Ideal Boilers VOGUE MAX COMBI 32 Manual de usuario

USER GUIDE

VOGUE MAX COMBI 26 32 40

When replacing any part on this appliance, use only spare parts that you can be

assured conform to the safety and performance speciﬁcation that we require.

Do not use reconditioned or copy parts that have

not been clearly authorised by Ideal Boilers.

July 2018 UIN 219004 A02

26 G.C. Appliance No. 47-349-59

32 G.C. Appliance No. 47-349-60

40 G.C. Appliance No. 47-349-61

THE BENCHMARK SERVICE INTERVAL RECORD MUST BE COMPLETED AFTER EACH SERVICE

Ideal Boilers is a member of the Benchmark scheme and fully supports the aims of the programme.

Benchmark has been introduced to improve the standards of installation and commissioning of central

heating systems in the UK and to encourage the regular servicing of all central heating systems to

ensure safety and efciency.

Natural Gas only

VOGUE MAX COMBI

All Gas Safe Register installers carry a Gas Safe Register ID card, and have a registration number. Both should be recorded in the

Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500.

INTRODUCTION

The Vogue is a wall mounted, room sealed, condensing combination boiler, featuring full sequence automatic spark ignition and

fan assisted combustion.

Due to the high efciency of the boiler, condensate is produced from the ue gases and this is drained to a suitable disposal point

through a plastic waste pipe at the base of the boiler. A condensate ‘plume’ will also be visible at the ue terminal.

The Vogue is a combination boiler providing both central heating and instantaneous domestic hot water.

SAFETY

Current Gas Safety (Installation & Use) Regulations or rules in force.

In your own interest, and that of safety, it is the law that this boiler must be installed by a Gas Safe Registered Engineer, in

accordance with the above regulations.

In IE, the installation must be carried out by a Registered Gas Installer (RGII) and installed in accordance with the current edition

of I.S. 813 “Domestic Gas Installations”, the current Building Regulations and reference should be made to the current ETCI

rules for electrical installation.

It is essential that the instructions in this booklet are strictly followed, for safe and economical operation of the boiler.

FOR ANY QUERIES PLEASE RING THE

IDEAL CONSUMER HELPLINE : 01482 498660

NOTE. BOILER RESTART PROCEDURE -

To restart the boiler, press “RESTART” hot key located below the colour screen. The appliance will now repeat

the ignition sequence if a heat demand is present.

IMPORTANT NOTES

• This appliance must not be operated without the casing correctly tted and forming an adequate seal.

• If the boiler is installed in a compartment then the compartment MUST NOT be used for storage purposes.

• If it is known or suspected that a fault exists on the boiler then it MUST NOT BE USED until the fault has been corrected by

a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII).

•Under NO circumstances should any of the sealed components on this appliance be used incorrectly or tampered with.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance

by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

In cases of repeated or continuous shutdown a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII) should

be called to investigate and rectify the condition causing this and carry out an operational test. Only the manufacturer’s original

parts should be used for replacement.

MINIMUM CLEARANCES

Clearances of 165mm above, 100mm below, 2.5mm at the sides. The minimum front clearance when built in to a cupboard is

5mm from the cupboard door but 450mm overall clearance is still required, with the cupboard door open, to allow for servicing.

Bottom clearance

Bottom clearance after installation can be reduced to 5mm.

This must be obtained with an easily removable panel to provide the 100mm clearance required for servicing.

A. Domestic Hot Water / Preheat Status

B. Central Heating Status

C. Burner On indication

Legend

BOILER CONTROLS

0 4

bar

READY

TIMER OR ROOM

THERMOSTAT OFF

60°C oﬀ max

max

boiler

oﬀ

A B

D. Hot Keys

E. Central Heating Temperature Control

F. Domestic Hot Water Temperature

Control / Off Switch

G. Pressure Gauge

H. Hot Key Identication Text

TO LIGHT THE BOILER -

(REFER TO BOILER CONTROLS)

If a programmer is tted refer to separate instructions for the

programmer before continuing.

1. Switch ON electricity to the boiler and check that all

external controls, e.g. programmer and room thermostat,

are ON.

