HP P5389A - Intel Pentium III-S 1.4 GHz Processor... Manual de usuario

HP Server Ultra3

Non-hot Swap

(68-pin) Hard Disk Drive

Installation Guide

HP Part Number 5990-2610

Printed in January 2002

Notice

The information contained in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this

material, including, but not limited to, the implied warranties of

merchantability and fitness for a particular purpose. Hewlett-Packard shall not

be liable for errors contained herein or for incidental or consequential damages in

connection with the furnishing, performance, or use of this material.

Hewlett-Packard assumes no responsibility for the use or reliability of its software

on equipment that is not furnished by Hewlett-Packard.

This document contains proprietary information that is protected by copyright. All

rights are reserved. No part of this document may be photocopied, reproduced, or

translated to another language without the prior written consent of Hewlett-

Packard Company.

NetWare®and UnixWare®are registered trademarks of Novell, Inc. Microsoft®

Windows NT, NTAS®, MS-DOS and Windows 2000®are registered trademarks

of Microsoft Corporation. SCO®UNIX®is a registered trademark of The Santa

Cruz Operation, Inc. Banyan®and VINES®are the registered trademark of Banyan

Systems Incorporated. OS/2is the registered trademark of the International

Business Machines Corporation. 3M® is a registered trademark of Minnesota

Mining and Manufacturing Company. TorxTM is a registered trademark of

CamCar/Textron, Inc. SCSI SelectTM is a registered trademark of Adaptec, Inc.

Linux®is a registered trademark of Linus Torvalds.

Hewlett-Packard Company

Network Server Division

Technical Communications/MS 45SLE

10955 Tantau Avenue

Cupertino, CA 95014 USA

Audience Assumptions

This guide is for the person who installs, administers, and troubleshoots LAN

servers. Hewlett-Packard Company assumes you are qualified in the servicing of

computer equipment and trained in recognizing hazards in products with

hazardous energy levels.

iii

It is HP's position that the HP Server product line being acquired is normally

located in spaces frequented only by service personnel for maintenance, repair or

occasional monitoring. Pursuant to FAR 39.204(d), this product is not required to

comply with the accessibility standards at 36 CFR part 1194 published under

Section 508 of the Rehabilitation Act.

Contents

1Prepare Drive for Installation..........................................................................1

Introduction........................................................................................................1

General Installation Steps .............................................................................1

Step 1: Prepare for Installation..........................................................................2

Tools You Need.............................................................................................2

Setup Information You Need.........................................................................2

Unpack the Drive...........................................................................................3

Step 2: Determine the Drive Type ..................................................................... 3

Step 3: Set the SCSI Address ...........................................................................8

Step 4: Continue Installation............................................................................16

2Mount the Drive in the Server L or T Series................................................17

Step 1: Mount the Drive in the System ............................................................17

Step 2: Connect the Drive Activity Light...........................................................18

Step 3: Connect the Drive................................................................................22

Step 4: Configure the Drive .............................................................................23

AJumper Settings............................................................................................. 25

Jumper Legend................................................................................................25

BReturning HP Hard Disk Drives.................................................................... 27

CWarranty and Support................................................................................... 29

Hardware Warranty..........................................................................................29

HP Repair and Telephone Support..................................................................29

Index....................................................................................................................31

1 Prepare Drive for Installation

Introduction

This chapter describes the tools, setup information and the steps necessary to

install a 68-pin SCSI hard disk drive into an HP Server. The drives documented in

this guide are listed in Table 1-1.

Table 1-1. Hard Disk Drive Product Numbers

HP Product Number Capacity RPM

P1167A 18.2 GB 10000

P4616A 18.2 GB 10000

P1169A 36.4 GB 10000

P3578A 73.4 GB 10000

These HP Ultra3 drives can operate in either Single-Ended (SE) mode as Ultra

drives with a maximum bus data rate of 40 MB/sec or in Low-Voltage Differential

(LVD) mode as Ultra3 drives with a maximum bus data rate of 160 MB/sec. The

terminator on the cable, other drives on the bus, and/or the host controller card,

determines whether the drive runs in SE or LVD mode.

