inventiv NATAIVA Manual de usuario
1
NATAIVA
0724901417094
0724901417100
0724901417117
Installation instructions
Use and maintenance advices
Dear Client,
Thank you for purchasing this product .
In order for it to bring you complete satisfaction during its use and to
optimize its lifespan, we thank you for reading this manual before any
installation, handling or maintenance.
We remind you that compliance with these instructions is an essential
condition for any warranty coverage.
Find all our warranty conditions on : www.info-inventiv.com
Take advantage of all our advices and our products on:www.mr-
bricolage.fr
Also meet #mr.bricolage on our networks:
2
INSTALLATION TIME / NUMBER OF
PEOPLE / RECOMMENDED TOOLS
WARNING SYMBOLS
SAFETY INSTRUCTIONS
PLEASE READ SAFETY INSTRUCTIONS
CAREFULLY BEFORE USING THE UNIT.
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use
10’~15’ 1 or 2
Please read the instructions carefully
Class II equipment
3
of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
• Children of less than 3 years should be kept
away unless continuously supervised.
• Children aged from 3 years and less than 8
years shall only switch on/off the appliance
if it has been placed or installed in its
intended normal operating position and
they have been given supervision or
instruction concerning use of the appliance
in a safe way and understand the hazards
involved.
• Children aged from 3 years and less than 8
years shall not plug in, regulate and clean
the appliance or perform user maintenance.
• CAUTION — Some parts of this product
can become very hot and cause burns.
Particular attention has to be given where
children and vulnerable people are present.
• If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
• The appliance should not be placed
immediately below a socket.
4
• WARNINGS: In order to avoid
overheating, do not cover the heater.
• Do not use this heater with a programmer,
timer, separate remote-control system or
any other device that turns on the heater
automatically because there is a risk of fire
if the device is covered or placed
incorrectly.
• CAUTION: To avoid hazard due to
inadvertent resetting of the thermal
cutout, this appliance must not be
powered via an external switch, such as a
timer, or connected to a circuit that is
regularly switched on and off by the
electricity supplier.
• This heater must not be disposed of with
household waste; it must be taken to a
local center of recovery and recycling of
electrical appliances.
• The heater must be installed so that
switches and other control devices cannot
be touched by a person in the bath or
shower.
• A means of disconnection from the power
supply having a contact opening distance
of all poles must be included in the fixed
wiring in accordance with the installation
requirements.
5
• WARNING: If this device is installed in a
bathroom, it must be installed at least 60
cm from a bath or shower, in accordance
with the requirements of the French
electrical standards NFC15-100.
• The device must be powered through a
Residual Current Device (RCD) having a
rated differential operating current not
exceeding 30 mA.
• If being fitted in a bathroom, a 30mA RCD
must be used.
• With respect to the details of how to install
the appliance onto the wall, refer to part
"INSTALLATION".
• Regarding the detailed information on the
connection of the electric cable, refer to
the section "ELECTRICAL CONNECTION".
INSTALLATION
IMPORTANT RECOMMENDATIONS TO
READ BEFORE INSTALLATION
- Do not install the unit directly below a
socket.
- Do not install the unit in a damp room or
near a water source.
- Do not use the appliance outdoors.
- Do not install the unit in an air current
that could disrupt its regulation.
6
- Do not place the unit near a barrier
limiting the airflow around it.
- Attach the heater vertically to the wall
as described below.
- Choose screws and plugs suitable for
the wall material and weight of the unit.
To hang the heater on the wall:
1. Choose a suitable installation location for
the heater. (Fig 1)
2. Disassemble the wall bracket by loosening
the screw (do not remove, only loosen) and
7
slide the metal plate out of the hole. Take
out the bracket by pulling down. (Fig 2)
3. Verify that the bracket is horizontal with a
spirit level and mark the location of 4 holes
on the wall. Drill 4 holes in the wall using a
drill adapted to the diameter of wall plug.
Insert the wall plug into the holes, then
screw securely wall mount bracket onto the
wall. (Fig 3)
4. Place the heater against bracket (Fig 4):
A : Align the heater on the 2 lower hooks that
are downwards.
B : Pull the heater upwards whilst retaining it
in the 2 lower hooks.
C : Align the heater on the 2 upper hooks
that are upwards.
D : Pull the heater down.
5. Slide the metal plate into the hole, and
fasten the
screw to lock the wall mount bracket. (Fig 5)
INSTALLATION IN THE BATHROOM
Warning: This appliance must be only
installed in the volume 2 or out of volume of
the bathroom, as stated in the French
standard NF C 15-100 for electrical
installation inside the house.
8
Note: The drawing is for reference only.
We suggest that you to contact a
professional electrician for assistance.
ELECTRICAL CONNECTION
CAUTION: Before any intervention, turn off
the electricity at the main circuit breaker.
- The installation must be carried out
according to the requirements and meet the
standards enforced in the country (NF C 15-
100 in France).
- The unit must be connected to a standard
wall box placed at least 25 cm from the floor.
- The appliance must not be connected to an
outlet with a power plug.
9
- The appliance must be supplied through a
residual current device (RCD) having a rated
residual operating current not exceeding 30
mA.
- The appliance must not be connected to the
earth wire (yellow and green wire).
ELECTRICAL CONNECTION
Blue or light gray wire connect to Neutral
(230V)
Brown or red wire connect to Phase (230V)
Black wire connect to pilot wire. (Optional
function to use in case of control by pilot
wire box)
WARNING! Do not connect the black wire to
the earth connection.
- In the absence of pilot wire, insulate the
bare end of the black wire to prevent
electrical contact with the other wires or
earth.
10
LCD DISPLAY
Symbol
Function
Stand-by mode (the appliance will not work but will receive
power)
Anti-freeze mode (the appliance maintains a temperature of
around 7°C)
,
Comfort mode (desired set temperature)
Eco mode (ECO maintains a temperature 3.5ºC lower than
the selected Comfort temperature. This mode reduces the
temperature without changing the selected Comfort
Temperature)
Pilot wire mode (to set the programs via pilot wire
programmer)
Window detector function
Child lock
Heating indicator (When appliance is heating up, this icon will
be displayed at the screen. The icon will disappear when the
room temperature reaches the selected temperature)
Temperature (centigrade)
Weekly personalized modes:
Comfort mode enabled
Eco mode enabled
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Manuales populares de Calentador de otras marcas
Empire Heating Systems
Empire Heating Systems WCC65 Manual de usuario
Wetekom
Wetekom 92 86 43 Manual de usuario
Desa
Desa SPC170-F Manual de usuario
Watlow
Watlow Watrod Electric Tubular Heaters Manual de usuario
Haverland
Haverland ECO-DRY GPS Series Manual de lista de piezas
Stelpro
Stelpro ASILVC2060 Series Manual de usuario