2. Set the Domestic Hot Water temperature control (F) and

Central Heating temperature control (E) to ‘max’.

The boiler will commence the ignition sequence supplying heat

to the central heating, if required.

Note. In normal operation the boiler colour screen will display

the boiler operation mode.

Boiler frost protection - boiler will re if temperature is less

than 5 degrees C.

During normal operation the burner on indicator (C) will remain

illuminated when the burner is lit.

If the boiler has not lit, after 5 ignition attempts, the following

screen will be displayed.

IGNITION LOCKOUT

Check other gas appliances work

If pre-payment meter check credit

If not, contact gas supplier

Restart boiler.

If fault persists contact installer

01482 498663

EXITRESTART

Restart the boiler and the ignition sequence will be repeated.

OPERATION

Central Heating and Domestic Hot Water required.

The boiler will re and supply heat to the radiators but will give

priority to Domestic Hot Water on demand.

If required the Domestic Hot Water preheat will operate as

described on page 17 MENU OPERATION - Preheat, during

periods when there is no call for CH.

Domestic Hot Water only required.

Either set the Central Heating temperature control knob (E)

to ‘off’ - or,

Set the Central Heating external controls to off.

Only if pre-heat is selected the boiler will re periodically for a

few seconds to maintain the Domestic Hot Water calorier in

a pre-heated condition. The pre-heat will take place only once

in a 30 minute time interval. This may vary considerably due to

the surrounding ambient temperature of the boiler.

The boiler will re whenever there is a demand for Domestic

Hot Water.

The boiler preheat facility can be immobilised, refer to page 20.

This will stop the boiler operating periodically for short periods.

This facility is primarily provided for boiler installations in a

sensitive area (i.e. bedroom etc.).

Note. If the pump and diverter valve have not operated in

the last 24 hours they will run briey to ensure they do not

become seized.

CONTROL OF WATER TEMPERATURE

Domestic Hot Water

The DHW temperature is limited by the boiler controls to 65oC

maximum at low draw-off rate, adjustable via the Domestic Hot

Water temperature control knob (F).

Due to system variations and seasonal temperature uctuations

DHW ow rates/temperature rise will vary, requiring adjustment

at the draw off tap : the lower the rate the higher the

temperature, and vice versa.

Approx. hot water temperatures for the boiler thermostat

settings are:

Domestic Hot Water Knob Setting Flow Temp

Minimum 40ºC

Maximum 65ºC

Central Heating

The boiler controls the central heating radiator temperature

to a maximum of 80oC, adjustable via the CH temperature

control knob (E).

Central Heating Knob Setting Flow Temp

Minimum 30ºC

Maximum 80ºC

WEATHER COMPENSATION

When the Weather Compensation option is fitted to the

system then the Central Heating Temperature Control knob

(E) becomes a method of controlling room temperature. Turn

the knob clockwise to increase room temperature and anti-

clockwise to decrease room temperature. Once the desired

setting has been achieved, leave the knob in this position

and the system will automatically achieve the desired room

temperature for all outside weather conditions.

TO SHUT DOWN THE BOILER

Set the Domestic Hot Water temperature control knob (F) to

‘boiler off’.

TO RESTART THE BOILER

Repeat the procedure detailed in ‘To light the boiler’ (refer to

page 7). Set the Domestic Hot Water temperature control

knob (F) to between 40ºC & 65ºC, refer to colour screen

whilst adjusting.

FROST PROTECTION

If no frost protection is provided and frost is likely during a short

absence from home, leave the heating controls at a reduced

temperature setting. For longer periods, the entire system

should be drained.

If the system includes a frost thermostat then the timer can be

left off. The mains supply should be left switched ON, with the

boiler thermostat left in the normal running position.

BOILER OVERHEAT PROTECTION

The boiler controls will shut down the boiler in the event of

overheating. Should this occur, the following display will appear;

OVERHEAT LOCKOUT

With boiler oﬀ & system cold ﬁll System to 1.0 Bar

Bleed radiators and reﬁll system to 1.0 Bar

Check radiator valves are open.

Restart boiler.

