Hotpoint VITROCERAMIC C320IX Manual de usuario

Index

Instructions for use

Installation, 4

Use, 4

Maintenance, 4

Instructions for the installater

Installation, 6

Positioning, 6

Electrical connection, 6

Heating elements, 6

Assistance, 7

THIS APPLIANCE IS CONCEIVED FOR

DOMESTIC USE ONLY.THE MANUFACTURER

SHALL NOT IN ANY WAY BE HELD

RESPONSIBLE FOR WHATEVER INJURIES

OR DAMAGES ARE CAUSED BY INCORRECT

INSTALLATION OR BY UNSUITABLE,WRONG

OR ABSURD USE.

English

Dear customer,

We thank you and con-gratulate you on your

choice. This new carefully de-signed product,

manu-facturedwiththehighestqualitymaterials,

has been carefully tested to satisfy all your

cooking demands. We would therefore request

you to read and follow these easy instructions

which will allow you to obtain ex-cellent results

right from the start. May we wish you all the

very best with your modern appliance!

THE MANUFACTURER

Cooking Hobs

VITROCERAMIC

C320IX

Instructions for use

Fig.1

NO NO YES

Fig.2

USE OF THE HEATING ELEMENTS

energy regulator intensità calore

1 - 2 Weak

3 - 4 Gentle

5 - 6 Slow

7 - 8 Medium

9 - 10 Strong

10 - 11 Bright

Installation

All operations relative to installation (electric connection)

should be carried out by skilled personnel in conformity

with the rules in force. As for the speciﬁc instructions

see part pertaining to installer.

Use

Heating elements - Manual control

(Fig. 1-2)

Rotate the knob concerned to the position correspondant

to the needs of cooking taking into consideration that

to a higher number a higher heat supply corresponds,

see table “use of heating elements”.

When pilot lights are lit, they indicate the top temperature

at the indicated spot is higher than 50’ C.

Some types of pilot lights will maintain some slight

luminescence even after disconnection. That is

quite normal.

N.B. - When one makes use of heating elements, we

advise receptacles with ﬂat bottom (Fig. 3) having same

diameter or lightly higher than that of the hot area.

- Avoid overﬂows of liquid, therefore when boiling has

happened, or in any case when liquid is heated,

reduce the heat supply.

- Don’t leave the heating elements on without

receptades on the top or withvoid pots and pans.

In the event of even a slight fracture on the cooking surface,

disconnect the electric power supply immediately.

Maintenance (Fig. 3)

First of all remove stray food bits and grease drops from

the cooking surface with the special scraper (ﬁg. 4).

Then clean the hot area as best as possible with SIDOL,

STAHLFE or other similar products with a papertowel,

then rinse again with water and dry with a dean cloth.

Pieces of aluminum foil and plastic material whic

have inadvertently melted or sugar remains or highly

sacchariferous food have to be removed immediately

from the hot cooking area with the special scraper (ﬁg.

4) -This is to avoid any possible damage to the surface

of the top. Under no circumstances should abrasive

sponges or irritating chemical detergents be used such

as oven sprays or spot removers.

DO NOT USE STEAM CLEANERS

Fig.3



Fig.4

Fig.4a

Instructions for the installer

HEATING ELEMENTS

V TYPE W REGULATION

~ 230 V single-circuit radiant Ø 145 1200 energy regulator 0+11

single-circuit radiant Ø 180 - Ø 195 1700-1900 energy regulator 0+11

H05RR-F3x1.5

Fig.5

The earth connection is compulsory in terms of the law.

Should there be no cable andlor plug on the equipment, use

suitable absorption material for the working temperature as

well, as indicated on the matrix plate. Under no circumstance

must the cable reach a temperature above 50°C of the

ambient temperature. lf connecting directly to the mains

power supply, ﬁt a multi-pole switch of a suitable size for the

rated capacity with a clearance distance which completely

disconnects the power line under overvoltage category

III conditions, consistently with the rules of installation (the

yellow/green earth wire must not be interrupted).

The plug or omnipolar switch must be easily reached on

the installed equipment.

N.B.: - The manufacturers dedine any responsibility in

the event of non-compliance with what is described

above and the accident prevention norms not being

respected and followed.

To avoid all risk, if the power cable becomes damaged,

it must only be replaced by the manufacturer, by

an authorised service centre, or by a qualiﬁed

electrician.

