HP D Series Manual de instalación y operación

System Memory Upgrade Guide

D Class and R Class

HP 9000 Enterprise Servers

Part No. A3262-90003

Edition 6

October 1998

E1098

Printed in: USA

Legal Notices

The information in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this manual,

including, but not limited to, the implied warranties of merchantability and fitness

for a particular purpose. Hewlett-Packard shall not be held liable for errors

contained herein or direct, indirect, special, incidental or consequential damages in

connection with the furnishing, performance, or use of this material.

Restricted Rights Legend. Use, duplication or disclosure by the U.S. Government

is subject to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in

Technical Data and Computer Software clause at DFARS 252.227-7013 for DOD

agencies, and subparagraphs (c) (1) and (c) (2) of the Commercial Computer

Software Restricted Rights clause at FAR 52.227-19 for other agencies.

HEWLETT-PACKARD COMPANY 3000 Hanover Street Palo Alto, California

94304 U.S.A.

reserved.

Reproduction, adaptation, or translation of this document without prior written

permission is prohibited, except as allowed under the copyright laws.

Trademark Notices. UNIX is a registered trademark in the United States and other

countries, licensed exclusively through X/Open Company Limited.

Contents

iii

Who Should Use this Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . vi

1. D Class System Memory Upgrade

Overview of Memory Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Memory Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Memory Upgrade Verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-24

Memory Upgrade Verification Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-25

Troubleshooting Memory Configuration Error Symptoms . . . . . . . . . . . . . . . . . 1-30

Obtaining the Correct Firmware Patch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-32

Downloading the Firmware Patch via the World Wide Web . . . . . . . . . . . . 1-33

Downloading the Firmware Patch using FTP . . . . . . . . . . . . . . . . . . . . . . 1-34

2. R Class System Memory Upgrade

Overview of Memory Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1

Memory Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Memory Upgrade Verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20

Troubleshooting Memory Configuration Error Symptoms . . . . . . . . . . . . . . . . . 2-24

Obtaining the Correct Firmware Patch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-25

Downloading the Firmware Patch via the World Wide Web . . . . . . . . . . . . 2-26

Downloading the Firmware Patch using FTP . . . . . . . . . . . . . . . . . . . . . . 2-27

Contents

Printing History

The manual printing date and part number indicate its current edition. The printing

date will change when a new edition is printed. Minor changes may be made at

reprint without changing the printing date. the manual part number will change

when extensive changes are made.

Manual updates may be issued between editions to correct errors or document

product changes. To ensure that you receive the updated or new editions, you should

subscribe to the appropriate product support service. See your HP sales

representative for details.

First Edition: December, 1995

Second Edition: May, 1996

Third Edition: November, 1996

Fourth Edition: August, 1997

Fifth Edition: August 1998

Sixth Edition: October 1998

NOTE Reader Comments. We welcome your comments about our documentation. If you

have editorial suggestions or recommended improvements for this document, please

write to us. You can reach us through e-mail at: hardwaredocs@cup.hp.com or by

sending your letter to: Documentation Manager, M/S 5657, Hewlett-Packard

Company, 8000 Foothills Blvd., Roseville, CA 95747-6588 USA. Please include the

following information in your message:

• Title of the manual you are referencing.

• Manual part number (from the title page).

• Edition number or publication date (from the title page)..

• Your name.

• Your company’s name.

SERIOUS ERRORS, such as technical inaccuracies that may render a program or a

hardware device inoperative, should be reported to your HP Response Center or

directly to a Support Engineer.

Who Should Use this Guide

The procedures in this guide are intended to be performed by a person who is

qualified in the installation and servicing of computer equipment, and is trained to

recognize the hazards involved. Memory is installed in an area of the product where

energy levels considered hazardous may be produced.

1-1

D Class System Memory Upgrade

Overview of Memory Installation

The memory installation procedures are organized as follows:

A. Check existing system memory.

B. Turn off power to the system.

C. Remove the front bezel.

D. Remove the side panel.

E. Remove the EMI cover.

F. Remove the Processor/Memory card.

G. Plan the memory configuration.

H. Install memory modules.

I. Replace the Processor/Memory card.

J. Replace the EMI cover.

K. Replace the side panel.

L. Replace the front bezel.

After completing all installation procedures, proceed to the Memory Upgrade

Verification procedure (located after the installation procedures) for instructions on

how to verify correct installation. If the memory verification is not successful, refer

to the section titled Troubleshooting Memory Configuration Error Symptoms at

the end of this manual.

1-2

D Class System Memory Upgrade

Overview of Memory Installation

Required Tools To perform the procedures in this upgrade guide, the following tools are required:

• Small flat-bladed screwdriver

• Torx driver, #15

• Phillips screwdriver.

Safety

Considerations

WARNING The installation procedures in this guide require opening the system cabinet,

which may expose you to high-energy (high-amperage) circuits, possible

ejection of molten metal, and exposed sharp edges in equipment chassis. Be

sure to remove all rings, watches, and other jewelry from fingers, wrists, and

arms before opening the system cabinet.

Electrostatic

Discharge

Precautions

Electrostatic discharge can damage the integrated circuits on printed-circuit boards.

