General information
5
2General information
This operating manual contains all the information you need for commissioning and using
the HUB-RT100 or the HUB-MRT100. It is intended both for installers and testers who
commission the device themselves and for service and maintenance technicians who
install extensions or perform fault analyses.
2.1 Scope of delivery
1 x HUB-RT100 or HUB-MRT100
1 x Instruction Manual (PDF)
2.2 General instructions for use
in.hub GmbH assumes no liability for malfunctions of the device resulting from improper
handling, mechanical damage, incorrect application and use for other than the intended
purpose. Improper handling of the device can significantly reduce the service life of the
product.
2.3 Intended use
HUB-RT100 and HUB-MRT100 are intended exclusively for use in industrial applications.
2.4 Safety requirements
The product should be handled in accordance with the following DIN standards:
•DIN EN 61340-5-1:2017-07 Electrostatics – Part 5-1: Protection of electronic
components against electrostatic phenomena – General requirements
•DIN EN 61010-1:2020-03 Safety requirements for electrical equipment for measurement,
control, and laboratory use - Part 1: General requirements
•DIN EN 60664-1:2008-01 Insulation coordination for equipment within low-voltage
systems - Part 1: Principles, requirements, and tests
2.5 Disposal
The device and the battery must be disposed of separately.
Do not dispose of the device and battery in household waste, but hand them in at
a local collection point.
