Hotpoint MAC155 Manual de usuario

Portable Air Conditioner,

Dehumidifier, Heater and

Fan

utilizing Heat Pump Technology

OWNER’S MANUAL

Model #: MAC155

Please read owner’s manual carefully before operating unit.

TABLE OF CONTENTS

INTRODUCTION……………………………………………………………………………………………… 3

IMPORTANT SAFEGUARDS…………………………………………………………………………………4

PRODUCT DIAGRAM………………………………………………………………………………………… 5

INSTALLATION……………………………………………………………………………………………… 6

CONTROL PANEL AND MULTI-COLOR DISPLAY………………………………………………………… 9

CONTROL PANEL FUNCTIONS……………………………………………………………………………… 9

OPERATION USING THE CONTROL PANEL…………………………………………………………………11

COOLING………………………………………………………………………………………………… 11

DEHUMIDIFYING………………………………………………………………………………………… 11

FANNING………………………………………………………………………………………………… 11

AUTO MODE……………………………………………………………………………………………… 12

SLEEP MODE…………………………………………………………………………………………… 12

REMOTE CONTROL & OPERATION……………………………………………………………………………13

MAINTENANCE……………………………………………………………………………………………… 15

END OF SEASON STORAGE……………………………………………………………………………… 16

TROUBLESHOOTING………………………………………………………………………………………… 16

ERROR MESSAGES………………………………………………………………………………………… 16

DISCLAIMER………………………………………………………………………………………………… 17

WARRANTY………………………………………………………………………………………………… 18-19

INTRODUCTION

Thank you for purchasing the Portable Air Conditioner. This unit is designed to improve indoor living and

working comfort by providing cooling, dehumidifying, and ventilation with minimal installation.

This multi-functional unit operates as an air conditioner, dehumidifier, heater, and fan. Unlike traditional

portables, there is no bucket to empty. The condensate water is evaporated and removed through the exhaust

duct along with the warm exhaust air. When operating as an air conditioner, this unit is designed for spot

cooling or cooling a room no larger than 550 square feet with a standard eight foot ceiling height. When

using this appliance, always exercise basic safety precautions.

Other air conditioning methods are recommended when the indoor temperature is either below 64°F or above

86°F.

Please complete the following information for future reference. Retain this owner’s manual with your sales

receipt as a permanent record of your purchase.

Serial Number: _________________________________________________________

Date of Purchase: _______________________________________________________

Place of Purchase: _______________________________________________________

IMPORTANT SAFEGUARDS

Before installing and using your portable air conditioner and heater, it is important that you read this owner’s

manual carefully. Store this manual in a safe place for future reference.

This instruction manual is used for guidance and does not form part of a contract. It reserves the right to

make technical changes without prior notice.

1. Always place the unit on a level surface.

2. The appliance shall be installed in accordance with national wiring regulation.

3. The unit must

e connecte

to a correctly grounde

owe

supply. Fo

you

safety, this unit is

grounded through the power cord plug when connected to a grounded wall outlet. Do not use an

adapter plug or extension cord.

4. Do not install the unit in an area where gas leakage may occur and/or in an explosive atmosphere.

5. Do not apply an insecticide or any type of flammable spray on the unit.

6. Confirm drainage piping is connected properly.

7. Do not start or stop the unit by inserting or pulling out the power plug.

8. Do not operate with wet hands.

9. Close supervision is necessary when the unit is use

nea

children. The unit in not intende

use

by children.

10. Do not insert anything into the air outlet. Do not obstruct air inlet or outlet grills.

11. Do not expose skin or eyes directly to cool air for a long period of time.

12. If an abnormal odo

smoke comes out of the unit, disconnect the unit immediately an

contact a

qualified service technician. (see page 13)

13. When opening the filter cover, do not touch the metal parts in the unit’s interior.

14. Do not immerse the unit in wate

any type of liquid. Do not use the unit in the immediate

surroundings of a bath, shower, or swimming pool, or in any other steamy, wet areas.

15. When cleaning the unit, always turn the unit off and unplug the power cord.

16. Always inspect the

owe

cor

signs of damage

efore use. If the

owe

cor

is damaged, it must

be replaced by the manufacturer or a qualified service technician.

