Husqvarna Viking Scandinavia 200 Manual de usuario

User’s Guide

KEEPING THE WORLD SEWING

This houshold sewing machine is designed to comply with IEC/EN 60335-2-28

and UL1594

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic safety precautions should always be

followed, including the following:

Read all instructions before using this household sewing machine.

DANGER - To reduce the risk of electric shock:

• A sewing machine should never be left unattended when plugged in. Always

unplug this sewing machine from the electric outlet immediately after using and

before cleaning.

• Always unplug before relamping. Replace bulb with same type rated 5 Watt.

WARNING - To reduce the risk of burns, ﬁre, electric

shock, or injury to persons:

• Do not allow to be used as a toy. Close attention is necessary when this sewing

machine is used by or near children and inﬁrm persons.

• Use this sewing machine only for its intended use as described in this manual. Use

only attachments recommended by the manufacturer as contained in this manual.

• Never operate this sewing machine if it has a damaged cord or plug, if it is not

working properly, if it has been dropped or damaged, or dropped into water.

Return the sewing machine to the nearest authorized dealer or service center for

examination, repair, electrical or mechanical adjustment.

• Never operate the sewing machine with any air openings blocked. Keep

ventilation openings of the sewing machine and foot controller free from the

accumulation of lint, dust, and loose cloth.

• Keep ﬁngers away from all moving parts. Special care is required around the

sewing machine needle.

• Always use the proper needle plate. The wrong plate can cause the needle to

break.

• Do not use bent needles.

• Do not pull or push fabric while stitching. It may deﬂect the needle causing it to

break.

• Switch the sewing machine off (“0”) when making any adjustment in the needle

area, such as threading needle, changing needle, threading bobbin, or changing

presser foot, etc.

• Always unplug sewing machine from the electrical outlet when removing covers,

lubricating, or when making any other user servicing adjustments mentioned in the

instruction manual.

• Never drop or insert any object into any opening.

• Do not use outdoors.

• Do not operate where aerosol (spray) products are being used or where oxygen is

being administrated.

• To disconnect, turn all controls to the off (“0”) position, then remove plug from

outlet.

• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

SAVE THESE INSTRUCTIONS

Table of Contents

Learn your Scandinavia 200 2

Overview 2

Unpacking 3

Pack Away After Sewing 3

Connecting the Foot Control 4

Connect to the Power Supply 4

Accessory Tray 5

Spool Pins 6

Threading the Upper Thread 7

Threading for Twin Needle 7

Bobbin Winding with the Machine

Threaded 8

Bobbin Winding – Vertical Spool Pin 9

Placing the Bobbin in the Machine 10

Lowering the Feed Teeth 10

Thread Tension 11

Changing the Needle 12

Changing the Presser Foot 12

Functions and Infodisplay 13

The Functions Panel 14

Icons on the InfoDisplay 16

Sewing 17

Stitch Overview 19

Utility Sewing 21

Seam 21

Twenty-ﬁve Needle Positions 22

Gathering 23

Reinforced Straight Stitch 23

Three-Step ZigZag Stitches 24

Seam and Overcast 25

Darning and Mending 26

Blind Hem 27

Hem 28

Buttonholes 29-30

Button 31

Sewing Zippers 32

Decorative Sewing 33

Appliqué 33

Bridging Stitch 34

Decorative Stitches 34

Care of your

Scandinavia 200 35

Trouble Shooting 38

Index 39

Learn your Scandinavia 200

Overview

1Lid

2Thread take-up lever

3Presser foot pressure dial

4Thread guide

5Buttonhole sensor socket

6Light

7Needle bar

8Presser foot

9Free arm

10 Bobbin cover

11 Base plate

12 Drop feed dial

13 Needle plate

14 Presser bar and Presser foot ankle

15 Needle clamp screw

16 Presser foot lifter

17 Thread tension

18 Thread guide for bobbin winding

19 Spool pin

20 Spool holders

21 Recess for additional spool pin

22 Thread cutter for bobbin winding

23 Handwheel

24 Bobbin spindle, Bobbin stop

25 InfoDisplay

26 Function selector buttons

27 Main power switch, Connection to

power supply

28 Stitch panel

Learn your Scandinavia 200

Unpacking

1. Place the machine on the table or

cabinet.

2. The foot control is stored at one of

the side parts of the packing material.

Press the foot control together and

remove it.

3. The machine is delivered with an

accessory bag, dust cover and a foot

control cord.