To prevent such damage from occurring, be sure to observe the following

precautions when handling and installing boards:

1. Use a grounding mat and an anti-static wrist strap, such as those included in the

ESD Field Service Kit (HP P/N A3024-80004).

2. Wear the anti-static wrist strap to ensure that any accumulated electrostatic

charge is discharged from you body to ground.

3. Keep uninstalled printed-circuit boards in their protective anti-static bags until

you are ready to install them.

4. Handle printed-circuit boards by their edges after you have removed them from

their protective anti-static bags.

1-3

D Class System Memory Upgrade

Memory Installation Procedure

A. Check Existing

System Memory To check the memory configuration on your system:

Reboot the system by typing /etc/shutdown -r at the HP-UX system prompt:

/etc/shutdown -r

When prompted, halt the boot process by pressing any key on the keyboard:

Processor is booting from first available device.

To discontinue, press any key within 10 seconds.

Boot terminated.

Main Menu ----------------------------------------------------

Command Description

------- -----------

BOot [PRI|ALT|<path>] Boot from specified path

PAth [PRI|ALT|CON|KEY] [<path>] Display or modify a path

SEArch [DIsplay|IPL] [<path>] Search for boot devices

TOC Soft boot the system

COnfiguration [<command>] Access Configurationmenu/commands

INformation [<command>] Access Information menu/commands

SERvice [<command>] Access Service menu/commands

DIsplay Redisplay the current menu

HElp [<menu>|<command>] Display help for menu or command

RESET Restart the system

-------

Main Menu: Enter command >

1-4

D Class System Memory Upgrade

Memory Installation Procedure

At the Main menu of the Boot Console Handler, type “in me” to display memory

information.

Note the amount of memory listed in the memory information display. After

installing additional memory, you will check this memory information display again

to verify that the system recognizes the newly installed memory

Example Memory Information Display (Models D200/D210/D310)

Main Menu: Enter command > in me

MEMORY INFORMATION

Slot Card Size Amount Enabled

---- --------- --------------

0 16 MB 16 MB

1 16 MB 16 MB

Physical Memory: 32 MB (0x02000000)

Configured Memory: 32 MB (0x02000000)

Main Menu: Enter command >

Example Memory Information Display (all other D2xx and D3xx Models)

Main Menu: Enter command > in me

MEMORY INFORMATION

MEMORY STATUS TABLE

Slot Size(a+b) Status

---- -------- ------

0a/b 128MB Configured

1a/b 32MB Configured

2a/b 32MB Configured

--------

TOTAL 192MB

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Servidor de HP

HP ML330 - ProLiant - G3 Instrucciones de funcionamiento y seguridad

HP ProLiant SL160z Generation 6 (G6) Guía de instalación

HP P4518A - Traffic Management Server Sa7150 Guía

HP P4800 G2 Manual de funcionamiento

HP D7171A - NetServer - LPr Manual de usuario

HP Tc2100 - Server - 128 MB RAM Manual de usuario

HP ProBook 4320t Manual

HP ProLiant DL165 Instrucciones de uso

HP Integrity Superdome SX1000 Manual de usuario

HP D5970A - NetServer - LCII Manual de usuario

HP Integrity rx2600 Manual de usuario

HP ProLiant DL560 Gen11 Manual de usuario

HP T5125 - Compaq Thin Client Manual de servicio

HP ProLiant DL360p G8 Instrucciones de montaje

HP D5970A - NetServer - LCII Manual de usuario

HP ProLiant BL20p Generation 2 Manual

HP P4518A - Traffic Management Server Sa7150 Manual de usuario

HP ProLiant ML115 G5 Guía de inicio rápido

HP Integrity BL860c i4 Manual de usuario

HP Tc4100 - Server - 256 MB RAM Manual de funcionamiento

HP ProLiant DL380 Manual de usuario

HP ProLiant MicroServer Gen8 Manual de usuario

HP Disk Carrier Blade for bh3710 Manual de usuario

HP NetServer LH 4 Manual de usuario

Manuales populares de Servidor de otras marcas

Dell

Dell PowerEdge R410 Manual de usuario

PowerNAS

PowerNAS CMA Manual de usuario

Supero

Supero FatTwin F617R3-FT Manual de usuario

MSI

MSI P1-109N-L70 Manual de usuario

Dell

Dell PowerEdge XE9640 Manual

Dell

Dell PS4100 Instrucciones de montaje

EtroVISION

EtroVISION EV3151 Manual de usuario

NEC

NEC Express5800/T110j Manual de usuario

Compaq

Compaq ProLiant 3000 Manual

Dell

Dell PowerEdge 3YPMN Manual de usuario

iRobo

iRobo IPC2U Manual de usuario

Nortel

Nortel 1000 Con?guration guide Manual de usuario

Asus

Asus AP7500 Manual de operación y mantenimiento

Avid Technology

Avid Technology AirSpeed 5000 Manual de usuario

Milestone

Milestone Husky IVO 350T Manual de usuario

Planet

Planet NAS-7410 Manual de usuario

Lenovo

Lenovo ThinkSystem SR635 V3 Manual de usuario

Dell

Dell PowerEdge HS5610 Manual