NOTE For any drive to run in LVD mode, all SCSI components on

that bus must be in LVD mode.

General Installation Steps

In general, the steps for installing a hard drive are shown below. Please refer to the

detailed instructions in each step before attempting to install your drive.

1. Prepare for Installation

2. Determine the Drive Type

3. Set the SCSI Address

5. Mount the Drive in the System

6. Connect the Drive Activity Light (if appropriate)

7. Connect the Drive

8. Configure the Drive

NOTE Drives with the same product number can be of different types

and require different jumper settings. Match your drive with the

type shown in the figures before installation.

Chapter 1 Prepare Drive for Installation

Step 1: Prepare for Installation

Gather the tools and the setup information you need to install the drive, before

removing the drive from its packaging.

Tools You Need

To install the disk drive, you need the following tools:

•Tweezers, needle-nose pliers or a similar tool for setting configuration

jumpers.

•A TorxTM T-15 screwdriver or a regular blade screwdriver.

Setup Information You Need

Before you begin, you need the following setup information:

•The HP Operations and Maintenance Guide for your system or

Information Assistant on the HP Server Navigator CD-ROM.

•The SCSI addresses available in your system. (Refer to your system in

Information Assistant on the HP Server Navigator CD-ROM for

information on determining available SCSI addresses.)

Chapter 1 Prepare Drive for Installation

Unpack the Drive

CAUTION Shock: Hard disk drives are very susceptible to mechanical

shock and can be damaged by a drop as short as one-quarter of

an inch (.64 cm). Take care when unpacking and handling the

disk drive. If the drop would crack an egg, it will damage the

drive.

Static: Protect the hard disk drive from static electricity by

leaving it in its antistatic bag until you are ready to install it.

Use an antistatic wrist strap and a grounding mat (3M

8501/8502/8505 or equivalent). If an antistatic work area is

not available, touch any unpainted metal surface to discharge

static electricity before handling the drive.

When you remove the hard disk drive from the antistatic bag,

handle it only by the frame. Do not touch the electrical

components. Place the drive on the antistatic bag whenever

you set it down.

After gathering the information and tools:

•Remove the drive from the packaging.

Step 2: Determine the Drive Type

The type of the drive varies and drives with the same part number may be of

different types.

•Match the drive you unpacked with the type of drive shown in Figure 1-1.

Chapter 1 Prepare Drive for Installation

Figure 1-1. Identification of the Different Types of Drives (1 of 2)

Otros manuales para P5389A - Intel Pentium III-S 1.4 GHz Processor...

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Almacenamiento de HP

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manual de instrucciones

HP AJ765A - StorageWorks RDX Removable Disk Backup... Manual de instrucciones

HP StoreAll 8000 Instrucciones de uso

HP StorageWorks 2000s Manual de usuario

HP StorageWorks 1/8 G2 Manual de usuario

HP P9000 Guía de configuración rápida

HP MSA 2050 Manual de usuario

HP StoreEver MSL3040 Manual

HP ProLiant SB460c - SAN Gateway Storage Server Manual de instrucciones

HP Z Turbo Drive Quad Pro Manual de usuario

HP P2000 G3 Manual de usuario

HP P9000 Manual de instrucciones

HP HP 7936 Instrucciones de instalación

HP BL536A Manual de usuario

HP StoreVirtual 4630 Manual de funcionamiento

HP StorageWorks Modular Smart Array 500 System Manual de usuario

HP Model 744 - VME Workstation Guía de referencia

HP AU183AA - 2TB Personal Media Drive Manual de uso y mantenimiento

HP StorageWorks 2300 - Disk System Guía rápida

HP StoreAll 9730 Manual de servicio

HP Cray CS E1000 Instrucciones de instalación

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manual de instrucciones

HP VS80 - StorageWorks DLT VS 80 Tape Drive Manual de usuario

HP StoreOnce B6000 Manual de usuario

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario

Dell

Dell PowerVault MD3600f Series Manual de usuario

CFI

CFI TERA STOR SATA RAID IV Manual de usuario