Intercall 600/700 Installation & Operation Guide Issue 4.59 Page 8 of 77
Intercall 600 User Guide.
Layout of the Intercall 622 and 722 Non Audio Call Point.
Making a standard call.
A standard call can e generated y any of the following:
•Pressing the Call button on the call point.
•Activation of the pear lead (or other device) plugged into the Jack socket.
•Operation of a ceiling pull switch wired to the call point.
•Un-plugging the pear lead from the Jack socket.
To confirm a standard call is active, the Re-assurance light will flash red one per second.
Staff Present Mode*.
When mem ers of staff enter a room, they must press the Reset button on the call point. The
call point is now in ‘Staff Present’ mode and the Re-assurance light will show a constant green.
Other mem ers of staff can now locate them, y pressing the ‘Show Staff’ utton on any display
unit. When they leave the room, they should press the Reset button again, this tells the system
they are no longer in the room & the Re-assurance light is off.
Staff Assistance Call*.
Staff assistance call can only e generated when the call point is in staff present mode and the
Re-assurance light showing constant green. Pressing the Call button will generate an assistance
call and the Re-assurance light will alternate red, then green, once a second to confirm this
action. To cancel the assistance call, press the Reset Button once. The call point is now in staff
present mode with the Re-assurance light showing constant green. To cancel the staff present,
press the Reset Button again until the Re-assurance light is off.
Staff Emergency/Crash Call.
Staff emergency call can e generated at any time y pressing the Call Button and the Reset
Button simultaneously (or pressing the Emergency Button). To confirm this action the Re-
assurance light will showing a rapid red flashing light. To cancel the emergency call, press the
Reset Button once, the call point is now in staff present mode with the Re-assurance light
showing constant green. To cancel the staff present mode, press the Reset Button again until
the Re-assurance light is off. On early Intercall 600 systems, unanswered standard calls could
e set to time-out and automatically convert to emergency calls.
Call Accepted.
To avoid several mem ers of staff from responding to a single call, calls may e accepted from
any display unit. To accept a call, wait until the call you wish to accept is on the top line of the
display and press the Accept Button. The call point re-assurance light will flash green to let the
resident know that staff are on their way. The call point will return to the calling condition if the
call point is not reset within a pre-set time period. Only standard calls and assistance calls can
e accepted.
* Features ig lig ted in t is way, may be disabled by t e commissioning engineer.
Intercall 600 Call levels and what they mean.
Call –
Standard patient call
Assistance –
Staff requiring assistance.
Emergency –
Staff requiring urgent assistance.
Present
–
A mem er of staff is in the room
.
Visit
–
A mem er of staff has accepted the call at the
display and is on their way to the resident.
Call utton.
Reset utton.
Re-assurance light.
Jack socket.
