oil film which remains on

the walls of the bean container. These traces may negatively affect

the coffee result. For this reason clean the bean container from time

to time.

Precondition: FILL BEANS is displayed.

TPress the On/Off button Qto switch the D6 off.

TOpen the bean container cover and remove the aroma pre-

servation cover.

TClean the bean container with a soft, dry cloth.

TFill the bean container with coffee beans and close the

aroma preservation cover.

TClose the bean container cover.

Limescale deposits may form in the water tank. To ensure correct

function of the machine, descale the water tank from time to time.

TRemove the water tank.

TIf you use a CLARIS Smart filter cartridge, remove this.

TCompletely fill the water tank and dissolve 3 JURA descaling

tablets in it.

TLeave the water tank with the descaling solution for several

hours (e.g. overnight).

TEmpty the water tank and rinse it thoroughly.

TIf you use a CLARIS Smart filter cartridge, insert this again.

TFill the water tank with fresh, cold water and reinsert the

tank.

Cleaning the bean

container

Descaling the water tank

D6_Kurz/en/201804

Otros manuales para D6

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cafetera de Jura

Jura

Jura Z10 Manual de usuario

Jura

Jura IMPRESSA J9.2 One Touch Manual de usuario

Jura

Jura ENA Micro 1 Manual de usuario

Jura

Jura E8 Manual de usuario

Jura

Jura X7 Manual de usuario

Jura

Jura E6 Manual de usuario

Jura

Jura IMPRESSA F8 Manual de usuario

Jura

Jura IMPRESSA X9 Guía de configuración

Jura

Jura GIGA X8 Professional Manual de usuario

Jura

Jura IMPRESSA J9.4 One Touch TFT Manual de usuario

Jura

Jura ENA 9 One Touch Manual de usuario

Jura

Jura IMPRESSA X9 Guía de configuración

Jura

Jura Impressa F9 guide Manual de usuario

Jura

Jura Professional fine foam frother Manual de usuario

Jura

Jura SUBITO Manual de usuario

Jura

Jura IMPRESSA X7-S Manual de usuario

Jura

Jura ENA 3 Manual del operador

Jura

Jura WE6 Professional Manual de usuario

Jura

Jura ENA Micro 5 Manual de usuario

Jura

Jura IMPRESSA Z5 Manual de usuario

Jura

Jura 740 Manual de usuario

Jura

Jura IMPRESSA C5 Manual de usuario

Jura

Jura IMPRESSA X7-S Manual de usuario

Jura

Jura GIGA X3C Guía

Manuales populares de Cafetera de otras marcas

Taurus

Taurus Livorno 6 Manual de usuario

Delta-q

Delta-q QUICK Manual de usuario

Bunn

Bunn LCA-1 Guía de solución de problemas

Black & Decker

Black & Decker BLACK DECKER HOME DE790 Instrucciones de instalación

Saeco

Saeco Vienna Plus Sup 018M Manual de usuario

DeLonghi

DeLonghi DC300 Manual de usuario

INCAPTO

INCAPTO BXCO1470E Manual de usuario

Bosch

Bosch TASSIMO finesse TAS16B Series Manual de usuario

Exido

Exido 245-072 Manual de usuario

Animo

Animo OptiVend Choco Manual de usuario

Siemens

Siemens TQ505DF Series Manual de usuario

DeLonghi

DeLonghi ECI341 Manual de usuario

Krups

Krups KT406511 Manual de usuario

Cimbali

Cimbali M32 Classic Manual de usuario

Philips

Philips HL3844N Manual de usuario

Bosch

Bosch TES 515 SERIES Manual de usuario

Tekmatix

Tekmatix TMFM - 65 Manual de usuario

Scarlett

Scarlett SC-CM33005 Manual de usuario