Impex IRON GRIP STRENGTH TSA-5762 Manual de usuario

NOTE:

Please read all instructions

carefully before using this

product

Table of Contents

Safety Notice

Hardware Pack

Assembly Instruction

Parts List

Warranty

Ordering Parts

Model

TSA-5762

Retain This

Manual for

Reference

06-27-05

OWNER'S

MANUAL

IRON GRIP STRENGTH

Deluxe Olympic Bench

TSA-5762

IMPEX INC.

14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746

Tel: (800) 999-8899 Fax: (626) 961-9966

www.impex-fitness.com

[email protected]

TABLE OF CONTENTS

BEFORE YOU BEGIN...................................................................................... 1

IMPORTANT SAFETY NOTICE....................................................................... 2

HARDWARE PACK……….....…....................................................................... 4

ASSEMBLY INSTRUCTIONS........................................................................... 6

EXPLODED DIAGRAM.........................................................................………. 11

PARTS LIST…………………………………………………………………………. 12

WARRANTY.................................................................................................… 13

ORDERING PARTS......................................................................................... 13

BEFORE YOU BEGIN

Thank you for selecting the IRON GRIP STRENGTH Deluxe Olympic Bench

TSA-5762 by IMPEX INC. For your safety and benefit, read this manual

carefully before using the machine. As a manufacturer, we are committed to

provide you complete customer satisfaction. If you have any questions, or

find there are missing or damaged parts, we guarantee you complete

satisfaction through direct assistance from our factory. To avoid unnecessary

delays, please call our TOLL-FREE customer service number. Our Customer

Service Agents will provide immediate assistance to you.

Toll-Free Customer Service Number

1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST

www.impex-fitness.com

[email protected]m

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply

whenever you operate a piece of exercise equipment. Be sure to read the entire manual

before you assemble or operate your machine. In particular, note the following safety

precautions:

1. Keep children and pets away from the machine at all times. DO NOT

leave children unattended in the same room with the machine.

2. Only one person at a time should use the machine.

3. If the user experiences dizziness, nausea, chest pain, or any other abnormal

symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.

4. Position the machine on a clear, leveled surface. DO NOT use the machine

near water or outdoors.

5. Keep hands away from all moving parts.

6. Always wear appropriate workout clothing when exercising. DO NOT wear

robes or other clothing that could become caught in the machine. Running

or aerobic shoes are also required when using the machine.

7. Use the machine only for its intended use as described in this manual. DO

NOT use attachments not recommended by the manufacturer.

8. Do not place any sharp object around the machine.

9. Disabled person should not use the machine without a qualified person or

physician in attendance.

10. Before using the machine to exercise, always do stretching exercises to

properly warm up.

11. Never operate the machine if the machine is not functioning properly.

12. A spotter is recommended during exercise.

CARE AND MAINTENANCE

1. Inspect and tighten all parts before using the machine.

2. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.

DO NOT use solvents.

3. Maximum weight capacity 300 lbs.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR

PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE

OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL

INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.

ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE

SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

WARNING LABEL PLACEMENT

The Warning Label shown here has been placed on the Upright Beam. If the label is missing or illegible, please

call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.

HARDWARE PACK

ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen

Wrenches. NOTE: It is strongly recommended two or more people assembling this

machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Push four ∅3” End Caps (#31) onto the bases of Right & Left Upright Beams (#1 &

#2).

B.) Connect the Left & Right Upright Beams (#1 & #2) by a Cross Brace (#3) in the mid-

span. Align the holes and secure each end with two M10 x 3 ¾” Carriage Bolts (#47),

one 5 ½” x 3 3/8” Bent Bracket (#24), two ∅¾” Washers (#59), and two M10 Aircraft

Nuts (#46).

C.) Place the Backrest Adjustment Bar (#16) onto the selected slot on the Upright Beams.

D.) Slide a Glider (#10) onto a Guide Rod (#14) from the bottom.

E.) Slide a Safety Stop (#11) onto the Guide Rod from the bottom. Attach a Safety Catch

Hook (#23) to the Safety Stop. Secure it with one M10 x 1” Allen Bolt (#52), two Ø ¾”

Washers (#59), and one M10 Aircraft Nut (#46).

F.) Attach and secure the top of the Guide Rod to the Right Upright Beam (#1) with one

M10 x 1” Allen Bolt (#52) and Ø ¾” Washer (#59). Secure the bottom to the base with

one M10 x 3 ¾” Allen Bolt (#49) and Ø ¾” Washer (#59).

G.) Repeat Procedures D, E, and F above to install the other side.

H.) NOTE: Help of another person to install the Weight Bar in this step is strongly

recommended. Place the Lifting Sleeve (#13) in between the two Gliders (#10). Align

the holes and insert the Weight Bar (#15) into the Glider from one end through the

Lifting Sleeve to the other Glider on the opposite side. Secure the Weight Bar with two

M8 x 3/8” Allen Bolts (#56).

I.) Attach two Long Olympic Sleeves (#33) onto the Weight Bar from both ends. Secure

the Sleeve to the Weight Bar with the screw on the Sleeve. Attach a Spring Clip (#27)

to each Sleeve.

DIAGRAM 1

STEP 2 (See Diagram 2)

A.) Attach the Main Seat Support (#4) to the Cross Brace (#3). Secure it with one 5 ½” x 3”

Bent Bracket (#25), four M10 x 2 3/8” Carriage Bolts (#48), four Ø ¾” Washers (#59)

and four M10 Aircraft Nuts (#46).

