
JDSLABS.COM 6JDSLABS.COM 7
Troubleshooting
Amplier does not turn on
Cause: Missing or loose power adapter connection.
Solution: Firmly connect AC adapter to 16VAC power jack.
Internal LED ashes, then turns o
Cause: Wrong power adapter detected.
Solution: Please see Power Adapters section below.
No sound in one channel
Cause: Bad cable, or incorrect computer settings.
Solution: Check balance settings; try another headphone or RCA cable. Some Mac OS X systems
will pan audio to the Left channel upon initial connection of a DAC. User must restore balance
to center.
Power Adapters
ATTENTION: Incorrect power adapters can result in capacitor
explosion hazards and device damage. Only use the power adapter
included with your Element:
Type: AC-to-AC Transformer Output Voltage: 16 VAC
Current: Minimum 1000mA Connector: 2.1x55.mm (ID x OD)
No sound from headphones
Cause: Wrong mode, or incorrect connectivity, or incorrect setup
Solution: Please see Connectivity page to toggle between Headphone or RCA Output. Check
cabling.
Application for Council Directives 2004/108/EC, 2006/95/EC, 2002/95/
EC.Conformity declared for EN55022:2011, EN611000-3-2, EN61000-3-
3, EN55024-2
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.