Hoover SmartWash+ FH53000PC Instrucciones de funcionamiento

Service Instructions

Hoover SmartWash- SmartWash Pet

SmartWash Model #: FH52000GB, FH52013, FH52014, FH52050, FH52003VPC, FH52050V,

FH52014V, FH52000V, FH52000VGB, FH52000VFD, FH52001V, FH52040VCD, FH52023V

SmartWash Pet Model #: FH53000, FH53000PC, FH53000PDI, FH53010, FH53040DI, FH53050,

FH53000VPC, FH53050V, FH53050VPD, FH53000V, FH53000VPD, FH53010V, FH53040VCD,

DUFH53000, DUFH53000T, DUFH53000VGL, DUFH53000VTG

TO VIEW PARTS SCHEMATICS PLEASE VISIT “PARTS CATALOG” THROUGH THE DEALER

PORTAL HOME PAGE.

Troubleshooting

A. Unit Leaking

1. Clean Water Tank and Dirty Water Tank are overfilled or not secure.

(1) Check to ensure all tanks are properly filled or empty (dirty water tank)

(2) Ensure the tanks are firmly placed into the unit and there are no gaps or looseness.

2. Dirty Water Tank Lid is not Secure.

(1) Make sure there are no gaps in the dirty water tank. If you see the yellow warning label,

then the lid is NOT properly secured.

3. Check tanks to determine if leaking occurs while installed or removed from unit.

Solution tank does have an amount of residual water when removed from tank resoivour.

Check tank caps to ensure seals are in place and sealing tanks.

4. Check if unit leaks while turned off or while running.

If unit leaks, there could be internal tubing disconnected.

B. Unit Won’t Dispense

1. Clean Water Tank is Empty.

(1) Check to ensure that the Clean Water Tank and solution tank is full of water and securely

locked in place.

2. Make sure the unit is in the correct mode.

(1) The unit will not sipense if in the DRY ONLY mode. Make sure to turn this setting off.

3. The unit is not moving forward or internal board is malfunctioning.

(1) Push unit forward to verify ‘wash’ light is shown and water/solution dispenses. Unit

should only dispense water/solution when moving forward.

4. Unit may need to be flushed.

Add warm tap water to both the clean water tank and the solution tank. Make sure both tanks

are seated firmly, clean any debris from the distributor bar and turn the unit ON, recline the

handle. Push the unit forward continuously about 3-4 times or until water comes out of the

bottom again.

5. Unit may need to be reset.

To reset SmartWash, unplug it from the wall. Remove the nozzle cover and take out the

brushes. Now, replace the nozzle cover, plug the unit back in, and cycle the power on and off

4 times. Replace the brushes and test to see if the reset worked.

C. Accessory Hose/Tool Won’t Dispense

1. Check to ensure that Clean Water Tank and Solution Tanks are full.

2. Ensure there are no clogs in the hose end.

(1) Check both ends of the hose and clean any clogs or debirs you may enocunter.

(2) Insert a small object into the hose solution port to ensure is not clogged.

3. There may be air trapped in the hose and pump. In this case, you will need to prime the pump

by lowering the hose to the floor and holding the trigger for up to one minute.

D. Unit Won’t Pick Up or Has Poor Suction

1. Dirty Water Tank is Full (Float Engaged), the float can also be tripped if the unit is lifted

from the floor while is ON.

(1) Turn off the unit and empty the Dirty Water Tank.

2. The Nozzle is not secure

(1) Pull up on the latch and pull forward to remove the nozzle cover. Check the nozzle

opening for any clogs or blockages. To replace the nozzle cover, line up the two tabs on

the base as well as the tabs close to the opening. Push down and backward until the latch

clicks into place (see photo below).

3. The debris filter is dirty

(1) Remove the debris filter, located under the Dirty Water Tank lid, wipe it clean, and allow

it to air dry before replacing.

4. There is a clog in the tool at the end of the hose.

(1) Remove the tool and clear out any debris.

