Intermec ScanImage 1470 Manual de usuario

S C A N I M A G E

User's Manual

Edition 3

from United Barcode Industries

Februry 1994

This page intentionally left blank

Notice

Patent Information

Scanners discussed in this manual are covered by patents

issued or pending in the U.S. and other countries.

The information contained in this manual are for information

purposes only and are subjected to change without notice. The

content of this manual are copyrighted. In addition, all software

code in the ScanImage itself is copyrighted. No part of either

this manual, or the ScanImage's software, may be copied or

reproduced in any manner, or disseminated to any unauthorized

person, without the prior written permission of United Barcode

Industries.

ScanImage is a trademark of

United Barcode Industries

Notice

The ScanImage is certified to be a CDRH Class II laser (class 3A

for 97x and 99x models) product with the United States

Department of Health and Human Services Center for Devices

and Radiological Health, and IEC Class II.

FCC Compliance Information

Warning: This equipment generates, uses, and can radiate

radio frequency energy. If not installed and used in accordance

with the instruction manual, it may cause interference to radio

communications. It has been tested and found to comply with

the limits for a Class A computing device pursuant to Subpart J

of Part 15 of FCC Rules, which are designed to provide

reasonable protection against such interferences when operated

in a commercial environment. Operation of the equipment in a

residential area is likely to cause interferences in which case the

user at his own expense will be required to take whatever

measure may be required to correct the interference.

Using this manual

This User's Manual explains in detail how to set up and operate

the ScanImage. Section 1 provides an overview of the

ScanImage versions available. Section 2, 3 and 4 cover,

respectively, programming for the following versions.

9X1 - Wand emulation

9X2 - RS-232 interface

9X7 - Wedge connection

This User's Manual will help you:

Install the ScanImage on your terminal.

Configure the ScanImage to your system and data

communications requirements via bar code menus.

Select the bar code formats to be activated.

Configure the ScanImage to incorporate preambles and/or

postambles.

Make use of ScanImage's advanced features such as, laser

management, character masking, bar code verification, and bar

code identifiers.

Table of contents

Notice .........................................................................................i

Using this manual..................................................................iii

Table of contents....................................................................iv

PART I - INSTALLATION

Section 1 - Description of the ScanImage and Special

Features

ScanImage Versions.................................................................1-1

Preparing the ScanImage for configuration............................1-2

Special Features.......................................................................1-3

Section 2 - Installing the ScanImage as a Wand

emulation

Wand emulation.......................................................................2-1

-Wand emulation Enable..................................................2-1

-Transmission...................................................................2-2

-Signal State .....................................................................2-2

-Speed ...............................................................................2-2

-Delay................................................................................2-3

Table of contents

Section 3 - Installing the ScanImage as an RS-232 output

device

Single RS-232 mode.................................................................3-1

-Single RS-232 Mode (P/N 9X2)........................................3-1

-ScanImage 9X2 With Single RS-232 Output ..................3-2

-Pin Assignments for Single Output

Cable Management Module.............................................3-4

Dual RS-232 mode ...................................................................3-5

-Dual RS-232 Mode...........................................................3-5

-ScanImage 9X2 With DUAL RS-232 Ouput Option .......3-6

-Standard Dual RS-232 Option

(P/N 901196 or 700352) ...................................................3-8

RS-232 interface parameters...................................................3-9

-RS-232 Enable.................................................................3-9

-Baud Rate......................................................................3-10

-Data/Stop/Parity............................................................3-11

-End of message Control Codes......................................3-12

-Protocols for Contolling Data Transmission .................3-13

Section 4 - Installing the ScanImage as a Keyboard

Wedge

Keyboard Wedge mode.............................................................4-1

-Keyboard Wedge Mode (P/N 9X7)...................................4-1

-ScanImage 9X7 Wedge Connection with

Cable Management Module.............................................4-2

-Compose Terminal Type..................................................4-4

-End of message Control Codes........................................4-5

-Upper Lower Case Options .............................................4-6

-Alt Mode ..........................................................................4-6

Table of contents

PART II - READING PARAMETERS

Family A - Audio and data management

Audio Managment ..................................................................A-1

-Speeker Volume..............................................................A-1

-Speeker Tones ................................................................A-2

Data Management ..................................................................A-3

