HTS VRS SCH-200 Manual de usuario
VRS SCH-200 Imaging Unit
2 Megapixel Network Box Camera Series
Quick Installation Guide
Version 1.0
June 2013
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 2
Table of Contents
CHAPTER 1 SAFETY AND CERTIFICATIONS..........................................................3
1.1 Safety Instructions........................................................................................3
1.2 Disposal of Equipment..................................................................................4
1.3 FCC Compliance Statement ..........................................................................5
1.4 CE Statement................................................................................................5
CHAPTER 2 PRODUCT DESCRIPTION ..................................................................6
2.1 Overview ......................................................................................................6
2.2 Specifications................................................................................................6
CHAPTER 3 INSTALLATION PREPARATION .........................................................8
3.1 Unpacking the Unit.......................................................................................8
3.2 Checking for Damage....................................................................................8
3.3 Wall Mount Bracket .....................................................................................9
3.4 Pole Mount Adaptor.....................................................................................9
CHAPTER 4 INSTALLATION ...............................................................................10
4.1 Installation Tools ........................................................................................10
4.2 Mounting the SCH-200 on a Wall ...............................................................10
4.3 Mounting the SCH-200 on a Pole ...............................................................12
4.4 Connecting the External Wiring..................................................................13
4.5 Network Topology ......................................................................................15
CHAPTER 5 IP CONFIGURATION .......................................................................16
5.1 Default IP Address ......................................................................................16
5.2 IP Configurator Utility.................................................................................16
5.2.1 Running IP Configurator from the Lane Controller ................................16
5.2.2 Running IP Configurator on the Internet ...............................................16
5.3 Setting a New IP Address............................................................................17
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 3
Chapter 1 Safety and Certifications
NOTICE
Please read this guide thoroughly and save it for future use before attempting to connect or
operate this unit.
1.1 Safety Instructions
HAZARD: Please follow the safety instructions below. Failure to adhere to the
instructions could result in personal injury to the user.
This unit operates at 24VDC. The Camera is operate at 12VDC VIA internal
P/S Board
Installation and service should be performed only by qualified and
experienced technicians and comply with all local codes and rules in order
to maintain your warranty.
To reduce the risk of fire or electric shock, do not expose the product to
rain or moisture.
Wipe the imaging unit with a dry soft cloth. For tough stains, apply a small
quantity of diluted neutral detergent and wipe dry with a soft cloth.
Do not apply benzene, gasoline, or thinner to the imaging unit, which
may melt the surface of the unit or cause fogging in the lens.
Avoid aligning the lens to very bright objects (for example, light fixtures)
for long periods of time.
Avoid operating or storing the unit in the following locations:
oExtremely humid, dusty, or hot/cold environments
(recommended operating temperature: -20°C to +50°C)
oClose to sources of powerful radio or TV transmitters
oClose to fluorescent lamps or objects with reflections
oUnder unstable or flickering light sources
For eye safety –avoid looking directly to the LED`s illumination beam
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 4
1.2 Disposal of Equipment
WEEE (Waste Electrical and Electronic Equipment). Correct disposal of
this product (applicable in the European Union and other European
countries with separate collection systems). This product should be
disposed of, at the end of its useful life, as per applicable local laws,
regulations, and procedures.
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 5
1.3 FCC Compliance Statement
Information to the user: This unit has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15B of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This unit generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the manual, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this unit does cause harmful interference to radio or television reception, which
can be determined by turning the unit off and on, the user is encouraged to try to
correct the interference. For example, try reorienting or relocating the receiving
antenna, increasing the separation between the unit and receiver, or connecting the
unit to an outlet on a different circuit.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the unit.
1.4 CE Statement
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. The manufacturer
declares that the unit supplied with this guide is compliant with the essential
protection requirements of EMC directive and General Product Safety Directive
(GPSD) conforming to requirements of standards EN55022 for emission, EN 55024 for
immunity.
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 6
Chapter 2 Product Description
2.1 Overview
The SCH-200 is a state-of-the-art, 2 megapixel imaging unit. It is supplied
with the following interfaces:
2 shielded copper pairs:
One pair for powering
One pair for synchronizing with an external illumination unit
An Ethernet interface for transmission of images. The Ethernet
interface is also used by management software to configure the
imaging unit.
2.2 Specifications
Item
Specification
Camera –Basler -BIP2-1600c-dn
Sensor type
1/1.8" color CCD
Shutter type
Progressive Scan
Active Pixels
1600 (H) x 1200 (V)
Lens
Standard: 35 mm, Optional: 16/25/50 mm
Effective Range
Standard: 5-10 meters, Optional: 5-20
meters
Day/Night
Removable IR-cut filter
Video Compression
H.264
Protocol
TCP/IP
Housing -Mechanical / Electrical
Physical Dimensions
245(L) x 120(W) x 115(H) mm
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 7
Weight
3280 grams (including mounting bracket)
Casing
Die-Cast Aluminum Alloy
Protection Level
IP66
Operating Temperature Range
-10⁰C to +50⁰C
Adjustment Angles
3 (up/down, right/left, rotation)
Mounting bracket
Full cable management
Electrical
24 VDC, 2 amperes
Heating
Contains heater with thermostat control
Illumination
Spectrum
Infra-red (850 nm) or white illumination
Quantity
4 LEDs
Angle
30⁰, 45⁰
Intensity
4 levels (high, medium, low, off)
Frequency multiplier
Internally VIA PLL card
Safety and Certifications
Emissions
FCC Part 15 Class B, CE Class B
Product Safety
CE: EN/IEC60950-1: 2005
Eye Safety
EN60825-1, class-1 LED Product
Manufacturing quality certification
ISO 9001-2008
Table 1: SCH-200 Specifications
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 8
Chapter 3 Installation Preparation
3.1 Unpacking the Unit
Open the SCH-200 package and make sure that the contents match the order
form and the packing slip. In addition to this guide, items below are included
in the package.
One SCH-200 Network Imaging Unit
One printed Quick Installation Guide (this document)
1 meter cable and outlet for power input and external illumination
One Ethernet cable outlet with female to female RJ45 connector
One mounting Bracket
3 screws, 3 plastic nuts, and three 8 mm masonry anchors
One hex key (Allen wrench)
One BR-20 pole mount adapter kit (Optional)
NOTE
Please contact HTS if any of the items listed is missing.
3.2 Checking for Damage
When first unpacking, please check if there is any visible damage to the unit
and its accessories. The protective materials used for the packaging should be
able to protect the unit from most forms of damage during transportation.
NOTE
Please contact HTS if the item or any of its accessories is damaged.
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 9
3.3 Wall Mount Bracket
The wall mount bracket supplied with the SCH-200 is depicted in Figure 1
below.
Figure 1: Bracket Drawing and Dimensions
3.4 Pole Mount Adaptor
The pole mount bracket is not supplied with the SCH-200. It is optional to
order the adaptor for Pole mounting. The BR-20 pole adaptor is depicted in
Figure 2 below.
Figure 2: Pole Mount Adaptor
SCH-200 Imaging Unit Series│ Quick Installation Guide
Page 10
Chapter 4 Installation
4.1 Installation Tools
The following tools may be necessary to complete the installation:
Electric drill
Screwdrivers
Wire cutters
Set of hex keys (Allen wrenches)
4.2 Mounting the SCH-200 on a Wall
Mount the imaging unit on a wall or ceiling using the bracket as illustrated in
Figure 3 below.
Figure 3: Wall Mount
Tabla de contenidos
Otros manuales de Cámara de seguridad de HTS