4. Wipe the machine, particularly

around the needle and needle plate

to remove any soil before sewing.

Packing Away After Sewing

1Unplug the cords from the wall socket

and the machine.

2Wind the cords around your hand

and place the foot control cord in the

foot control storage space and the

main cord in the pocket of the soft

cover. There is also space provided

for the instruction book.

3Check to ensure that all accessories

are in the accessory box. Slide it onto

the machine behind the free arm.

4Lower the presser foot.

5Place the foot control, underside

toward you, on the accessory tray at

the back of the machine. Fold down

the handle and replace the the cover.

Learn your Scandinavia 200

Connecting the Foot Control

Among the accessories you will ﬁnd the

foot control cord and the main cord.

Connecting the foot control cord to

the foot control is only necessary the

very ﬁrst time you are going to use the

machine.

1Take out the foot control cord. Turn

the foot control over. Connect the

cord to the socket inside the space of

the foot control.

2Push ﬁrmly to make sure it is

properly connected.

3Put the cord through the slot on the

right hand side of the foot comtrol.

Connect to the Power Supply

On the underside of the machine you will

ﬁnd information about the power supply

(V) and the frequency (Hz).

Before plugging in the foot control, check

to ensure that it is of type “FR4” (see

underside of foot control).

1Connect the foot control cord to the

front socket on the bottom right side

of the machine.

2Connect the power cord to the rear

socket on the bottom right side of the

machine.

3When you press the power switch to

ON, both the machine and the light

are switched on.

For the USA and Canada

This sewing machine has a polarized

plug (one blade wider than the other). To

reduce the risk of electric shock, this plug

is intended to ﬁt in a polarized outlet only

one way. If the plug does not ﬁt fully in the

outlet, reverse the plug. If it still does not ﬁt,

contact a qualiﬁed electrician to install the

proper outlet. Do not modify the plug in any

way.

Learn your Scandinavia 200

Accessory Box

1Open the accessory box by placing

your ﬁnger in the space on the top

and lift upward.

2Store the presser feet and the bobbins

in the box from the beginning so they

are always easily accessible.

Extended Sewing Surface

1Slide the accessory box onto the

machine to provide a larger ﬂat work

surface.

2Slide the accessory box to the left

when you wish to remove it and use

the free arm.

3To facilitate sewing trouser legs and

sleeve hems use the free arm. The

free arm also allows you to darn

socks (darning foot is an accessory).

4To replace the accessory box, slide it

tight onto the machine.

An extension table is also available as

an accessory to provide an even larger

sewingsurface.

Learn your Scandinavia 200

Spool Pins

The machine has spool pins suitable for

all types of thread. The main spool pin

(a) is adjustable – the thread reels off

the stationary spool. Place the spool so

that the thread reels counter-clockwise.

There are two spool holders on the

spool pin. With narrow thread spools,

the small holder (b) is placed in front

of the thread. If you use large thread

spools, the large holder (c) is placed in

front of the thread.

Slide the correct size spool holder in

place so the ﬂat side is pressed ﬁrmly

against the spool. No space between

spool holder and spool.

There is also a separate spool pin (d)

to be attached onto the machine. The

ﬁngers on the extra spool pin ﬁt into

the two holes to the right of the ﬁxed

spool pin. Push downward to snap in

place.

The large spool holder (c) is placed

under the thread. This spool pin is used

when winding a bobbin from a second

spool of thread or for a second spool

when sewing with a twin needle.

Narrow thread spools

Large thread spools

Learn your Scandinavia 200

Threading the Upper Thread

!Turn off the main switch.

Make sure the presser foot is raised and

the needle is in the up position

1Pull the spool pin out. Place the

thread on the spool pin and the spool

holder on the spool pin as described.

Push the spool pin back in.

2Bring the thread in the direction of

the arrow under the thread guide (a)

and over the thread guide (b).

3Bring the thread down between the

thread tension discs.

4Continue threading by drawing the

thread from the right into the slot on

the take-up lever.

5Thread last guide just above the

needle.

6The needle is threaded from front to

back.

Threading for Twin Needle

!Turn off the main switch.

1Insert a twin needle.

2Use a second thread spool or wind a

bobbin with the thread you are going

to use as the second upper thread.

3LEFT NEEDLE:Thread the machine

and check to ensure that the thread

lies between the inner thread tension

discs, and inside the last thread guide.

Thread the left needle.

4Attach the extra spool pin onto the

machine. Place a spool holder under

the thread.