-Preambles and Postambles.............................................A-3

-Intercharacter Delay......................................................A-4

-Rolling Buffer.................................................................A-5

-Intermessage Delay........................................................A-6

Family B - Activation/Deactivation of Bar Code

Formats

Bar Code Formats...................................................................B-1

Family C - Code 39 Parameters

Code 39 Parameters................................................................C-1

Family D - Interleaved 2 of 5 Parameters

Interleaved 2 of 5 Parameters................................................D-1

Family E - 2 of 5 Standard Parameters

2 of 5 Standard Parameters....................................................E-1

Family F - Codabar Parameters

Codabar Parameters............................................................... F-1

Table of contents

Family G - UPC/EAN Parameters

UPC/EAN Parameters............................................................G-1

Family H - Code 128, PLESSEY, MSI, Code 93, Code 11,

TELEPEN, MATRIX 2/5, EAN 128 Parameters

Code 128, PLESSEY ...............................................................H-1

MSI, Code 93...........................................................................H-2

Code 11, TELEPEN, MATRIX 2/5..........................................H-3

EAN 128..................................................................................H-4

Family I - Advanced features

Laser management .................................................................. I-1

Laser Time-out Variable.......................................................... I-2

Consecutive same read code validation................................... I-3

No read message...................................................................... I-4

Character masking and reordering......................................... I-5

Single code type identifier ....................................................... I-9

Identification AIM ................................................................. I-11

Delay character...................................................................... I-12

Character substitution/deletion............................................. I-13

Configuration password......................................................... I-13

Table of contents

Appendix - Full ASCII Bar Code Chart and Command

Full ASCII Bar Code Chart ....................................................X-1

Command Menu......................................................................X-9

Otros manuales para ScanImage 1470

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Escáner de Intermec

Intermec

Intermec MicroBar 9710 Manual de usuario

Intermec

Intermec IF61 Manual

Intermec

Intermec SF51 Manual de usuario

Intermec

Intermec MaxiScan 2400 Manual de usuario

Intermec

Intermec Sabre 1551C Manual de usuario

Intermec

Intermec MaxiScan 3010 Manual de usuario

Intermec

Intermec Sabre 1514 Manual de usuario

Intermec

Intermec Sabre 1545 Manual

Intermec

Intermec IF30 Manual

Intermec

Intermec Microbar 9745 Base Station Manual de usuario

Intermec

Intermec Trakker Antares 2480 Manual de usuario

Intermec

Intermec SR61 Manual de usuario

Intermec

Intermec SE1022 Manual de usuario

Intermec

Intermec MicroBar NX Manual de usuario

Intermec

Intermec Sabre 1517 Manual

Intermec

Intermec MaxiScan 2200 Manual de usuario

Intermec

Intermec SR30 Manual de usuario

Intermec

Intermec ScanPlus 1800ST Manual de usuario

Intermec

Intermec MicroBar NX Manual de usuario

Intermec

Intermec MaxiScan 2220 Manual

Intermec

Intermec Sabre 1551C Manual de usuario

Intermec

Intermec Trakker Antares 2420 Manual de usuario

Intermec

Intermec SG20B Manual de usuario

Intermec

Intermec Sabre 1552 Scanner Manual de usuario

Manuales populares de Escáner de otras marcas

Plustek

Plustek Scanner Manual de usuario

Z/I Imaging

Z/I Imaging PhotoScan 2001 Manual de usuario

Renkforce

Renkforce DS100-5M Manual de usuario

Image Access

Image Access WideTEK A2 Manual de usuario

Canon

Canon imageFORMULA CR-120N Manual de usuario

Fujitsu

Fujitsu FI-4860C2 Manual de usuario

GeoSlam

GeoSlam ZEB Horizon Instrucciones de instalación

Kodak

Kodak i5800 Scanner Manual de usuario

Kodak

Kodak i7300 Manual de usuario

Revopoint

Revopoint POP Manual de usuario

Fujitsu

Fujitsu fi-4860C Manual de usuario

Eddyfi Technologies

Eddyfi Technologies Floormap X Manual de usuario

Faselase

Faselase F6 Manual de usuario

Fujitsu

Fujitsu CardMinder Manual de usuario

Uniden

Uniden BC340CRS Manual de usuario

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Manual de usuario

Mustek

Mustek PageExpress 4800 Pro Manual de usuario

Optex

Optex 750830 Manual de usuario