B.) Attach the seat support frame on the Leg Developer Holder (#5) to the bracket on the

Main Seat Support (#4). Secure it with one M10 x 2 ¾” Allen Bolt (#50), two Ø ¾”

Washers (#59), and one M10 Aircraft Nut (#46). Do not tighten the Nut and Bolt yet.

C.)Attach the bottom of Leg Developer Holder (#5) to the Main Seat Support. Secure it

with one Bracket (#19), two M10 x 2 3/8” Allen Bolts (#51) and two Ø ¾” Washers

(#59). Securely tighten all the Nuts and Bolts previously installed.

D.)Place the Seat (#22) onto the seat support frame on the Leg Developer Holder. Secure

it with four M8 x 5/8” Allen Bolts (#55) and Ø 5/8” Washers (#58).

E.) Thread the Lock Knob (#29) into the hole on the Leg Developer Holder.

F.) Insert a Foam Tube halfway through the hole on the Leg Developer Holder. Push two

Vinyl Foam Rolls (#32) onto the Tube from both ends. Push two Foam Roll End Caps

(#39) into the ends. DIAGRAM 2

STEP 3 (See Diagram 3)

A.) Attach the Backrest Incline Support (#12) in between the two side-holes on the

Backrest Supports (#17). Attach the Backrest Supports to the pivot on the Main Seat

Support (#4). Secure it with one M12 x 7 ½” Allen Bolt (#53), two ∅1” Washers (#60),

and one M12 Aircraft Nut (#45).

B.) Place the other end of Backrest Supports rest against the Backrest Adjustment Bar.

C.) Place the Backrest Board (#21) onto the Backrest Supports (#17). Secure it with four

M8 x 1 5/8” Allen Bolts (#54) and Ø 5/8” Washers (#58).

D.) Attach the Leg Developer (#6) to the Leg Developer Holder (#5). Secure it with one

Axle (#28), two M10 x 1” Allen Bolts (#52), and two Ø ¾” Washers (#59).

E.) Insert two Foam Tubes (#18) halfway through the holes on the Leg Developer. Push

four Vinyl Foam Rolls (#32) onto the Tubes. Push four Foam Roll End Caps (#39) into

the Tubes from both ends.

F.) Attach a Short Olympic Sleeve (#34) to the weight post on the Leg Developer. Attach a

Spring Clip (#27) to the Sleeve.

G.) Attach the Curl Bar Handle (#9) to the bracket on the Leg Developer. Secure it with a

L-shaped Lock Pin (#26).

H.) Attach the Arm Curl Pad (#20) to the Arm Curl Stand (#7). Secure it with two M8 x 5/8”

Allen Bolts (#55) and Ø 5/8” Washers (#58). Insert the Arm Curl Stand into the opening

on top of Leg Developer Holder. Secure it with the Lock Knob.

I.) Remove the Arm Curl Stand and Curl Bar Handle when doing Leg exercises.

Tabla de contenidos

Otros manuales de Gimnasio en casa de Impex

Impex

Impex MD-2100 Manual de usuario

Impex

Impex IGS-6201 Manual de usuario

Impex

Impex WM 1403 Manual de usuario

Impex

Impex MARCY PLATINUM MP-3100 Manual de usuario

Impex

Impex SB 661 Manual de usuario

Impex

Impex AMZ-979RW Manual de usuario

Impex

Impex MWB-36780B Manual de usuario

Impex

Impex Circuit Fitness AMZ-986RW-BT Manual de usuario

Impex

Impex IRON GRIP STRENGTH TSA-410 Manual de usuario

Impex

Impex MFB 400 Manual de usuario

Impex

Impex Marcy SB-662 Manual de usuario

Impex

Impex Circuit Fitness AMZ-986RW Manual de usuario

Impex

Impex PLATINUM MARCY PM-9150 Manual de usuario

Impex

Impex APEX PT-36 Manual de usuario

Impex

Impex MARCY DIAMOND ELITE MD-9010G Manual de usuario

Impex

Impex TR-2 Manual de usuario

Impex

Impex Marcy Platinum MP-PWR10.0 Manual de usuario

Impex

Impex COMPETITOR CG 1400 Manual de usuario

Impex

Impex Marcy SB-512 Manual de usuario

Impex

Impex PM-4510 Manual de usuario

Impex

Impex MWB-838 Manual de usuario

Impex

Impex MARCY DIAMOND ELITE MD-389 Manual de usuario

Impex

Impex Marcy SB-350 Manual de usuario

Impex

Impex MARCY AB4000 Manual de usuario

Manuales populares de Gimnasio en casa de otras marcas

Horizon Fitness

Horizon Fitness OXFORD 6 Manual de usuario

Energetics

Energetics Multi Trainer 5.1 Manual de usuario

Matrix

Matrix MG-PL Series Manual de usuario

Reebok

Reebok Tbr2i Manual de operación y mantenimiento

Weider

Weider 8300 Hard Drive Manual de usuario

Pure Fitness

Pure Fitness 8526HE Manual de usuario

Weider

Weider 8700 I Guía de inicio rápido

Bowflex

Bowflex Sport 001-6961 Manual de usuario

NordicTrack

NordicTrack E8200 Competition Bench Guía de inicio rápido

Weider

Weider WEMC10161 Manual de usuario

Body Solid

Body Solid GHYP-345 Manual de usuario

Evo

Evo TAHOE 5105 Manual de usuario

cardiobull

cardiobull RA17 Manual de usuario

ParaBody

ParaBody 40 Manual de usuario

JLL

JLL Ventus Pro Air Power Manual de usuario

Trojan

Trojan Colorado 370 Manual de usuario

Octane Fitness

Octane Fitness xRide xR650 Manual de usuario

Precor

Precor Discovery Series Manual de usuario