JASON Hydrotherapy SP200 Manual de usuario

Page 1 of 15

INSTALLATION INSTRUCTIONS

SP200 SHOWER PANEL

49-2040-004

Date 05/07

JASON INTERNATIONAL, INC.

8328 MacArthur Drive • North Little Rock, AR 72118 • www.jasoninternational.com

501-771-4477 • Fax: 501-771-2333 • Cust. Svc.: 800-255-5766

Page 2 of 15

Figure 1 - Dimensions

Page 3 of 15

Operating Pressure: max. 145 psi

Recommended pressure: 30.60 psi

Test pressure: 232 psi

Max. hot water temperature: 176°F *

Recommended hot water temperature: 120°F - 140°F *

Flow rate @ 45 psi

Handshower 2.5 gpm

Bodysprays <1 gpm each

Protection against back siphonage is provided by check

valves in the hot and cold supply elbows.

This panel incorporates a thermostatic mixing valve. The

high temperature limit stop on the mixing valve can be reset

to comply with local plumbing codes. See page 10.

* Know and follow all applicable local plumbing codes when setting the

temperature on the water heater.

Figure 2

Technical Data

Page 4 of 15

Preparation for Installation

1. Install 1/2” IPS nipples for the hot and cold water sup-

plies at the locations shown on the diagram. The nipples

should extend 5/8” outside the surface of the nish wall.

2. For proper operation of the unit, the hot supply should be

on the left, and the cold supply should be on the right.

3. Install the wall surface material. Make sure that the wall

is watertight before installing the panel.

4. Seal the wall around the nipples with waterproof seal-

ant.

Figure 3

Page 5 of 15

Installation Instructions

1. Wrap the nipples with several layers of Teon tape.

2.Install the elbows included with the panel. The outlets

should point downwards. The elbow should extend no

more than 1 1/4” from the surface of the nished wall.

See Figure 4 and Figure 5.

3.With a helper holding the panel in place, mark the posi-

tions of the screw holes. See Figure 6.

4.Set the panel aside, securely supported to prevent dam-

age.

Figure 5

Figure 4

Figure 6

5. Drill the screw holes with a 6 mm bit suitable for the wall

surface. (See Figure 7.)

6. Install the anchors. (See Figure 7.)

7. Seal the wall around the anchors with waterproof seal-

ant. (See Figure 7.)

Figure 7

Page 6 of 15

INSTALLATION INSTRUCTIONS (cont.)

8. Hold the panel against the wall.

9. Install the gray plastic insert. (See Figure 8.)

10. Insert the top screw through the front of the panel, the

washer and the insert. Screw it into the anchor. (See

Figure 8.)

11. Install the center and bottom screws and washers. (See

Figure 9.)

12. Connect the supply hoses to the hot and cold supply

elbows. (See Figure 10.)

13. Connect the supply hoses to the hot and cold inlet ports

on the valve. (See Figure 11 and Figure 12.)

Figure 8

Figure 9

Figure 10

Figure 11

Figure 12

Page 7 of 15

14. Turn the water on at the main. Push the diverter stem up

to turn the water on to the panel. (See Figure 13.)

15. Check all connections for leaks.

Figure 13

INSTALLATION INSTRUCTIONS (cont.)

16. Once you ensure that the connections are watertight,

push the diverter stem down to turn the water off to the

panel. (See Figure 14.)

17. Install the side seals on the front cover. (See Figure 15.)

Trim off any excess.

19. Install the diverter sleeve. (See Figure 17.)

Figure 14

Figure 15

Figure 16

Figure 17

18. Push the front cover into place. (See Figure 16.)

Page 8 of 15

20. Make sure that the indexing mark on the thermostatic

mixer sleeve is at the 12:00 position. (See Figure 18.)

21. Install the thermostatic mixer handle.(See Figure 18.)

22.Tighten the handle screw with a at-bladed screwdriver.