Installation

These Instrnctions are for the qualiﬁed technician, as a

guide to the installation, adjustment and maintenance,

according to the laws and standards in force. Any of these

operations must always be canied out when the appliance

has been disconnected from the electric system.

Positioning (Fig. 4-4a)

The appliance can be ﬁtted into a working area as

illustrated on the ﬁgure. Apply the seal supplied over the

whole perimeter of the working area.

Electrical connection (Fig. 5)

Prior io carrying out the electrical connection, please ensure that:

- the plant characteristics are such as to follow what is indicated

on the matrix plate placed at the bottom of the working area;

- that the plant is ﬁtted with an efﬁcient earth connection,

following the standards and law provisions in force.

The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or

copying errors. We reserve the right to make on our own products those changes to be considered necessary or useful,

without jeopardizing the essential characteristics.

Assistance

Before contacting After-Sales Service:

1. See if you can solve the problem yourself.

2. Switch the appliance on again to see if the problem

has been solved. if it has not, disconnect the

appliance from the power supply and wait for about

an hour before switching on again.

3. If the problem persists after this course of action,

contact After-Sales Service.

Specify:

• thenatureofthefault,

• themodel

• the service number (the number after the word

SERVICE on the rating plate on the rear of the

appliance)

• yourfulladdress,

• yourtelephonenumberandareacode.

Never call on unauthorized technicians and always

refuse to purchase non-original spare parts.

Notes

Tabla de contenidos

Otros manuales de Quemador de Hotpoint

Hotpoint

Hotpoint PH 930 MST/HA Manual de usuario

Hotpoint

Hotpoint RO 642 TOIRFH Manual de usuario

Hotpoint

Hotpoint TD 641S (BK) IX/HA TR Manual de usuario

Hotpoint

Hotpoint HR 651 C H Manual de usuario

Hotpoint

Hotpoint PKL 641 EX Manual de usuario

Hotpoint

Hotpoint PK 644 D GH X /HA G Manual de usuario

Hotpoint

Hotpoint PL 640 SP TK/HA Manual de usuario

Hotpoint

Hotpoint E6004 Manual de usuario

Hotpoint

Hotpoint TD 640 IX/HA Manual de usuario

Hotpoint

Hotpoint G640N Manual de usuario

Hotpoint

Hotpoint E320SKIX Manual de usuario

Hotpoint

Hotpoint CIB 64 C. S Manual de usuario

Hotpoint

Hotpoint PK 640 R GH /HA Manual de usuario

Hotpoint

Hotpoint CRO642DB Manual de usuario

Hotpoint

Hotpoint E604 Manual de usuario

Hotpoint

Hotpoint GE75DX Manual de usuario

Hotpoint

Hotpoint CIO 644 DD Z Manual de usuario

Hotpoint

Hotpoint KIC 640 Z IT Manual de usuario

Hotpoint

Hotpoint ET6004 Manual de usuario

Hotpoint

Hotpoint TQ 751K X/HA Manual de usuario

Hotpoint

Hotpoint ET6124 Manual de usuario

Hotpoint

Hotpoint 6344 Manual del propietario

Hotpoint

Hotpoint E600 Manual de usuario

Hotpoint

Hotpoint HR 619 CH Manual de usuario

Manuales populares de Quemador de otras marcas

Siemens

Siemens EX875KYV1E Hoja de especificaciones

AEG

AEG CERAMIC HOB 6010 K Manual de usuario

VALERA

VALERA CT 70A Manual de usuario

Zanussi

Zanussi ZGF 6420 Manual de usuario

Gaggenau

Gaggenau CI 273 Manual de usuario

G3 Ferrari

G3 Ferrari Energy Manual de usuario

Pkm

Pkm IN4B Manual de usuario

Award

Award H903BG Manual de usuario

Zanussi

Zanussi VCH 5005 RZ Manual de usuario

Miele

Miele KM 523 Manual de usuario

AEG

AEG HK854870XB Manual de usuario

Cookology

Cookology SEP600BK Manual de usuario

Bauknecht

Bauknecht Hob Manual de usuario

Zanussi

Zanussi ZGM 782 Manual de usuario

dipo INDUCTION

dipo INDUCTION DIBK218S Manual de usuario

Miele

Miele KM 5987 Manual de usuario

Miele

Miele KM 360 G Manual de usuario

Blomberg

Blomberg MKN 24201 W Manual de usuario