Page7
CONSTRUCTION FEATURES
The ..2.0 Rinnova Ceiling units are designed for the renewal of air in rooms. The ease of installation through two 160 mm diam. holes and the high renewal air
flow rate allow application in situations such as residential buildings, schools, clinics, offices and all contexts where air renewal is required; The thermodynamic
recovery allows to have an integration with respect to the environmental climatic conditions, helping the air conditioning system to satisfy the internal comfort;
Furthermore, the air introduced is always at a temperature close to or better than the room temperature, thus guaranteeing superior perceived comfort;
The unit is made up of a monobloc including all components for correct operation: fans, cooling circuit with high efficiency compressors, air filtration sections and
high efficiency counter-current heat recovery unit.
ALL IN ONE: Complete unit capable of exchanging the air and integrating the thermal and refrigeration requests of
the rooms served. The unit is complete with every component for its operation and is ready for use.
UV LAMP AND VOC SENSOR: The unit is equipped with a UV lamp (accessory) which allows a germicidal action on the air
introduced from outside through the effect of the UVC; The lamp is activated automatically
according to the ambient air quality,
VENTILATION: Fans with directly coupled brushless motor; The fans operate in various modes mainly controlled by
the air quality sensor located inside the unit;
ACTIVE THERMODYNAMIC RECOVERY: The unit allows the active recovery of the energy of the expelled air. The thermodynamic recovery
allows, thanks to its cooling circuit, to supply energy to the environment in a higher quantity than that
subtracted from the ventilation for 90% of the unit's operation;
FILTRATION: There are 2 ePM1 filters on the extracted air and the introduced air; The inlet air filter is placed after
the coil to completely filter out any impurities in the inlet air. There is a Coarse pre-filter on the
outside air which protects the cleanliness of the unit;
STRUCTURE: Self-supporting sheet metal frame
Self-supporting sheet metal structure, externally painted (in the visible versions), with interposed
thermal and acoustic insulation in polyethylene and Epdm;
REFRIGERANT CIRCUIT: Made of brazed copper complete with: BLDC high efficiency compressor, drier filter, finned coils,
electronic expansion valve, reverse valve and safety devices.
ADJUSTMENT: Electrical panel on the unit with microprocessor and dedicated regulation. Fan management, display
and timed dirty filter management temperature setpoint.
Defrost algorithm management optimized for operation with low outside temperatures; Panel with
graphic interface and WI-FI on board the machine and remote control included in the visible
versions;
Remote panel to be purchased optionally with WI-FI or MODBUS RTU for connection up to 10 m
from the unit for built-in versions;
