iCES ICR-240 Manual de usuario
Top view
Back view
Front view
CONTROLS AND INDICATORS
1. SNOOZE / SLEEP / DIM utto
2. ON / OFF / NAP utto
3. P- utto
4. ALARM / VOL – utto
5. HOUR / TUNING – utto
6. TIME / PRESET utto
7. P+ utto
8. ALARM / VOL + utto
9. MIN / TUNING + utto
10. Battery compartment
11. FM antenna
12. AC plug
A. Time and radio frequency display
B. Alarm 2 buzzer
C. Alarm 2 radio indicator
D. FM
E. Alarm 1 buzzer
F. Alarm 1 radio indicator
PREPARATION FOR USE
This clock radio includes a battery backup system that will maintain the time and
alarm settings during a temporary power interruption. Isert two AAA size atteries
correctly by matching the polarity (+/-) markings in the battery compartment (10). If
you experience a power failure while batteries are istalled, the displa will tur off
but the clock will continue to run and maintain your alarm settings. Please replace all
batteries at the same time with only new batteries.
The clock radio has slip proof silicon feet. Place the clock radio only on protected
furniture.
Plug AC plug (12) into 230vac electrical outlet.
Unwind the FM antenna (11) on the back of the clock radio. Extend and reposition
the antenna for best radio reception.
ALARM CLOCK OPERATION
SETTING THE TIME
Note:
You cannot set any function when the clock display is blinking after plug in, press
the TIME/PRESET to stop blink and start setting.
The time can only be set when the radio is turned off. Press the ON / OFF / NAP
button (2) to turn radio on or off.
When the clock display is blinking, you cannot power on radio by the ON / OFF /
NAP utto .
1. Press ad hold dow TIME / PRESET utto for approiatel seods
until the display flashes.
2. Press HOUR / TUNING – utto repeatedly to change the hour setting.
3. Press MIN / TUNING + utto repeatedly to change the minute setting.
4. Press TIME / PRESET utto to ofir at the tie ad the displa will stop
flashing.
SETTING THE ALARM TIME
This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the buzzer
or wake up to radio.
Note: The alar tie a ol e set whe the radio is tured off. Press the ON /
OFF / NAP utto to tur radio on or off.
1. For setting alarm time 1 with buzzer, press ALARM / VOL – button (4) and
indicator (E) will flash. For settig alar tie with radio, press ALARM /
VOL – utto 4) twice and indicator (F) will flash.
2. When the digits are flashing, press HOUR / TUNING – utto repeatedly to
change the hour setting. Press MIN / TUNING + utto repeatedly to change
the minute setting.
3. Press ALARM / VOL – button (4) to confirm.
4. To cancel alarm, press ALARM 1 / VOL – button (4) three times when the
current time is showing. The alarm indicators will be off.
5. When the alarm sounds, press any button to tur off alar or press SNOOZE /
SLEEP / DIM button (1) to enter snooze mode. or will blink during
snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does not cut
the radio sound. If alarm waken up by radio, volume control for radio is not
available.
6. Follow the sae istrutios for alar with ALARM / VOL + utto (8).
Note:
You must make the time and alarm time adjustments while the display is flashing.
The display will stop flashing after approximately 10 seconds if adjustments are
not made.
If two alarms are set together, for example alarm1 set to buzzer alarm and alarm2
set to radio alarm, when buzzer is activated by alarm1 and radio is activated by
alarm2, the previous alarm does not stop automatically and has both buzzer and
radio sound together.
RADIO
General Operations
1. Press the ON/OFF/NAP utto to tur radio o ad off.
2. For manual tuning, press HOUR / TUNING – utto or MIN / TUNING
+ utto for increments of 0.1mHz.
3. For automatic tuning, press and hold down HOUR / TUNING – utto or
MIN / TUNING + utto for approximately 3 seconds. Depress the button
and the radio will start to scan for the next available station.
4. Press ALARM / VOL – utto or ALARM / VOL +utto to adjust
volume level. The display changes to show the volume level indication (00 to 14)
during the volume adjustments, then changes back to the radio station frequency
and then the current time.
5. Press HOUR / TUNING – utto or MIN / TUNING + utto to show the
radio station frequency.
Pre-set Station Memory
1. The radio can store up to 20 FM stations.
2. To store a station in memory, tune to the desired radio station. Press and hold
dow TIME/PRESET utto for approiatel seods ad P o the
displa will flash. Press P+ utto or P- utton (3) to the desired station
eor P to P. Press TIME/PRESET utto oe to ofir.
3. Repeat the above steps for up to 20 stations.
4. To reall the statio, press P+ utto or P- utto util desired statio
is reached.
Sleep mode
1. Whe the radio is o, press SNOOZE / SLEEP / DIM button (1) to enter sleep
ode. OFF will e displaed. Press SNOOZE / SLEEP / DIM button (1)
repeatedl for the duratio of the SLEEP tie. The rage of SLEEP tie is
minutes to 10 minutes, as displayed on the screen.
NAP
Set the desired NAP time and the radio will turn on automatically after the preset
time.
1. When the radio is off, press and hold ON / OFF / NAP utto for
approximate 4 seconds and the display and FM indicator (D) will flash.
2. Press P+ utto or P- utto to set the desired ap tie , ,
or 120 mins)
3. Press ON / OFF / NAP utto to ofir.
DIMMER
Whe the radio is off ad the urret tie showig, press SNOOZE / SLEEP / DIM
button (1) to select the brightness of the display for high or low.
Service and support
For information: http://www.ices-electronics.com/
ICES offers service and warranty in accordance to European law, which means that in
case of repair (both during and after the warranty period), you should contact your
local dealer.
Please note: It is not possible to send products directly to ICES for repair.
Important note: If this unit will be opened, or accessed in any way by a non-official
service center, the warranty expires immediately.
Products with the CE marking comply with the EMC Directive
(2004/108/EC) and the Low Voltage Directive (2006/95/EC) issued by
the Commission of the European Community.
The declaration of conformity may be consulted at www.ices-electronics.com
This symbol indicates that the relevant electrical product or battery
should not be disposed of as general household waste in Europe.
To ensure the correct waste treatment of the product and battery,
please dispose them in accordance to any applicable local laws of
requirement for disposal of electrical equipment or batteries. In so
doing, you will help to conserve natural resources and improve
standards of environmental protection in treatment and disposal of
electrical waste (Waste Electrical and Electronic Equipment Directive).
®All rights reserved
Bovenaanzicht
Achteraanzicht
Vooraanzicht
BEDIENINGSORGANEN EN INDICATIELAMPJES
1. SLUIMER-/SLAAP-/DIM-toets
2. AAN/UIT/DUTJE-toets
3. P- toets
4. WEKKER /VOL – toets
5. UREN/AFSTEMMEN – toets
6. TIJD/VOORKEUZE-toets
7. P+ toets
8. WEKKER /VOL + toets
9. MIN/AFSTEMMEN + toets
10. batterijvak
11. FM-antenne
12. Netstekker
A. Scherm voor tijd en radiofrequentie
B. Wekker 2 zoemer
C. Wekker 2 radio-indicatielampje
D. FM
E. Wekker 1 zoemer
F. Wekker 1 radio-indicatielampje
Otros manuales para ICR-240
1
Tabla de contenidos
Idiomas:
Otros manuales de Radio reloj de iCES
