Icom IC-F61 Manual de usuario

INSTRUCTION MANUAL

UHF TRANSCEIVER

iF61

VHF TRANSCEIVER

iF51

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page A (1,1)

FOREWORD

READ ALL INSTRUCTIONS carefully and completely before

using the transceiver.

SAVE THIS INSTRUCTION MANUAL— This instruction

manual contains important operating instructions for the IC-F51

VHF

TRANSCEIVER

and IC-F61

UHF TRANSCEIVER

EXPLICIT DEFINITIONS

OPERATING NOTES

• When transmitting with a portable radio, hold the radio in a vertical

position with its microphone 5 to 10 centimeters away from your

mouth. Keep the antenna at least 2.5 centimeters from your head

and body.

• If you wear a portable two-way radio on your body, ensure that the

antenna is at least 2.5 centimeters from your body when transmit-

ting.

WORD DEFINITION

RWARNING Personal injury, fire hazard or electric shock

may occur.

NOTE If disregarded, inconvenience only. No risk

of personal injury, fire or electric shock.

CAUTION Equipment damage may occur.

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page i (1,1)

PRECAUTION

RWARNING! NEVER hold the transceiver so that the antenna

is very close to, or touching exposed parts of the body, especially

the face or eyes, while transmitting. The transceiver will perform

best if the microphone is 5 to 10 cm away from the lips and the

transceiver is vertical.

RWARNING! NEVER operate the transceiver with a headset

or other audio accessories at high volume levels.

CAUTION! NEVER short the terminals of the battery pack.

NEVER connect the transceiver to a power source other than the

BP-226 or BP-227. Such a connection will ruin the transceiver.

DO NOT push the PTT when not actually desiring to transmit.

AVOID using or placing the transceiver in direct sunlight or in

areas with temperatures below –25°C or above +55°C.

The basic operations, transmission and reception of the transceiver,

are guaranteed within the specified operating temperature range

(depending on version). However, the LCD display may be operate

correctly, or show an indication in the case of long hours of opera-

tion, or after being placed in extremely cold areas.

DO NOT modify the transceiver for any reason.

MAKE SURE the ﬂexible antenna and battery pack are securely

attached to the transceiver, and that the antenna and battery pack

are dry before attachment. Exposing the inside of the transceiver

to water will result in serious damage to the transceiver.

The use of non-Icom battery packs/chargers may impair transceiver

performance and invalidate the warranty.

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page ii (1,1)

TABLE OF CONTENTS

iii

FOREWORD ……………………………………………………………… i

EXPLICIT DEFINITIONS ………………………………………………… i

OPERATING NOTES ……………………………………………………… i

PRECAUTION …………………………………………………………… ii

TABLE OF CONTENTS ………………………………………………… iii

SUPPLIED ACCESSORIES …………………………………………… iv

1 ACCESSORIES ……………………………………………………… 1–2

‘Accessory attachments……………………………………………… 1

2 PANEL DESCRIPTION …………………………………………… 3–11

‘Front, top and side panels ………………………………………… 3

‘Function display ……………………………………………………… 6

‘Programmable function keys ……………………………………… 7

3 CONVENTIONAL OPERATION ………………………………… 12–18

‘Turning power ON ………………………………………………… 12

‘Channel selection ………………………………………………… 12

‘Call procedure ……………………………………………………… 13

‘ Receiving and transmitting ……………………………………… 14

‘ Scrambler function ………………………………………………… 17

‘ User set mode ……………………………………………………… 18

4 BIIS OPERATION ………………………………………………… 19–34

‘Default setting ……………………………………………………… 19

‘Receiving a call …………………………………………………… 20

‘Transmitting a call ………………………………………………… 23

‘Receiving a message ……………………………………………… 26

‘Transmitting a status ……………………………………………… 29

‘Transmitting an SDM ……………………………………………… 30

‘Position data transmission ………………………………………… 31

‘Printer connection ………………………………………………… 32

‘PC connection ……………………………………………………… 32

‘Digital ANI …………………………………………………………… 32

‘Auto emergency transmission …………………………………… 33

‘Stun function………………………………………………………… 33

‘BIIS indication ……………………………………………………… 34

‘Priority A channel selection ……………………………………… 34

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page iii (1,1)

5 BATTERY CHARGING ………………………………………… 35–44

‘Battery charging …………………………………………………… 35

‘Caution ……………………………………………………………… 36

‘Optional battery chargers ………………………………………… 37

‘Optional battery case ……………………………………………… 43

6 SPEAKER-MICROPHONE ……………………………………… 45–46

‘Optional HM-138 description ……………………………………… 45

‘Attachment ………………………………………………………… 46

7 OPTIONS ………………………………………………………… 47–48

8 DOC………………………………………………………………… 49–50

SUPPLIED ACCESSORIES

The following accessories are supplied: Qty.

