Rev. 02 | English | 4
Mode: Fixed Authorization (Private-mode)
In this mode, a specific transponder medium is pre-set to
operate the lock. This mode is suitable for user groups where
user permissions should not change permanently, such as in an
office cabinet. The lock can be opened using the stored
transponder medium. Unregistered transponder media will be
rejected by the lock. To open, the transponder medium is held
in the middle in front of the lock. To close, the knob is turned
back (counterclockwise) until the bolt engages.
Mode: Multiuser Authorization (Multiuser-mode)
This mode is suitable for changing user groups where the
compartment is only temporarily or once used, such as in a
sports facility. Transponder media are valid for a single locking
operation and are deleted by the lock when the compartment
is reopened, allowing a new transponder medium to be used.
The bolt remains open until a new transponder medium
relocks the lock. Before locking, the door must be closed and
the knob turned counterclockwise. To close, the transponder
medium is held in the middle in front of the lock. The LED
starts blinking. The lock can only be opened with the same
transponder medium.
Master-card
The master-card can open the lock regardless of the set mode
(emergency opening). In Multiuser-mode, the transponder
medium used for closing is deleted by the lock. The master-
card also has the authorization to add and remove user-cards
in private-mode, as well as to delete all enrolled cards.
Manager-card (Private-mode)
The manager-card can open the lock regardless of the set
mode (emergency opening).
Mode-card
The mode-card can be used to switch between modes. The
mode-card is held in the middle in front of the knob. The
mode changes automatically.
LED Locking Indicator
When the lock is locked, the green LED flashes briefly every
three seconds.
Battery Warning
If the battery voltage drops below a certain level, the LED
briefly lights up when a transponder is presented. If the
voltage falls into the critical range, the lock can no longer be
operated.
Operation Configuration
Please carefully note the following instructions before
starting the configuration:
The first card held in front of the lock during initialization
is saved as the master-card.
Mode switching and resetting using the reset-PIN can only
be done when the lock is disassembled.
1 Enrolling Cards
a) Master-card
1. Insert the battery into the lock (page 6, "Battery
Replacement").
2. Hold the card to be enrolled in the middle in front of
the knob.
3. A beep sound confirms the successful process.
Note: A maximum of 3 master-cards can be enrolled.
b) Manager-card (Private-mode)
1. Hold the master-card in front of the knob four
times in a row. The green LED starts blinking.
2. Hold the card to be enrolled as a manager-card in
the middle in front of the knob.
3. A beep sound confirms the successful process.
4. Wait until the LED stops blinking.
Note: A maximum of 2 manager-cards can be enrolled.
c) User-card (Private-mode)
1. Hold the master-card in front of the knob three
times in a row. The green LED starts blinking.
2. Hold the card to be enrolled as a user-card in the
middle in front of the knob.
3. A beep sound confirms the successful process.
4. Wait until the LED stops blinking.
Note: A maximum of 6 user-cards can be enrolled.
2 Card Deletion
a) Per Reset-PIN
1. Briefly press the reset-PIN into the reset-hole on
the back of the lock.
2. Two beep sounds confirm the successful process.
3. Remove the reset-PIN.
Note: The reset button can only be accessed when the lock
is disassembled.
ID LOCK 6000 | 07-2023
During this process, all cards will be deleted from the
lock. Cards cannot be deleted individually. The set
mode remains active.