5. The Unit needs to be reset

(1) To reset the SmartWash, unplug it from the wall. Remove the nozzle cover and take out

the brushes. Now, replace the nozzle cover, plug the unit back in, and cycle the power on

and off 4 times. Replace the brushes and test to see if the reset worked.

E. Brushroll Not Spinning

1. Make sure the unit is NOT in the upright position

(1) If the unit is in the upright position, the brushroll won’t spin. Tilt the unit backwards.

2. The brushroll stall protection has been activated. This happens when the brushroll gets

jammed or clogged.

(1) Turn the unit off and back ON again.

(2) Make sure to remove the brushroll and clean any tangled hair or debris that could be

causing the stall. Temember to clean the notches inside the nozzle too.

F. Unit Not Turning ON

(1) Make sure the unit is firmly plugged into a working outlet.

(2) Check there are no outages or issues with the fuse at the customer’s home

(3) The thermal protector might have activated. The unit does this to prevent damage from

overheating.

(a) Unplug the unit from the outlet.

(b) Clean the dirty and clean water tanks

(d) Allow the unit to cool down for up to 30 minutes. Then plug back ON

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Aspiradora de Hoover

Hoover

Hoover Corded & Cordless Rechargeable Manual de usuario

Hoover

Hoover Power Force HT87-T1-ME Manual de usuario

Hoover

Hoover uh70608 Manual de usuario

Hoover

Hoover SteamVac Dual F7225-900 Manual de usuario

Hoover

Hoover S3825 - Elite Cyclonic Bagless Canister... Manual de usuario

Hoover

Hoover Convrtible U4087 Manual de usuario

Hoover

Hoover UH72400 Manual de usuario

Hoover

Hoover 3010 PERFORMER Manual de usuario

Hoover

Hoover PU71 Manual de usuario

Hoover

Hoover UH73201 Manual de usuario

Hoover

Hoover Tranquility Manual de usuario

Hoover

Hoover F5505 - Steam Vac Spot Convertible Manual de usuario

Hoover

Hoover WindTunnel WindTunnel Bagless Canister Cleaner with Powered... Manual de usuario

Hoover

Hoover SJ60DA/1 Manual de usuario

Hoover

Hoover Xarion Pro Manual de usuario

Hoover

Hoover CH54013 Manual de usuario

Hoover

Hoover POWER SCRUB XL Manual de usuario

Hoover

Hoover U8187 Manual de usuario

Hoover

Hoover SteamJet Cylinder Manual de usuario

Hoover

Hoover H-ENERGY700 Manual de usuario

Hoover

Hoover WindTunnel T1 Series Manual de usuario

Hoover

Hoover SX70HU01 Manual de usuario

Hoover

Hoover ONEPWR Blade+ Manual de usuario

Hoover

Hoover WindTunnel U5471-900 Manual de usuario

Manuales populares de Aspiradora de otras marcas

Bissell

Bissell LittleGreen Proheat 1425 Series Manual de usuario

Panasonic

Panasonic MC-YL637S147-AE Manual de usuario

NEFF

NEFF N17XH10 0 Series Manual de usuario

LG A9 Series Manual de usuario

Oreck

Oreck Cordless Captura BK51700 Series Manual de usuario

Kogan

Kogan KAVACROBVWA Manual de usuario

Kränzle

Kränzle VENTOS 50 ID Guía del usuario

EVVO

EVVO Ai35 Manual de usuario

DeWalt

DeWalt DWH200D Manual de usuario

Pontec

Pontec Pondomatic Vacuum Cleaner Manual de usuario

Cleanmaxx

Cleanmaxx PC-P007E Manual de usuario

Exido

Exido 240-114 Manual de usuario

RIDGID

RIDGID WD1685AU0 Manual de usuario

Ezviz

Ezviz RE4P Manual de usuario

STG global

STG global TANVAC HDV3000 Manual de usuario

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Manual de usuario

Factory

Factory M3340 Manual de usuario

Shop-Vac

Shop-Vac VN92 SERIES Manual de usuario