5Place the bobbin with the second

thread on the spool pin.

6 RIGHT NEEDLE:Thread the machine

as before but this thread should lie

between the outer thread tension

discs, outside the lowest thread guide.

Thread right needle.

The white on the presser foot ankle

makes it easy to see the eye of the

needle.

7Place thread under the presser foot

and into the thread knife where it is

cut.

Learn your Scandinavia 200

Bobbin Winding with the

Machine Threaded

Make sure that the presser foot is

up and the needle is in the highest

position.

Note! Do not use a plastic presser

foot when bobbin winding.

1Place your empty bobbin with the

small mark outwards on the

bobbin spindle on the front of the

machine. Bring the bobbin spindle

down.

2Pull the thread from the needle under

the presser foot and to the right over

the thread guide (c).

Note! We do not recommend winding

specialty threads such as clear nylon

or other stretchy threads through the

needle. Instead see ”Bobbin winding

– vertical spool pin”.

3Start from above and wind a few

turns of thread around the bobbin.

Cut off the thread on the thread knife

(d).

4Press the foot control. When the

bobbin winding is ﬁnished, remove

the bobbin, cut off the thread and

bring the bobbin spindle up.

Tabla de contenidos

Otros manuales de Máquina de coser de Husqvarna Viking

Husqvarna Viking

Husqvarna Viking Scandinavia 400 Manual de usuario

Husqvarna Viking

Husqvarna Viking Oscar Manual de usuario

Husqvarna Viking

Husqvarna Viking Designer Ruby Deluxe Manual de usuario

Husqvarna Viking

Husqvarna Viking Prelude 350 Manual de usuario

Husqvarna Viking

Husqvarna Viking Huskylock s21 Manual de usuario

Husqvarna Viking

Husqvarna Viking Viking E20 Manual de usuario

Husqvarna Viking

Husqvarna Viking Designer I Manual de usuario

Husqvarna Viking

Husqvarna Viking Mega Quilter Manual de usuario

Husqvarna Viking

Husqvarna Viking HUSKYSTAN C10 Manual de usuario

Husqvarna Viking

Husqvarna Viking Lily 550 Manual de usuario

Husqvarna Viking

Husqvarna Viking Viking H Class 100Q Manual de usuario

Husqvarna Viking

Husqvarna Viking Designer Diamond Royale Manual de usuario

Husqvarna Viking

Husqvarna Viking Sapphire 930 Manual de usuario

Husqvarna Viking

Husqvarna Viking Designer Jade 35 Manual de usuario

Husqvarna Viking

Husqvarna Viking Jade 20 Manual de usuario

Husqvarna Viking

Husqvarna Viking Designer topaz 25 Manual de usuario

Husqvarna Viking

Husqvarna Viking 160 Manual de usuario

Husqvarna Viking

Husqvarna Viking Platinum 755 Manual de usuario

Husqvarna Viking

Husqvarna Viking Platinum 755 Manual de usuario

Husqvarna Viking

Husqvarna Viking Viking Royale Manual de usuario

Husqvarna Viking

Husqvarna Viking Huskylock S25 Manual de usuario

Husqvarna Viking

Husqvarna Viking Huskylock 936 Manual de usuario

Husqvarna Viking

Husqvarna Viking Sapphire 960Q Manual de usuario

Husqvarna Viking

Husqvarna Viking Opal 690Q Manual de usuario

Manuales populares de Máquina de coser de otras marcas

Riccar

Riccar RL634DE Manual de usuario

Singer

Singer 2517 Manual de usuario

Pfaff

Pfaff 3307-1 SERIES Manual de usuario

Janome

Janome Quilt Maker Pro 18 VERSA Manual de usuario

Siruba

Siruba C007JP Manual de usuario

Singer

Singer 148-5 Manual de usuario

IKEA

IKEA SY Manual de usuario

Pfaff

Pfaff 571 Manual de usuario

Singer

Singer 15-91 Manual de usuario

Brother

Brother BB370 Manual de usuario

Pegasus

Pegasus WT100 Series Manual de usuario

Reliable

Reliable 7100DB Manual de usuario

Pfaff

Pfaff 937 Manual de usuario

Singer

Singer 6038 Manual de usuario

Singer

Singer 413K Manual de usuario

Pfaff

Pfaff 1471 E1 Manual de usuario

Kenmore

Kenmore 16677 - Serger Sewing Machine Manual de usuario

HIGHLEAD

HIGHLEAD GC2008-M Manual de usuario