Intergraph TD-200 Targa 2000 Manual de usuario
TD-200 Targa 2000
Configuration Guide for Value-Added Resellers
March 1997
DSA082900
Copyright
1997 Intergraph Corporation. All rights reserved. This document may only be used pursuant to the
applicable software license agreement. This document contains information protected by copyright, trade
secret, and trademark law. This document may not, in whole or in part, be reproduced in any form or by
any means, or be used to make any derivative work, without written consent from Intergraph Corporation.
Intergraph Corporation, Huntsville, AL 35894-0001 205-730-2000
Restricted Rights Legend
Use, duplication, or disclosure by the United States Government is subject to restrictions as set forth in
subdivision (c)(1)(ii) of the rights in technical data and computer software clause at DFARS 252.227-
7013. Unpublished rights are reserved under the copyright laws of the United States.
Disclaimer
Information discussed in this document is subject to change without notice and should not be considered a
commitment by Intergraph Corporation. Integraph Corporation assumes no responsibility for any errors
in this document.
Trademarks
Intergraphand the Intergraph logo are registered trademarks of Intergraph Corporation. TD is a
trademark of Intergraph Corporation. Other brands and product names are trademarks of their respective
owners.
iii
Contents
Preface .........................................................................................................................v
About This Document....................................................................................................v
Document Conventions..................................................................................................v
Finding Additional Information .....................................................................................v
Getting Documentation and Training ...........................................................................vi
Getting Telephone Support..........................................................................................vii
Using the Intergraph Bulletin Board Service................................................................vii
Using the Intergraph FAXLink...................................................................................viii
Finding Intergraph on the Internet ..............................................................................viii
1 Getting Started .........................................................................................................1
Setting Up System Hardware and Software....................................................................1
Using the ISA Configuration Utility ..............................................................................1
Taking Antistatic Precautions ........................................................................................2
Getting More Information..............................................................................................2
2 Configuring the System............................................................................................3
Verify the Current IRQ Settings ....................................................................................4
Remove or Move the PCI Expansion Boards..................................................................4
Configure the ISA Expansion Boards ............................................................................4
Disable On-board Audio and Free IRQ Settings.............................................................5
Remove Drivers and Services for Networking and Audio...............................................5
Free Audio IRQ Settings................................................................................................6
Re-install the PCI SCSI Adapter....................................................................................6
Install the Targa 2000 Board .........................................................................................7
Add Networking............................................................................................................8
Create a Disk Drive Stripe Set .......................................................................................9
Configure to Use PC Card Devices................................................................................9
iv
v
Preface
The TD-200 Targa 2000 Configuration Guide for Value-Added Resellers provides help for
value-added resellers who want to configure an Intergraph TD-200 system to use
Truevision’s Targa 2000 DTX or Targa 2000 RTX expansion board.
CAUTION This document is intended only for value-added resellers. Do not distribute this document to
end-users.
About This Document
The TD-200 Targa 2000 Configuration Guide for Value-Added Resellers is organized as
follows:
u
Chapter 1, “Getting Started,” describes how to get ready to configure the system to use a
Targa 2000 board.
u
Chapter 2, “Configuring the System,” describes how to configure the system to use a
Targa 2000 board.
Document Conventions
Bold Commands, words, or characters that you key in literally.
Italic Variable values that you supply, or cross-references.
Monospace Output displayed on the screen.
SMALL CAPS Key names on the keyboard, such as D, ALT or F3; names of files and
directories. You can type filenames and directory names in the dialog
boxes or the command line in lowercase unless directed otherwise.
CTRL+DPress a key while simultaneously pressing another key; for example, press
CTRL and D simultaneously.
Finding Additional Information
For information on setting up, configuring, and using the Intergraph TD-200 system, refer to
the printed and online documentation delivered with the system.
vi
For information on the Windows NT Workstation 4.0 operating system, refer to the printed
and online Microsoft documentation delivered with the system:
u
For basic information on installing and using Windows NT, refer to Start Here.
u
For detailed information on using Windows NT, refer to Windows NT Help.
