IMT Diamond Air DA435ELW Manual de usuario
DA435ELW: 99900917: iii
PRECAUTIONS
Read before operating your compressor!
19980223
71393886
DANGER
EXPLODINGTANK WILL CAUSE
DEATH, SERIOUS INJURY
OR PROPERTY DAMAGE
●
Drain air tank after each use to prevent
moisture build-up and corrosion which
leads to tank failure.
Assure that tank and compressor relief
valves work properly, and are at correct
pressure settings.
DO NOT modify or repair air tank.
NEVER drive vehicle with pressure in air
tank.
●
●
●
DA435ELW: 99900917: v
TABLE OF CONTENTS
PARA TITLE PAGE
Section 1. SPECIFICATIONS
GENERAL 1-1
SPECIFICATIONS 1-1
OUTSIDE DIMENSIONS 1-1
Section 2. NOT USED
Section 3. OPERATION
GENERAL 3-1
OPERATION 3-1
Section 4. MAINTENANCE & PARTS
GENERAL 4-1
ROUTINE MAINTENANCE CHECKLIST 4-1
AIR COMPRESSOR DA435ELW-PARTS (51713976) 4-2
AIR COMPRESSOR DA435ELW-DRAWING (51713976) 4-3
AIR COMPRESSOR DA435ELW-DRAWING (51713976) 4-4
REPAIR KITS 4-5
PRESSURE SWITCH KIT (51713977) 4-5
Section 5. REPAIR
5-1. GENERAL 5-1
5-2. PISTON RING REPLACEMENT 5-1
5-3. OIL PUMP REPLACEMENT 5-2
5-4. CRANKSHAFT AND BEARING REPLACEMENT 5-4
5-5. COMPRESSOR DRIVE BELT REPLACEMENT 5-5
5-6. CLUTCH REPLACEMENT 5-5
5-7. TROUBLESHOOTING 5-6
19980223
DA435ELW: 99900917: 1-119970808
SPECIFICATIONS
Bore 2-5/8"
Stroke 2-1/2"
Cylinder Configuration V4
Displacement 44 CFM*
Delivery 35 CFM*
Lubrication Oil Pump
Oil Capacity 1-1/3 qts
Cooling Water
Height 13-1/2”
Width 15”
Length 13-7/8”
Material Aluminum Alloy
Weight 87 lbs.
* @ 1400 RPM - 100 PSI
SECTION 1. SPECIFICATIONS
OUTSIDE DIMENSIONS
GENERAL
The IMT DA435ELW air compressor is a single
stage, liquid cooled, 4-cylinder, pressure lubricated
unit, with a delivery rate of 35 CFM at 1400 RPM.
The compressor is belt driven from the engine
crankshaft, through a magnetic clutch. It is engaged
and disengaged by use of an air pressure sensing,
electric switch. This pressure switch is preset at
approximately 90 PSI to engage, and 130 PSI to
disengage.
CAUTION
OPERATING THE COMPRESSOR AT 35 CFM WITH
PRESSURESGREATERTHAN130 PSIWILLSHORTEN
THE SERVICE LIFEAND VOID THE WARRANTY.
The compressor must not operate more than 6
minutes out of a 10 minute period. This will include
operating continuously for 6 minutes out of 10
minutes or operation in segments for a total of 6
minutes out of 10 minutes.
DA435ELW: 99900917: 3-119970508 SECTION 3. OPERATION
GENERAL
Each compressor is bench tested under load at the
factory to ensure proper break-in and operation.
While it is not necessary to follow any break-in
procedure, the following checks should be made
before putting the unit into service, as well as,
periodically during use.
Before start-up:
1. Check the oil level in the compressor
crankcase with the dipstick on the unit. If oil is
needed, use only IMT’s synthetic compressor oil.
2. Check the air intake filter pads on each head
to make certain that they are clean and
unobstructed. Dirty filters are a possible cause of
reduced air output. Bi-weekly checks of air
filters is recommended.
OPERATION
The system will function automatically. It will
engage the compressor clutch when the air receiver
tank pressure is below 90 psi, and disengage the
clutch when the air pressure reaches 130 psi.
CAUTION
OPERATING THIS UNIT IN EXCESS OF 1400 RPM,
WILLVOIDTHEWARRANTY,ANDWILLSHORTENTHE
NORMAL SERVICE LIFE OF THE COMPRESSOR.
Tabla de contenidos
Otros manuales de Compresor de aire de IMT