17. Do not place a plant or allow a pet in the direct path of the airflow to avoid injury.

18. Do not put a stove, etc, where it would be exposed to the direct airflow. It may affect combustion.

19. Do not sit on the unit or place anything on it.

20. Before storing, the water must be drained from the unit and the filters cleaned.

PRODUCT DIAGRAM

FRONT

A. Control panel

B. l air louvers

C. Hepa

D. Casters

E. Cable(power cord and plug)

BACK

A. In ner filter

B. Inner inhale hole

C. Outer exhaust hole

D. Outer inhale hole

E. Outer filter

ACCESSORIES

Flexible exhaust hose with 2 adapters

• 3-piece set

• stretches from 14 1/4” to60 5/8”

(36cm to 150cm)

Window exhaust adapter

Adjustable window slider kit

• 3-piece set

• adjusts 331/2”to 70” (85cmto 177.8cm)

Drain tube

Drain pan

INSTALLATION

SELECTING THE LOCATION

Place the unit in a flat location where the air

outlets are not obstructed. Place the unit at

least 20” (50cm) awayfrom a wall or other

obstacle.

MOUNTING THE EXHAUST HOSE

Slide the square end of the exhaust duct over

the hot air outlet on the back of the unit.

The exhaust hose should be kept as short and

straight as possible. Prevent any sharp bends in

the exhaust hose, as this will trap hot exhaust

air.

The hot exhaust air can be vented through the

wall or out a window. If mounting in the wall, the

height of the hole should be 16 to 50 inches

(40cm to 130cm).

Ex ha us t Ho se

Hot Air Outlet

WINDOW KIT INSTALLATION

The window kit is designed to fit into most

standard vertical and horizontal windows, as well

as some sliding glass doors. However, it may be

necessary to modify some aspects of the

installation process for certain window types.

1. Open the window or sliding door and adjust

the length of the window kit to fit the

opening. If the window kit is notlong

enough, connect the extra window kit panel

to fit the opening. Mark and cutdown a

single panel of thewindow kit if necessary.

2. Place the window kit between the window

and the window frame as shown in the

images to the right. Close the window onto

the window kit to form a tight seal.

ttach the exhaust duct adapter to the

window kit. Tabs located on the adapter will

lock into place securing the adapter to the

window kit.

CONTROL PANEL

TIMER SWING

°C/°F

SPEED

TIME+

MODE

PURIFY

POWER

This button increases the room temperature/timer hours.

Press this button to oscillate the vertical louvers or to

stop oscillation.

During the modes of cooling ,heating and fanning ,press

this button to choose high,medium or low fan speed.In

dehumidifying mode,this button is inoperable.

Press this button to turn the timer on/off.

This button decreases the room temperature/timer hours.

Press this button to select among the modes of

auto,cooling,dehumidifying,fanning or heating.

Press this button to turn the unit on or off.

FAN SPEED

Button

SWING Button

TEMP- Button

TEMP+ Button

TIMER Button

MODE Button

POWER Button

ONTROL PANEL

TIME+ Button This button increases the timer hours.

°C/°F button press this button change the temperature display °C and

°f .

PURIFY Button After faxing the HEPA ,Unit comes into air purify mode,Press

this button to open and close the unit.

NOTE: UNIT’S MODE BOTTON IS NOT AVAILABLE UNDER THE OPERATION MODE OF AIR PURIFY, OTHER

BUTTON’S FUNCTION IS THE SAMEAS THE OPERATION MODE OFAIR CONDITIONER.

MULTI-COLOR DISPLAY

A. Auto Mode

B. Cool Mode

C. Dehumidify Mode

D. Fan Mode

E. Heat Mode(if only cooling not work)

F. Fan Speed (Low, High, Medium)

G. Compressor is on F

H. Swing Mode

I. Sleep Mode

J. Temperature andTimer

K. Timer On

L. Timer Off

M. Water full

N. Purify

ABCDEN

FHMG I KJL

CONTROL PANEL FUNCTIONS

ON/OFF BUTTON

Starts or stops the unit.

MODE BUTTON

Press to select the operating mode:

Fan Mode

Air Conditioning Mode

Dehumidifying Mode

Auto Mode

FAN BUTTON

Press to select the fan speed: High, Medium, and Low.

The fan speed can be visually distinguished by the number of the digital air segments flow out from the

windmill fan image on the multi-color display.

TEMPERATURE

When in cooling or heating mode, the desired temperature can be selected by pressing the ∧and ∨

buttons. The multi-color display flashes the temperature while it is being set. The multi-color display

shows the set temperature when it is not in temperature setting mode.

The multi-color display can show either Celsius or Fahrenheit. Press the ∧and ∨buttons

simultaneously to change the display from Celsius to Fahrenheit or vice versa.