For information on installing and using Truevision’s Targa 2000 DTX or Targa 2000 RTX
expansion board, refer to the documentation delivered with the product.
Getting Documentation and Training
You can purchase additional product documentation from Intergraph.
u
In the United States, contact your sales account representative, call the Intergraph Order
Desk at 1-800-543-1054, or send a fax to 1-800-548-3318 to place an order. If you call
or fax the Order Desk, have the document numbers ready for the items you wish to
purchase.
u
Outside the United States, contact the Intergraph subsidiary or distributor from which
you purchased your Intergraph product to place an order.
To find information on training for Intergraph products, or to enroll for an available class,
contact Intergraph Training Solutions at 1-800-240-3000.
To find information on documentation and training for Truevision products, contact
Truevision.
NOTE End-users who want information on training or documentation for Intergraph or Truevision
products should contact their value-added reseller.
vii
Getting Telephone Support
If you experience problems with your Intergraph product, or have questions about the
information in this document, you can contact Intergraph for help.
u
In the United States, call the Customer Response Center at 1-800-633-7248 between the
hours of 7:00 a.m. and 7:00 p.m. Central Time, Monday through Friday (except
holidays).
u
Outside the United States, contact the Intergraph subsidiary or distributor from which
you purchased your Intergraph product.
Have the following information readily available when you call:
u
The product’s serial number or your service/CPIN number.
u
The product’s name or model number.
u
Your name and telephone number.
u
A brief description of the question or problem.
NOTE End-users who want telephone support for TD-200 systems configured with Targa 2000
boards should contact their value-added reseller.
Using the Intergraph Bulletin Board Service
Available 24 hours a day, 7 days a week, the Intergraph Bulletin Board Service (IBBS) is an
electronic forum for Intergraph customers to exchange information with Intergraph's
technical and marketing staff, and with other Intergraph customers. You can use the IBBS
to get technical support information, documentation and training information, programs, and
software updates and fixes. The IBBS is also available for you to give suggestions, make
inquiries, and report problems.
To connect to the IBBS:
1. Set your system’s communications protocol for eight (8) data bits, no parity, one (1) stop
bit, and any baud rate up to 14,400.
2. Using a modem, dial the IBBS number, 1-205-730-8786. You can dial 1-205-730-6504
if you are using a 2,400 baud connection.
Mirror sites are maintained for locations outside the United States. Information on these
sites is available on Intergraph Online, Intergraph’s World Wide Web server.
3. When connected, respond to the login request by keying in your user ID. If you have not
connected before, key innew to create a user ID.
viii
4. Follow the menus to find what you need. If you are new to computer bulletin boards, the
IBBS provides clear choices and plenty of online help. A text file that explains IBBS
commands and organization is available for you to download.
If you have trouble connecting to or using the IBBS, log a support request through the
Customer Response Center (product entry IBBS), send a fax to 1-205-730-1110, or leave a
message for the System Operator (Sysop) at 1-205-730-1413.
Using the Intergraph FAXLink
You can use the Intergraph FAXLink to get technical support information by fax 24 hours a
day, 7 days a week. From a touch-tone phone or fax machine phone:
u
Call 1-800-240-4300 to get new user instructions, an index listing of available
documents, and an overview of the categories of available information.
u
Call 1-205-730-9000 to order the documents (up to 5 per call).
Follow the prompts provided to locate and deliver the information you need.
Finding Intergraph on the Internet
You can find Intergraph on the Internet in the following ways:
u
If you have a World Wide Web browser, connect to Intergraph Online, Intergraph’s
World Wide Web server, at http://www.intergraph.com. From the home page, follow
the links to Customer Services for information on available customer services and
support options.
u
If you have a File Transfer Protocol (FTP) program or Gopher program, connect to
Intergraph at ftp.intergraph.com or gopher.intergraph.com.
u
help in the body of the message (the subject line is ignored) to get information on such
subjects as Intergraph’s online services and where to get World Wide Web browsers.
u
You can participate in the Intergraph Customer Forum (ICF), a bidirectional gateway to
the USENET newsgroup comp.sys.intergraph. Anything posted to that group or sent
messages are also posted to the newsgroup. You can subscribe to the ICF via Intergraph
Online.
