HP f800g Manual de usuario
1
Battery warning
The battery for this car camcorder is sealed internally. DO NOT
attempt to disassemble the camcorder and remove the battery.
Always charge using the provided system. Improper charging of the
battery may result in explosion.
The battery is designed for this camcorder and is not customer
replaceable.
Batteries may explode if exposed to na ed fire. Never expose the
car camcorder in a fire.
Recycle the camcorder observing local regulations.
Notes on Installation
1. Install the device near the rear-view mirror to obtain the best
open-field view. Do NOT install the camcorder in a location that will
obstruct your required driving view.
2. Ma e sure that the lens is within the wiping range of the
windscreen wiper to ensure a clear view even when it rains.
3. Do not touch the lens with your fingers. Finger grease may be left
on the lens and will result in unclear videos or snapshots. Clean the
lens on a regular basis.
4. Do not install the device on a tinted window. Doing so may damage
the tint film.
5. Ma e sure that the installation position is not hindered by the
tinted window.
2
1Introduction
1.1 Package Contents
The pac age contains the following items. In case there is any missing or
damaged item, contact your dealer immediately.
Camcorder Brac et
CD-ROM Quic start guide Car adapter
3
1.2 Product Overview
No. Item No. Item
1 Brac et Soc et 6 GPS Antenna
2 Memory Card Slot 7 Wide Angle Lens
3 Power Switch 8 Spea er
4 LED Indicator 9 Microphone
5 USB / Power Connector 10 LCD Touch Panel
Top and Bottom Views
Side (Left and Right) Views
Front View
Rear View
2
8
9
1
10
4
5
7
6
3
4
2etting Started
2.1 Inserting the Memory Card
Insert memory card with the gold section facing upward and the screen
of the camcorder facing upward too, as illustrated. Push the memory
card in until a clic sound is heard, indicating the card is in position.
To remove the memory card
Push to eject the memory card out of the slot.
Note:
1. Do not remove or insert the memory card when the camcorder is turned on. This
may damage the memory card.
2. Please use a Class 6 or higher rating Micro SD card, max. up to 32GB.
3. Please format the micro SD cards before the initial use.
4. When removing the memory card, be careful that the card may spring out and get
lost. The memory slot has this spring-out feature for easy removal of the card.
5
2.2 Installing in Vehicles
2.2.1 Mount to Windshield
1. Push the brac et into brac et slot on top of
camcorder, until a clic sound is heard.
2. With the suction-cup laying flat,
position the suction-cup on the
windshield.
3. Hold the base firmly on the windshield
and press down the clamp to mount the
car holder to the windshield. Ma e sure
the base is securely loc ed in place.
6
2.2.2 Adjust the Camcorder position
1. Loose the nob to swivel the
camcorder vertically.
2. Loose the nob to swivel the
camcorder horizontally up to
360°.
3. Then tighten the nob to ma e sure the camcorder is securely
loc ed in place.
Knob
Knob
7
2.3 Connecting to Power
Use only the supplied car adapter to power up the camcorder and
charging the built-in battery.
1. Connect one end of car adapter to USB/Power connector port on the
camcorder.
2. Plug the other end of the car adapter to the cigarette lighter soc et
of your vehicle. Once the vehicle engine is started, the camcorder
automatically powers on.
Note:
This product shall be installed near the rear mirror, at the center of windshield, if
possible, for optimal viewing.
8
2.4 Powering the Camcorder On / Off
2.4.1 Auto Power On/Off
Once the vehicle engine is started, the camcorder automatically turns on.
If the Automatic Record function is enabled, the recording will
automatically start right after the camcorder powers on.
2.4.2 Manual Power On/Off and Reset
2.4.2.1 Manual Power On
Slide the power switch and ma e sure that the power switch loc s on the
memory card slot.
On
2.4.2.2 Power Off
The power switch to the edge and ma e sure that the memory slot is
released and the camcorder starts power off sequence. Do not power on
the camcorder when it is in the power-off sequence, or the recorded file
may become corrupt.
O
ff
9
2.5 Initial Settings
Before using the camcorder, we recommend you to enable the
Automatic Record function and set up the correct Date and Time.
2.5.1 Setting the Universal Time Code (UTC)
Depending on your location, you may need to change the current UTC
setting of the camcorder so that the correct date and time are updated
when a GPS signal is detected.
* Be sure to adjust for daylight saving time (DST) by adding +1 hour to the UTC offset.
** These areas may observe half hour increments and daylight saving time (DST).
Otros manuales para f800g
1
Tabla de contenidos
Idiomas:
Otros manuales de Cámara de salpicadero de HP
HP
HP f710 Manual de usuario
HP
HP f790 Manual de usuario
HP
HP Deskjet F310 Manual de usuario
HP
HP Compaq Presario,Presario F760 Manual de usuario
HP
HP f520 Manual de usuario
HP
HP f650x Manual de usuario
HP
HP u818x kit Manual de usuario
HP
HP F330S Manual de usuario
HP
HP f910g Manual de usuario
HP
HP f969x Manual de usuario
HP
HP F300 Manual de usuario
HP
HP f210 Manual de usuario
HP
HP Compaq Presario,Presario F558 Manual de usuario
HP
HP f880x Manual de usuario
HP
HP F650g Manual de usuario
HP
HP f300c Manual de usuario
HP
HP Deskjet F310 Manual de usuario
HP
HP Deskjet F310 Manual de usuario
HP
HP f330 Manual de usuario
HP
HP Compaq Presario,Presario F760 Manual de usuario