TIMERTo set the auto start time, press the Timer on button until the multi-color display shows a flashing

“”. Press the ∧and ∨buttons to change the clock to the desired time for the unit to

automatically start. To set the auto stop time, press the Timer Off button and the multi-color display

will show a flashing “ ”. Press the ∧and ∨buttons to change the clock to the desired time

for the unit to automatically stop. The light will flash for 3 seconds to activate the timer you

programmed.

项目符号和

编号

带格式的[微]:

Press time+ button,Timer keep up by unti of 1 hour .The light will flash for 3 seconds to activate the timer

you programmed.

TIME DISPLAY

In the diagram above, the letter “J” points to the adjustable time display. To adjust the time, Press FAN,

SPEED and SWING together (at the same time), then press UP to adjust the hours, and press DOWN

to adjust the minutes.

SWING

To start horizontal oscillation, press the Swing button once. ‘ ’ icon will appear on the multi-color

display. To stop oscillation, press the Swing button again. Vertical air flow direction can be adjusted

manually.

PURIFY

When the hepa be faxed into the unit’s filter , Unit comes into the operation mode of air purify ,press

this button to open and close the unit , “”icon keep light when “”

Keep flame ,means it’s time to change a new hepa for better operation.

NOTE: UNIT’S MODE BOTTON IS NOT AVAILABLE UNDER THE OPERATION MODE OF

AIR PURIFY, OTHER BUTTON’S FUNCTION IS THE SAME AS THE OPERATION MODE

OFAIR CONDITIONER.

Tabla de contenidos

Otros manuales de Acondicionador de aire de Hotpoint

Hotpoint

Hotpoint AH11E09D Instrucciones de funcionamiento

Hotpoint

Hotpoint EWF073CM5WA Manual de usuario

Hotpoint

Hotpoint AH12E07D Instrucciones de funcionamiento

Hotpoint

Hotpoint HTP05 Guía de instalación

Hotpoint

Hotpoint HP21WC-Cooling Only Manual de usuario

Hotpoint

Hotpoint KMH12 Instrucciones de instalación

Hotpoint

Hotpoint KLA 18DA Instrucciones de instalación

Hotpoint

Hotpoint KCD09L Instrucciones de instalación

Hotpoint

Hotpoint MAC140 Manual de usuario

Hotpoint

Hotpoint KLA18DA Manual de usuario

Hotpoint

Hotpoint KX918DS Instrucciones de instalación

Hotpoint

Hotpoint KCM08 Instrucciones de instalación

Hotpoint

Hotpoint KL913AM Manual de usuario

Hotpoint

Hotpoint AH11H09D/E Instrucciones de funcionamiento

Hotpoint

Hotpoint KVM18 Series Instrucciones de instalación

Hotpoint

Hotpoint KVS06 Instrucciones de instalación

Hotpoint

Hotpoint KES15 Guía de instalación

Hotpoint

Hotpoint KNS18 Instrucciones de instalación

Hotpoint

Hotpoint AH11E07D Instrucciones de funcionamiento

Hotpoint

Hotpoint KSL06L Instrucciones de instalación

Hotpoint

Hotpoint AH11H07D Manual de usuario

Hotpoint

Hotpoint KVS08 Manual de usuario

Hotpoint

Hotpoint KED12 Guía de instalación

Hotpoint

Hotpoint KMS06 Instrucciones de instalación

Manuales populares de Acondicionador de aire de otras marcas

Spheros

Spheros CC 355 Manual de usuario

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manual de usuario

Panasonic

Panasonic CS-E12HKEW Manual de usuario

nedis

nedis ACMB1WT7 Manual de usuario

Samsung

Samsung AR KV Series Guía

Daikin

Daikin FCFV50A Manual de usuario

Fujitsu

Fujitsu Inverter ASBA30JFC Manual de usuario

Toshiba

Toshiba RAS-M10SMUV-E Manual de usuario

Daikin

Daikin FXLQ20MAVE Manual de usuario

Hitachi

Hitachi RAS-E24CAK Manual de usuario

CIAT

CIAT Magister 2 Series Guía

Bestron

Bestron AAC6000 Manual de usuario

Hisense

Hisense 7K Manual técnico

Frigidaire

Frigidaire FFRE0533S1E0 Manual de usuario

Samsung

Samsung AS09HM3N Manual de usuario

Frigidaire

Frigidaire CRA073PU11 Manual del propietario

Soleus Air

Soleus Air GB-PAC-08E4 Manual de usuario

McQuay

McQuay MCK020A Manual de usuario