• Flexible antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

• Battery pack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

• Jack cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 set

• Belt clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 set

• Function name stickers* (KEY-STICKER) . . . . . . . . . . . . . . . . . .1

*There are no names on the programmable function keys since the

functions can be freely assigned to [P0] to [P3], [Red], [ ] and

[ ] keys.

Attach the supplied function name stickers above the appropriate

keys for easy recognition of that key’s assigned function.

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page iv (1,1)

1ACCESSORIES

■Accessory attachments

DFlexible antenna

Connect the supplied ﬂexible antenna

to the antenna connector.

CAUTION!

• NEVER HOLD by the antenna

when carrying the transceiver.

• Transmitting without an antenna

may damage the transceiver.

ïBattery pack

To attach the battery pack:

Slide the battery pack on the back of the transceiver in the direc-

tion of the arrow (q), then lock it with the battery release button.

• Slide the battery pack until the battery release button makes a ‘click’

sound.

To release the battery pack:

Push the battery release button in the direction of the arrow (w) as

shown below. The battery pack is then released.

Battery pack

Battery release button

NEVER release or at-

tach the battery pack

when the transceiver

is wet or soiled. This

may result in water or

dust getting into the

transceiver/battery

pack and may dam-

age the transceiver.

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page 1 (1,1)

ACCESSORIES

ïJack cover

Attach the jack cover when the optional speaker-microphone is not

used.

DBelt clip

Attach the belt clip to the back of the transceiver with the supplied

screws.

Supplied screws

To attach the jack cover:

qInsert the jack cover into the

[SP MIC] connector.

wTighten the screw.

To detach the jack cover:

eUnscrew the screw with a

phillips screwdriver.

rDetach the jack cover for the

speaker-microphone connec-

tion.

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page 2 (1,1)

2PANEL DESCRIPTION

■Front, top and side panels

NOTE: If the speaker netting (for dust prooﬁng) becomes wet,

dry it with a hair drier (cool mode) etc. before operating the

transceiver. Otherwise the audio may be difﬁcult to hear for

loss of the sound pressure.

uMicrophone

Function display

(p. 6)

Speaker

(See the following

NOTE.)

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page 3 (1,1)

PANEL DESCRIPTION

qVOLUME CONTROL [VOL]

Turns power ON and adjusts the audio level.

wRED BUTTON

The desired function can be assigned by your dealer.

eANTENNA CONNECTOR

Connects the supplied antenna.

rSPEAKER-MICROPHONE CONNECTOR [SP MIC]

Connects the optional speaker-microphone. (p. 46)

tDEALER-PROGRAMMABLE KEYS [P0] to [P3]

The desired functions can be assigned independently by your

dealer.

yCH UP AND DOWN KEYS [ ]/[ ]

➥During standby condition, push to select an operating channel.

➥After pushing [TX Code CH Select], push to select a TX code

channel.

➥After pushing [DTMF Autodial], push to select a DTMF channel.

➥After pushing and holding [Scan A Start/Stop]/[Scan B

Start/Stop], push to select a scan group.

➥After pushing [Digital], push to select a BIIS code, status num-

ber or SDM.

*Desired functions can be assigned independently by your dealer.

☞Continue to the next page.

[SP MIC] jack cover

NOTE: KEEP the [SP MIC]

jack cover attached to the

transceiver when the speaker-

microphone is not used.

(See p. 2 for details)

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page 4 (1,1)

2PANEL DESCRIPTION

■Front, top and side panels (Continued)

uTRANSMIT/BUSY INDICATOR

Lights red while transmitting; lights green while receiving a sig-

nal, or when the squelch is open.

iPTT SWITCH [PTT]

Push and hold to transmit; release to receive.

IC-F51_F61 BIIS-3.qxd 06.3.24 1:45 PM Page 5 (1,1)

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Transceptor de Icom

Manuales populares de Transceptor de otras marcas

Yaesu

Yaesu FT-7B Manual de usuario

Kenwood

Kenwood ProTalk TK-3201 Manual de usuario

Texas Instruments

Texas Instruments TLK10232 Manual de usuario

Mizuho

Mizuho MX-2 Guía del producto

Kenwood

Kenwood TK-3180 Manual de operación y mantenimiento

Blitz

Blitz MJ-398U Manual de usuario

Utilicom

Utilicom LongRanger 2050 Manual de usuario

Standart

Standart HX290UKA Manual de usuario

Altronix

Altronix Pace1PTM Manual de usuario

Kirisun

Kirisun PT2208 Manual de usuario

ELECRAFT

ELECRAFT KX2 Manual de usuario

Zodiac

Zodiac K3 Manual de usuario

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Manual de usuario

Kenwood

Kenwood TK-2217 Manual de usuario

Siemens

Siemens PSO 4000 Manual de usuario

Kenwood

Kenwood TS-590SG Manual de usuario

Midland

Midland G8E-BT Manual

ComNav

ComNav Mariner X2 Manual de usuario