NOVA 2000 Operating manual - English
4
GENERAL INTRODUCTION
The NOVA 2000 key-cutting machine has been designed according to the specifications of the Machine
Directives.Fromthedesignstagerisksfor the operator have been eliminatedinallareas: transport,key-
cutting, regulation and maintenance.
Other risks have been eliminated by the use of protective devices for the operator.
The protective devices used are designed not to provoke further risks and, above all, they cannot be
ignored unless deliberately cut out. They do not hinder visibility of the work area.
A special adhesive label is attached to the machine warning the operator to use goggles during the
cutting operations, and this is strongly recommended in this manual.
The material used in the manufacture of this machine and the components employed during use of the
machine are not dangerous and their use complies with standards.
Use
The NOVA 2000 must be installed and used in the way laid down by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this
manual, the customer will forego any rights he may have over Ilco-Orion. Furthermore, unforeseen
danger to the operator or any third parties may arise from incorrect use of the machine.
Negligence in the use of the machine or failure on the part of the operator to observe the instructions
given in this manual are not covered by the guarantee and the manufacturer declines all responsibility
in such cases.
It is therefore indispensable to read the operating manual carefully in order to make the best use
of the NOVA 2000 and benefit from its potential.
Further Risks
There are no further risks arising from the use of the machine.
Protection and safety precautions for the operator
The NOVA 2000 key-cutting machine is built entirely to standards. The operations for which it has been
designed are easily carried out at no risk to the operator.
The adoption of general safety precautions (wearing protective goggles) and observation of the
instructions provided by the manufacturer in this manual eliminate all human error, unless deliberate.
The NOVA 2000 key-cutting machine is designed with features which make it completely safe in all its
parts.
• Power supply
The key-cutting machine is powered directly by electricity supplied through a safety device
(standard
with 230V key-cutting machines, on request for other voltages).
• Start-up
The machine is started up
:
- by means of the main switch on the safety device (standard with 230V key-cutting machines);
- by means of the master switch.
•Operation
The machine is started up by means of a motor switch.
• Illumination
The work area is illuminated by a lamp which operates when the machine is switched on with the master
switch.
• Maintenance
The operations to regulate, service, repair and clean the machine have been devised in the simplest
and safest way possible. There is no danger of removable parts being re-placed wrongly or unsafely.
• Machine identification
The NOVA 2000 key-cutting machine is provided with an identification label which shows the serial
number (fig. 2).
Fig. 2
(*) see chap. 9 DISPOSING OF MACHINE, page 19.