23. Install the diverter handle. Tighten the set screw with a

4 mm Allen wrench. (See Figure 19.)

24. Place a black rubber washer in one end of the hand-

shower hose. Screw this end of the hose to the hand-

shower outlet port. (See Figure 20.)

25. Place the screen washer in the other end of the hose.

(See Figure 20.)

26. Screw this end of the hose to the handshower. (See

Figure 20.)

27. Place the handshower in the holder.

Figure 18

Figure 19

Figure 20

INSTALLATION INSTRUCTIONS (cont.)

Page 9 of 15

You can make the slider easier or harder to move. Use a 2.5

mm Allen wrench to turn the set screw clockwise to increase

the tension, counter-clockwise to decrease the tension.

Figure 21

1. Turn the water on to the handshower.

2. Turn the thermostatic mixer handle until the output water

measures 100oon a thermometer. (See Figure 22.)

3. Turning the handle clockwise makes the water

cooler;turning the handle counter-clockwise makes the

water warmer.

4. Turn the water off.

5. Loosen the thermostatic mixer handle screw. Remove

the handle. (See Figure 23.)

6. Replace the handle so that the safety stop override but-

ton is at the 12:00 position. (See Figure 24.)

7. Tighten the set screw.

Figure 22

Figure 23

Figure 24

Adjust the Slider

Justify the Thermostatic Mixer Handle

Page 10 of 15

3. Turn the water on to the handshower.

4. Turn the temperature control stem until the output wa-

ter is the desired maximum high temperature -- usually

110o*. (See Figure 26.)

*Please know and follow all applicable local plumbing

codes when setting the high temperature limit stop.

5. Turn the water off.

6. Replace the stop ring so that the tooth is against the high

temperature limit stop. (See Figure 27.)

7. Replace the clip. (See Figure 27.)

8. Justify the handle. (See Figure 27.)

Figure 26

Figure 27

1. Remove the thermostatic mixer handle.

2. Remove the clip and the stop ring from the stem of the

thermostatic mixer. (See Figure 25.)

Figure 25

Set the High Temperature Limit Stop (Optional)

Tabla de contenidos

Otros manuales de Accesorio de baño de JASON Hydrotherapy

JASON Hydrotherapy

JASON Hydrotherapy MicroSilk Manual de usuario

JASON Hydrotherapy

JASON Hydrotherapy Forma MicroSilk-AirMasseur Manual de usuario

JASON Hydrotherapy

JASON Hydrotherapy forma Designer MicroSilk AirMasseur Manual de usuario

JASON Hydrotherapy

JASON Hydrotherapy MicroSilk Manual de usuario

JASON Hydrotherapy

JASON Hydrotherapy forma Manual de usuario

Manuales populares de Accesorio de baño de otras marcas

DURAVIT

DURAVIT C.1 C15240 0090 Manual

Heatstore

Heatstore HSTRL500WTN Manual de usuario

Sunshower

Sunshower PURE SOLO Manual de usuario

Delabie

Delabie Delabie Sporting 714700 Manual de usuario

Kohler

Kohler K-13056 Instrucciones de montaje

ESS

ESS Container TCL-11 Manual de usuario

Mustee

Mustee 22C Manual de usuario

VITRA

VITRA V-Flow Manual de usuario

baliv

baliv DUK-80.30 T Manual de usuario

Malmet

Malmet B105BT Manual de usuario

bathstore

bathstore Transition H1690MM Guía

BELLOSTA

BELLOSTA Edward 0800/M Manual de usuario

baliv

baliv DU-5160 Manual de usuario

Franke

Franke PRTR0006 Manual de usuario

Gessi

Gessi RILIEVO 59011 Manual de usuario

noken

noken VITAE 100188525-N299998810 Manual de usuario

Allen + Roth

Allen + Roth 1142VA-30-201 Manual de usuario

Britex

Britex HBDA Manual de usuario