ICW T2 Manual de usuario

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario

T2 Wall Mount Installation

Wall mount

1 Locate a stud in the wall you

intend to mount your arm

on. Mark the top hole, drill 11/64

pilot hole and insert a provided

#14 screw and tighten slightly.

Using a level, mark the two lower

holes and drill pilot holes, insert

the last two #14 screws and,

with the mount level, tighten all

screws securely.

Note: ICW supplies #14 wood screws. If install-

ing into metal studs you will need to replace with

proper metal stud fasteners. All hardware used to

secure wall mount must have a properly counter-

sunk head.

Back arm

Front arm

Monitor mount

Do not disassemble these bearing packs.

2 Remove the arm assembly from the box and,

using the provided 5mm hex key, separate the

two arms and detach the monitor mount. Keep track

of all parts.

3 Feed your computer monitor cords and any

other cords down through the opening in the

wall mount – passing through the bearing.

4 Feed all cords up through the back arm and

bolt back arm to the wall mount. Feed all

cords from the back arm through the front arm and

bolt front arm to the back arm. Cords should pass

through the center of the bearing.

Note: When running your cords through the

arm, keep them all to one side of the bolts at the

arm joints.

Note: When measuring for the length of the

cords, be sure to allow enough extra cord to ac-

commodate the tilt and rotation of the monitor.

5 Pass the cords through the slots in the monitor

mount baseplate and re-attach the monitor

mount to the front arm.

Slots

6 Use the provided 1/4" wrench to open the

plastic slider mount and insert the ball on the

 VESAplate.Tightenrmly.

7 Attach the optional keyboard tray to the moni-

tor mount using the 2 provided 1/4-20 screws.

8 Secure the monitor to the

VESA plate using the 4

provided 4mm screws.

9 Attach the optional large handle to the end of

the slider by screwing together the two halves.

Handles

10 Use the slider handle to adjust the monitor

up and down.

Slider

Handle

11 Use the push buttons to pivot the monitor

forward and back.

Buttons

T2 Wall Mount Rev. 6/13/07 dw