Lithium baeries (Lilo/LiPo/LiFe) program
Press key to the screen on the le, then press key to enter into the parameter
seng menu. You can switch at the same level menu by key. Please refer the detailed
flow chart on the le. When you are willing to alter the parameter value in the program,
press key to make it blink, then change the value with Key. The value will be
stored by pressing key once, and then press key for more than 2 seconds to start
the process.
Mode
Esc
Mode/Esc
Enter
Start
Enter/Start
Enter
Start Enter
Start
Enter
Start
Dec./Inc.
Dec./Inc.
“AUTO charging” this is for individual Lithium baery or some special baery pack without
balance port or cell count. The le side of the first line shows the type of baery you
selected at the user seng. The right side of the first line shows you the mode of charge. The
value on the le side of second line sets a charge current and the value on the right side of
second line sets the cells count of the baery. The definion of the following screen is all the
same. (To know how to connect, please refer picture B)
“Balance charging” this is for 2-6cells of Lithium baery with balance port, the baery pack
being charged should have the individual cell connect, and connect it to the individual port
at the right side of charger with a suitable connecon cable that fits with your baery pack.
(See picture B) In this mode, the charging process will be different from ordinary charging
mode. The internal processor of the charger will monitor and control the voltage of each
cell of the baery pack. This can improve the discharging performance of the baery! EV
charger use the opmized calculaon to control the tolerance in the range of +—0.01V!
“Fast charging” select this mode to finish charging process earlier. Principle: When the current
down to 1/5 of the current you set during the CV term, it will stop the process and eliminate
the forcible requirement of the balance precision. (Whether it is been connected to the
balance port), the charging capacity may be a bit smaller than normal charging but the
process me will be reduced.
“Storage mode” this is for charging or discharging Lithium baery not to be used for the me
being. In order to reduce the wastage, you can select this mode to remain the power to 40%
to store. The final voltage are different from the type of the baery, Lilo:3.75V、liPo:3.85V、
LiFe:3.3V.This is an intellecve program, if the voltage of baery at its inial stage is over the
voltage level to storage, the program will start to discharge, and if it is lower, the program
will start to charge automacally. In order to ensure each baery pack meets the demand,
the individual plug of the baery pack should be connected to the individual port of charger.
PROGRAM SELECT
Li** BATT
LiPo CHARGE
2.0A 11.1V(3S)
LiPo BALANCE
2.0A 11.1V(3S)
LiPo FAST CHG
2.0A 11.1V(3S)
LiPo STORAGE
1.0A 11.1V(3S)
LiPo DISCHARGE
1.0A 11.1V(3S)
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Dec.
Inc.
Inc.
Dec.