1
1 Getting Started
Follow the instructions in this chapter to prepare to install a Targa 2000 board in an
Intergraph TD-200 system.
Setting Up System Hardware and Software
Set up the TD-200 hardware and system software as described in the hardware
documentation delivered with the system.
Make sure the following operating system software is installed and running on the TD-200:
u
Windows NT Workstation 4.0
u
Windows NT Workstation 4.0 Service Pack 1
This TD-200 system configuration is offered only on Windows NT Workstation 4.0. Targa
2000 software has not been tested by Intergraph Computer Systems on TD-200 systems
running Windows NT Workstation 3.51.
Using the ISA Configuration Utility
You will be configuring system interrupt requests (IRQs) and disabling or changing Industry
Standard Architecture (ISA) hardware resources on the system (such as the on-board sound
processor on the TD-200 system board). This will ensure that the Targa 2000 board has the
proper interrupt priority and can use the system disks correctly. You should use the ISA
Configuration Utility (ICU) program to view IRQs and disable or change ISA hardware
resources on the system.
The ICU program is part of the System Utilities (SYSUTIL) product for the TD-200. If you
do not have the ICU program, you can get the latest version from the Intergraph Bulletin
Board Service (IBBS). Refer to the hardware documentation delivered with the TD-200 for
instructions on getting the SYSUTIL product, and installing and running the ICU program.
2
Taking Antistatic Precautions
You will be opening the system to remove and install expansion boards. Some components
in a system can be damaged by static electricity. To minimize the possibility of damage, take
the following steps:
u
Turn off power to the system.
u
Leave the power cord connected to the system and to the AC outlet to maintain ground.
u
Touch the metal chassis to drain off any static electricity.
u
Wear a properly connected grounding wrist strap. Make sure the wrist strap is
connected properly to the system and contacts bare skin on your wrist.
u
Do not wear wool or polyester clothing.
u
Work in an area with a relative humidity of at least 50 percent.
u
Work on an antistatic surface.
Getting More Information
Refer to the hardware documentation delivered with the TD-200 for information on opening
and closing the system’s base unit, getting and running the ICU program for the system,
using the BIOS Setup program, and adding expansion boards to the system.
Refer to the online ICU Help for information on defining an ISA expansion board to the
system, and to the documentation delivered with the Targa 2000 board for detailed
installation and configuration instructions.
Refer to the operating system documentation and Help for information on Windows NT
administration tasks such as adding and removing hardware, drivers, and network support,
and creating a disk drive stripe set.
Tabla de contenidos
Otros manuales de De oficina de Intergraph
Intergraph
Intergraph TDZ-300 Manual de funcionamiento
Intergraph
Intergraph TD-260 Manual de lista de piezas
Intergraph
Intergraph TDZ 2000 GL2 Workstation Guía del usuario
Intergraph
Intergraph TD-x10 Setup Guía del usuario
Intergraph
Intergraph TDZ 2000 GL1 Guía del usuario
Intergraph
Intergraph TD-x20 Setup Guía del usuario
Intergraph
Intergraph TD-20 Setup Guía del usuario
Intergraph
Intergraph TDZ 2000 GL1 Manual de usuario
Intergraph
Intergraph TDZ 2000 GT1 Manual de usuario
Intergraph
Intergraph TD-300 Manual de funcionamiento
Intergraph
Intergraph TDZ 2000 GL2 Workstation Manual de usuario
Intergraph
Intergraph TDZ 2000 GT1 Manual de usuario
Intergraph
Intergraph TD-300 Manual de funcionamiento
Intergraph
Intergraph TD-2x Manual de usuario
Intergraph
Intergraph TDZ 2000 GL2 Workstation Manual de usuario
Intergraph
Intergraph TD-325 Targa 2000 Manual de usuario
Intergraph
Intergraph ExtremeZ SAN Guía
Intergraph
Intergraph Zx1 ViZual Workstation Guía del usuario
Intergraph
Intergraph TD-x20 Setup Manual de usuario
Intergraph
Intergraph TDZ 2000/ExtremeZ Manual de usuario
