ICP DAS USA SG-3011 Manual de usuario

Ver1.0，07/01/2005，～1～

SG-3011 Isolated Thermocouple Input Module

User’s Manual

Introduction

The SG-3011 is a thermocouple input signal conditioner. SG-3011 uses

microprocessor-controlled high-resolution 24-bit dual-slope,integrating A/D

converter to acquire thermocouple signal and cold junction compensation input.

Temperature measurement is handled by thermocouple linearization and cold

junction compensation function. The supported thermocouple types are J, K,

T, E, R, S, B, N, C, L, M,L2(DIN 43710).

The SG-3011 features optical isolation technique providing 3000Vdc isolation.

The power supply that drives the module`s input and output circuitry is

internally isolated,enabling SG-3011 to offer true channel - to - channel

isolation.

It’s easy to mount the SG-3011 on a standard DIN rail and can operate in

environment with wide temperature range.

Specifications

Thermocouple Type:

Thermocouple

Type Temperature

Range ℃

Type J -40 ~ +760

Type K 0 ~ +1000

Type T -100 ~ +400

Type E 0 ~ +1000

Type R +500 ~ +1750

Type S +500 ~ +1750

Type B +500 ~ +1800

Type N -100 ~ +1300

Type C 0 ~ +2000

Type L -200 ~ +800

Type M -200 ~ +100

Type L2 (DIN 43710) -200 ~ +900

Voltage Output:

Unipolar: 0~10V

Output impedance: <50Ω

Current Output:

Current: 0~20mA

Current load resistor:0~450Ω(Source)

General

Three-way isolation: 1000 Vdc

Overload protection: 240 Vrms

CJC offset adjustable

Open thermocouple detection

Accuracy: ±0.2% of full range

Operating temperature range:-25°C～75°C

Storage temperature range:-30°C～85°C

Supply Voltage

Input range: 10～30 Vdc

Configuration

The terminal wiring for the SG-3011 is shown in Figure A. The SG-3011 uses a power input

range of 10~30Vdc.

Figures D and E show the switch positions used to configure the input and output range.

The I/O configuration switches are located inside the module and can be accessed by

removing the DIN-rail bracket covers by sliding them in the direction shown in Figure B.

Ver1.0，07/01/2005，～2～

PIN Assignment

Wire Connection

Figure C: Wire Connection

Ver1.0，07/01/2005，～3～

Switch Configuration

SW2

Ver1.0，07/01/2005，～4～

Block Diagram

Dimensions

Technical Service

Please E-mail your problem description to service@icpdas.com if you have any questions.

More detail information :WWW.icpdas.com

Otros manuales de Sistema de E/S de ICP DAS USA

ICP DAS USA

ICP DAS USA CAN-2084C Manual de usuario

ICP DAS USA

ICP DAS USA P8R8-DIO Manual de usuario

ICP DAS USA

ICP DAS USA A-626 Manual de usuario

ICP DAS USA

ICP DAS USA I-8017 Series Manual de usuario

ICP DAS USA

ICP DAS USA ET-2242 Manual de usuario

ICP DAS USA

ICP DAS USA U-7500 Series Manual de usuario

ICP DAS USA

ICP DAS USA I-7065BD Manual de usuario

ICP DAS USA

ICP DAS USA HRT-711 Manual de usuario

ICP DAS USA

ICP DAS USA tM-P8 Manual de usuario

ICP DAS USA

ICP DAS USA ET-2217CI Manual de usuario

ICP DAS USA

ICP DAS USA CAN-2057D Instrucciones de uso

ICP DAS USA

ICP DAS USA ISO-C64 Manual de usuario

ICP DAS USA

ICP DAS USA iDCS-8000 Instrucciones de uso

ICP DAS USA

ICP DAS USA I-3591 Manual de usuario

ICP DAS USA

ICP DAS USA ECAT-2000 Series Manual de usuario

ICP DAS USA

ICP DAS USA CAN-2054C Manual de usuario

ICP DAS USA

ICP DAS USA tM-P8 Manual de usuario

ICP DAS USA

ICP DAS USA CAN-2015C Manual de usuario

ICP DAS USA

ICP DAS USA I-7018 CR Manual de usuario

ICP DAS USA

ICP DAS USA I-7052 Manual de usuario

ICP DAS USA

ICP DAS USA A-812PG Instrucciones de uso

ICP DAS USA

ICP DAS USA I-7000 Series Manual de usuario

ICP DAS USA

ICP DAS USA tM-AD2 Manual de usuario

ICP DAS USA

ICP DAS USA M-7018-16 Manual de usuario

Manuales populares de Sistema de E/S de otras marcas

WAGO

WAGO 750-344 Manual de usuario

Teknim

Teknim TWM-1887 Manual de instrucciones

Intelligent Appliance

Intelligent Appliance IA-2662-E Manual de usuario

BERGHOF

BERGHOF ECC DIO 16/16 Manual de instrucciones

Advantech

Advantech PCM-27J3AU Manual de instalación y operación

Festo

Festo CP-E08-M12-CL Manual de usuario

Measurement Computing

Measurement Computing PCI-DAS64/M1/16 Manual de usuario

Hitachi

Hitachi HX-RIO3 Series Manual de usuario

NUUO

NUUO SCB-A08 Manual de usuario

M-system

M-system R3Y-RS8 Manual de usuario

jablotron

jablotron JB-110N Manual de usuario

Omron

Omron SYSMAC C200H Manual de usuario

DOLD

DOLD SAFEMASTER M Manual de usuario

ABB

ABB OPT-MF-001 Manual de usuario

Omron

Omron SYSMAC C2000H Manual de usuario

Helmholz

Helmholz TB20 Manual de usuario

Automationdirect.com

Automationdirect.com DL305 Manual de usuario

WAGO

WAGO I/O-SYSTEM 750 Manual de usuario