Hotpoint E320SIX Manual de usuario

Index

Instructions for use

Installation, 4

Use, 4

Maintenance, 4

Instructions for the installater

Installation, 6

Positioning, 6

Electrical connection, 6

Assistance, 7

THIS APPLIANCE IS CONCEIVED FOR

DOMESTIC USE ONLY.THE MANUFACTURER

SHALL NOT IN ANY WAY BE HELD

RESPONSIBLE FOR WHATEVER INJURIES

OR DAMAGES ARE CAUSED BY INCORRECT

INSTALLATION OR BY UNSUITABLE,WRONG

OR ABSURD USE.

English

Dear customer,

We thank you and con-gratulate you on your

choice. This new carefully de-signed product,

manu-facturedwiththehighestqualitymaterials,

has been carefully tested to satisfy all your

cooking demands. We would therefore request

you to read and follow these easy instructions

which will allow you to obtain ex-cellent results

right from the start. May we wish you all the

very best with your modern appliance!

THE MANUFACTURER

Electrical Cooking Hob

E320SIX

Instructions for use

USE OF ELECTRICAL PLATES

quick-normal intensity of heat

1 Weak

2 Gentle

3 Slow

4 Medium

5 Strong

6 Bright

Fig.1

Fig.2

Installation

All operations relative to installation (electric connection)

should be carried out by skilled personnel in conformity

with the rules in force. As for the speciﬁc instructions see

part pertaining to installer.

Use

Electric plates (Fig. 1 - 2 - 3)

Rotate the knob to the position correspondent to the

needs of cooking taking into consideration that to a

higher number a higher heat supply corresponds,

see table “use of electric plates”. “Quick and normal

plates”: clockwise and anticlockwise rotation with

7 ﬁxed position (0÷6). The pilot lamp on indicates

when plate is connected.

Some types of pilot lights will maintain some slight

luminescence even after disconnection. That is quite

normal.

N.B.:

- When one makes use of electric plates, we advise

receptacles with ﬂat bottom having same diameter or

lightly higher than that of the plate;

- avoid overﬂows of liquid, therefore when boiling

has happened or in any case when liquid is heated,

reduce the heat supply;

- don’t leave the electrical plates on without receptacles

on the top or with void pots and pans;

- at the end of cooking take again the knob to position “0”.

Maintemace

Before every operation it’s necessary to disconnect the

apparatus. To obtain a higher life of the apparatus concerned

it’s indispensable to carry out at regular intervals a carefully

general cleaning bearing in mind the following:

- the s/s and/or enameled parts should be cleaned by

means of suitable not abrasive or corrosive products

(available on the market). Avoid cloride-base products

(bleach, etc.)

- avoid leaving on the top acid or alkaline substances

(vinegar, salt, lemon-juice, etc.)

- the electric plates have to be cleaned by means of a wet

rag and lightly oiled with lubricant when they are still tepid.

DO NOT USE STEAM CLEANERS

HO5RR - F3 x 1.5

HO5RR - F4 x 0.75

Apparatus class I (type Y): it can be brought near furniture being higher than the work-top

ELECTRIC PLATES

SUPPLY

TYPE

WREGULATION

~ 230 V • QUICK Ø 145 1500

CLOCKWISE AND ANTICLOCKWISE ROTATION

• QUICK Ø 180 2000

• red point

Fig. 4

Fig. 5

1 - Ø 145

2 - Ø 180

Fig. 3

Instructions for the installer

Installation

These instructions are turned to the skilled installer as

a guide toinstallation, regulationand maintenance in

compliance with the lawsand the rules in force. Any of

these operationsmust always be carriedout when the

appliancehas been disconnected from the electric

system.

Positioning (Fig. 4)

The apparatus isprovided to be built-in awork-top

as shown in thespecial ﬁgure.Present the sealing

agentalong all the perimeter.

Electrical connection (Fig. 5)

Before carrying out theelectrical connection be sure that:

- the characteristics of the system are such as tosatisfy

what indicated onthe part number plateapplied to the

bottom ofthe work-top;

- that the system is provided with the effective ground

in compliance with the rules and the provisions of law

in force. The ground is binding according to the law.

In case the apparatus isn’tprovided with cable and/or

with relative plugmake use of material suitable for the

absorption indicated inthe part number plate andfor

the workingtemperature. The cableshould reach in

no point atemperature higher 50°Cthan of the room

temperature.

