721U0901 Rev 03 - Product specications are subject to change
4Page
Toll Free (N.A.): 1.800.267.9111
Telephone: 1.613.592.4642
www.instantel.com
Warranty
Instantel products come with a one-year warranty. Monitoring units and sensors will have the warranty extended for a second year if they are returned
to the Instantel factory for service and calibration within 30 days of the ‘Next Calibration’ date printed on the calibration label located on the product.
If within a period of one year from the date of shipment to a customer, the instrument fails to perform in accordance with Instantel’s published
specications and the operator’s manual, due to a defect in materials or workmanship, it will be repaired or replaced at Instantel’s option, free of
charge. This warranty is void if the equipment has been dismantled, altered or abused in any way. This warranty is nontransferable.
This warranty does not include any implied warranty of functionality for a particular purpose. Instantel assumes no responsibility for damages of any
description resulting from the operation or use of its products. Since it is impossible to anticipate all of the conditions under which its products will
be used either by themselves or in conjunction with other products, Instantel cannot accept responsibility for the results unless it has entered into a
contract for services which clearly dene such an extension of responsibility and liability.
Any shipments returned directly to Instantel Inc. must have our prior approval and all packages must display the Return of Material Authorization
(RMA) number issued by Instantel. Shipping charges to Instantel’s plant will be paid by the customer and those for return to the customer will be
paid by Instantel.
To protect your warranty, you must complete and return a Warranty Registration Certicate, or complete the online Warranty Registration Form,
within ten days of purchase. Products will be assumed out of warranty if there is no warranty card on le at Instantel. Retain this portion and the
proof of purchase for your records.
EC Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate measures.
Physical Installation
1. Connect the Remote Alarm Controller to the Auxilliary connector on the monitoring unit. To increase the distance
between the two devices make use of the appropriate extension cable as referenced by unit and part number in
the previous table.
2. The output available on the terminal block is only a switch. You must supply external power to drive the load.
When using an external warning device, the common terminal is the ground or minus side of the external
load-power source combination. Normally, one side of the external load connects to the positive side of the
power supply. The negative side of the power supply connects to the common terminal.
Micromate Alarm Setup
1. Press the Setup key to access the Setup Options.
2. Press the Checkmark key to enter the View/Edit Current Setup menu option.
3. Press the Down Arrow key to select the Auxiliary I/O option.
4. Press the Checkmark key to enter the menu.
5. Press the Down Arrow key to select Auxiliary Mode.
6. Scroll through the available options using the Checkmark key until Remote Alarm is selected.
7. Press the Down Arrow key to select Alarm On and enter the menu using the Checkmark key.
8. Change the values using the Down Arrow and Checkmark keys.
9. Press Cancel to exit and Save any changes.
10. Use the Down Arrow key to select the Warning Hold and Alarm Hold options.
11. Change their values using the Checkmark key to scroll through the available settings.
12. Press the Cancel key to exit, validate the changes by saving them with the Checkmark key.
13. Select Save to Current File and then Overwrite File, or Save to New File and create a new le name
using the touchscreen keypad.
14. Press Cancel to exit and return to the Homescreen.
