
INTRODUCTION AND SPECIFICATIONS
Installing the Module into the LDC-3916 or LDC-3908 Mainframe
2 LDC-3916558
CHAPTER 1
TEC module voltage measurement, selection of thermistor current range, and
control loop gain adjustment from 1 to 127.
Initial Inspection
When you receive your LDC-3916558 3-Amp Temperature Control Module, check
for shipping damage immediately. Verify that the module has an ESD protective
hood on the 15-pin D-sub and that it is enclosed in an ESD safe handling bag.
Remember before handling the module to follow proper ESD safe handling
procedures.
Installing the Module into the LDC-3916 or LDC-3908
Mainframe
If you are receiving this new module without an LDC-3916 or LDC-3908
Mainframe for installation into a previously purchased mainframe, follow the
instructions below. If your system was configured at the factory with your desired
modules, skip this section.
Static discharge can damage your new Temperature Controller Module. Be certain you
use proper grounding procedures before you unpack and install your module(s) into the
LDC-3916 or LDC-3908 Mainframe.
Inspect the module for any visible shipping damage that may have occurred before
inserting the module into the mainframe. Pay special attention to the copper shielding
material on the back edge of the module.
Be sure that the LDC-3916 or LDC-3908 Mainframe power is off before inserting or
removing any module.
Unwrap the module from the anti-static bag it was packaged in.
Make sure the instrument the module is going into, either the LDC-3916 or the
LDC-3908, is switched off. Insert the module into the desired slot from the rear.
Each module is supported by two plastic card guides inside of the mainframe.
Insert the module, 40-pin connector first, by lining up the edges of the module
frame with the appropriate card guides (one on top and one on the bottom).
Carefully slide the module into the mainframe slot until the connector is seated.
You will have to push a little harder to seat the module. The rear panel of the
module should be flush with the mainframe when properly inserted. Fasten the
module to the mainframe with two screws located at the top and bottom of the
module rear panel.