HUBBELL LIGHTING COMPASS CU2FO Manual de usuario

WARNING – This product contains chemicals known to the State of California to cause cancer, birth

defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,

or otherwise touching this product.

Hubbell Lighting, Inc. Life Safety Products • www.compasslightingproducts.com

COM604073_INST_SHT 11/17

Fixed Optic LED Emergency Light

CU2FO

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following.

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. Do not use outdoors.

2. Equipment should be mounted in locations at heights (Max: 9ft) where it will not be subject

to tampering by unauthorized personnel.

3. Do not mount near gas or electric heaters

4. The use of accessories are not recommended by the manufacturer and may cause an

unsafe condition.

5. Do not use this equipment for other than its intended use.

6. Servicing of this equipment should be performed by qualied personnel.

7. Disconnect AC power before servicing.

INSTALLER:

•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS

•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT

IMPORTANT

The battery in this unit may not be fully charged. After electricity is connected to the unit,

let battery charge up to 24 hours. Then the normal operation of this unit should take

effect. To check press the “TEST” button and the lights on the unit should turn ON

RECYCLING INFORMATION

All steel, aluminum and thermoplastic

parts are recyclable. All cartons contain

recycled materials.

Please recycle responsibly.

INSTALLATION

WIRING DIAGRAM

Warning:

Unused wires must be capped

using enclosed wire nuts.

Fig. A Fig. B Fig. C

J-Box Mounting

1. Feed xture leads through back plate and connect AC power supply (Fig. A).

2. Connect wires through J-box. Secure back plate on to J-Box with screws.

3. Connect battery before AC power can be provided to the unit (Fig. B).

4. Align snaps and push housing directly onto back plate (Fig. C). Supply AC power and press

“TEST” button to check light.

Conduit Mounting

5. Secure back plate to wall surface. Route wires through hole in conduit ange and make conduit

connection.

6. Connect battery before AC power can be provided to the unit (Fig. B).

7. Align snaps and push housing directly onto back plate (Fig. C). Supply AC power and press

“TEST” button to check light.

OPERATION

1. During an electrical power failure, the lamps will automatically illuminate for a minimum of 90

minutes.

2. To test, pust the “TEST” switch. The emergency lamps will illuminate. When the switch is

released, the lamps will go off.

3. LED light is on when AC power & battery connected.

4. LED light will be OFF when AC power is disconnected.

5. LED light will be OFF when battery is disconnected or damaged

Este manual sirve para los siguientes modelos

Otros manuales de Luminaria de HUBBELL LIGHTING

HUBBELL LIGHTING

HUBBELL LIGHTING DUAL LITE EVHC Series Manual

HUBBELL LIGHTING

HUBBELL LIGHTING DualLite DYN Series Manual

HUBBELL LIGHTING

HUBBELL LIGHTING DUAL LITE DYN Series Manual

HUBBELL LIGHTING

HUBBELL LIGHTING DUAL LITE CCEL Series Manual de usuario

HUBBELL LIGHTING

HUBBELL LIGHTING Prescolite MD8LED Series Manual de usuario

HUBBELL LIGHTING

HUBBELL LIGHTING Compass CU2 Manual de usuario

HUBBELL LIGHTING

HUBBELL LIGHTING DUAL LITE CLSC Series Manual de usuario

Manuales populares de Luminaria de otras marcas

Emos

Emos CLASSIC ZY1431T Manual de usuario

Westinghouse

Westinghouse Outdoor Lighting Fixture Manual de usuario

Hedler

Hedler C 12 silent Manual de usuario

Blizzard Lighting

Blizzard Lighting Puck: CSI Manual de usuario

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Manual de usuario

Lightmaxx

Lightmaxx Shaft 5R Manual de usuario

Triarch

Triarch 31083 Manual de usuario

Philips

Philips 32614 Series Manual de usuario

IKEA

IKEA TIVED Manual de usuario

Lightolier

Lightolier LP200 Manual de usuario

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Manual de usuario

Martin

Martin MAC 250 Krypton Manual de usuario

Cooper Lighting

Cooper Lighting Halo L3232E Manual de usuario

Stageline

Stageline ODW-2410RGBW Manual de usuario

Light Sky

Light Sky Tornado Series Manual de usuario

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U Manual de usuario

Lightolier

Lightolier Lytespan 83ED17S Manual de usuario

Lightolier

Lightolier Calculite CS8226 Manual de usuario