If connecting directly to the mains power supply, ﬁt a multi-

poles witch of a suitable size for the rated capacity with

a clearance distance which completely disconnects the

power line under over voltage category III conditions,

consistently with the rules of installation (the yellow/green

earth wire must not be interrupted).

The plug on the omnipolarswitch should be easilyreachable

with apparatusinstalled.

N.B.:-Themanufacturerdeclinesallresponsibilityincase

the above and the usual safety rules aren’trespected.

To avoid all risk, if the powercable becomes damaged,

it mustonly be replaced bythe manufacturer, byan

authorised service centre, or by aqualiﬁed electrician.

The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or

copying errors. We reserve the right to make on our own products those changes to be considered necessary or useful,

without jeopardizing the essential characteristics.

Assistance

Before contacting After-Sales Service:

1. See if you can solve the problem yourself.

2. Switch the appliance on again to see if the problem

has been solved. if it has not, disconnect the

appliance from the power supply and wait for about

an hour before switching on again.

3. If the problem persists after this course of action,

contact After-Sales Service.

Specify:

• the nature of the fault,

• the model

• the service number (the number after the word

SERVICE on the rating plate on the rear of the

appliance)

• your full address,

• your telephone number and area code.

Never call on unauthorized technicians and always

refuse to purchase non-original spare parts.

Notes

Tabla de contenidos

Otros manuales de Quemador de Hotpoint

Hotpoint

Hotpoint BE11 Manual del propietario

Hotpoint

Hotpoint GF640 Manual de usuario

Hotpoint

Hotpoint CIB 64 C. S Manual de usuario

Hotpoint

Hotpoint GF961TX Manual de usuario

Hotpoint

Hotpoint 6361 Manual de instrucciones

Hotpoint

Hotpoint NRA 640 B Manual de usuario

Hotpoint

Hotpoint EV302X Manual de usuario

Hotpoint

Hotpoint GX 641 F G K Manual de usuario

Hotpoint

Hotpoint PC 604 /HA Manual de usuario

Hotpoint

Hotpoint HS67V5KHX Manual de usuario

Hotpoint

Hotpoint E6011 Manual de usuario

Hotpoint

Hotpoint PK 750 R GH /HA Manual de usuario

Hotpoint

Hotpoint HR 619 CH Manual de usuario

Hotpoint

Hotpoint E320SKIX Manual de usuario

Hotpoint

Hotpoint EC6011 - EC6014 Manual de usuario

Hotpoint

Hotpoint GF640 Manual de usuario

Hotpoint

Hotpoint CIC 642 C Manual de usuario

Hotpoint

Hotpoint KBT 6412 I IX Manual de usuario

Hotpoint

Hotpoint GF750TX Manual de usuario

Hotpoint

Hotpoint Creda EC6005 Manual de usuario

Hotpoint

Hotpoint G640SB Manual de usuario

Hotpoint

Hotpoint GB 630 R T X Manual de usuario

Hotpoint

Hotpoint GBD641EIX Manual de usuario

Hotpoint

Hotpoint KRH 600 B Manual de usuario

Manuales populares de Quemador de otras marcas

Siemens

Siemens EX875KYV1E Hoja de especificaciones

AEG

AEG CERAMIC HOB 6010 K Manual de usuario

VALERA

VALERA CT 70A Manual de usuario

Zanussi

Zanussi ZGF 6420 Manual de usuario

Gaggenau

Gaggenau CI 273 Manual de usuario

G3 Ferrari

G3 Ferrari Energy Manual de usuario

Pkm

Pkm IN4B Manual de usuario

Award

Award H903BG Manual de usuario

Zanussi

Zanussi VCH 5005 RZ Manual de usuario

Miele

Miele KM 523 Manual de usuario

AEG

AEG HK854870XB Manual de usuario

Cookology

Cookology SEP600BK Manual de usuario

Bauknecht

Bauknecht Hob Manual de usuario

Zanussi

Zanussi ZGM 782 Manual de usuario

dipo INDUCTION

dipo INDUCTION DIBK218S Manual de usuario

Miele

Miele KM 5987 Manual de usuario

Miele

Miele KM 360 G Manual de usuario

Blomberg

Blomberg MKN 24201 W Manual de usuario