If fault persists contact Installer

01482498660

EXITRESTART

LOSS OF SYSTEM WATER PRESSURE

The pressure gauge (G) indicates the central heating system pressure. If the pressure is seen to fall below the original installation

pressure of 1.0 & 1.5 bar then conduct the re-pressurising procedure as shown below. If unable to do so or if the pressure continues

to drop a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII) should be consulted.

THE BOILER WILL NOT OPERATE IF THE PRESSURE HAS REDUCED TO LESS THAN 0.5 BAR UNDER THIS CONDITION.

In this case the following display will appear:

EXITPICTURE

LOW WATER PRESSURE

With boiler oﬀ & system cold

ﬁll system to between 1.0 & 1.5 bar

(Press PICTURE to see how)

Bleed radiators then reﬁll

If fault persists contact Ideal (01482 498660)

If pressure loss re-occurs contact installer

EXIT

Under boiler,

turn blue & black

handles in line with

pipes to ﬁll

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Caldera de Ideal Boilers

Ideal Boilers

Ideal Boilers Mexico Slimline RS 3/40 Guía del usuario

Ideal Boilers

Ideal Boilers British Gas 4100 RD2 Hoja de datos

Ideal Boilers

Ideal Boilers Logic Combi C Manual de usuario

Ideal Boilers

Ideal Boilers Harrier GTE 5 Manual de usuario

Ideal Boilers

Ideal Boilers Classic Slimline Manual de usuario

Ideal Boilers

Ideal Boilers minimiser SE 40 Manual de usuario

Ideal Boilers

Ideal Boilers mini HE C24 Manual de usuario

Ideal Boilers

Ideal Boilers Concord CXSD 40/H Guía del usuario

Ideal Boilers

Ideal Boilers i-mini 24 Manual de usuario

Ideal Boilers

Ideal Boilers Buccaneer GTE 4 Manual de usuario

Ideal Boilers

Ideal Boilers 30 RD1 Guía del usuario

Ideal Boilers

Ideal Boilers Mexico Super RS 3/60P Hoja de datos

Ideal Boilers

Ideal Boilers Classic m3050 Manual de usuario

Ideal Boilers

Ideal Boilers Harrier GT Guía

Ideal Boilers

Ideal Boilers Mexico Super FF4100 Manual de usuario

Ideal Boilers

Ideal Boilers Mexico Super CF 3/60P Hoja de datos

Ideal Boilers

Ideal Boilers excel HE C24 Manual de usuario

Ideal Boilers

Ideal Boilers Classic FF230 Manual de usuario

Ideal Boilers

Ideal Boilers Esprit 2 Guía del usuario

Ideal Boilers

Ideal Boilers Response 80 Manual de usuario

Ideal Boilers

Ideal Boilers Imax xtra F320 Manual de usuario

Ideal Boilers

Ideal Boilers icos system m3080 Manual de usuario

Ideal Boilers

Ideal Boilers Classic LXFF 230 Hoja de datos

Ideal Boilers

Ideal Boilers British Gas 440 RD2 Guía del usuario

Manuales populares de Caldera de otras marcas

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manual de usuario

Radijator

Radijator BIO max 23.1 Manual de usuario

Brunner

Brunner BSV 20 Manual de usuario

Buderus

Buderus Logamax GB062-24 KDE H V2 Manual de usuario

Potterton

Potterton 50e Hoja de datos

UTICA BOILERS

UTICA BOILERS TriFire Manual de usuario

Joannes

Joannes LADY Series Manual

ECR International

ECR International UB90-125 Manual de instrucciones

Froling

Froling FHG Turbo 3000 Manual de usuario

Froling

Froling P4 Pellet 8 - 105 Manual de usuario

U.S. Boiler Company

U.S. Boiler Company K2 Manual de usuario

Henrad

Henrad C95 FF Manual de usuario

NeOvo

NeOvo EcoNox EF 36 Manual de usuario

Potterton

Potterton PROMAX SL 12 Manual de usuario

Eco Hometec

Eco Hometec EC 25 COMPACT Manual de usuario

Viessmann

Viessmann VITODENS 200 Guía

Baxi

Baxi Prime 1.24 Manual de usuario

REXNOVA

REXNOVA ISA 20 BITHERMAL Manual de usuario