Honeywell 5816 WMWH Manual de usuario

www.FoxGuardSecurity.com

INSTALL WIRELESS DOOR & WINDOW CONTACTS

INSTRUCTIONS - INSTALLING A WIRELESS CONTACT - HONEYWELL 5816

1- Carefully open the Honeywell 5816 WMWH wireless contact package and lay out all of the

included parts. Locate the gray 3M mounting tape, if purchased.

2- Open the cover of the wireless contact by gently depressing the thumb tab on the one end and

gently pull the cover up.

3- Insert the supplied lithium CR123 battery carefully observing the

polarity, keeping the (+) oriented towards the thumb tab used to

rrelease the contact cover previously removed.

4- Using a #1 ﬂat head or smaller screwdriver, gently depress the

small tab visible on the underside of the contact, to allow the plastic

mounting base to slide off of the Honeywell contact. This mounting base will mount to the door

or window ﬁrst.

5- The contact assembly consists of two (2) main components - the contact itself which contains

a small magnetic reed style switch located near the battery, and a magnet which activates the

switch wswitch when in close proximity. When the switch is activated it is CLOSED The contact itself will

be mounted to either the door or window, and the supplied magnet will be installed on the door

frame/trim or window trim/upper window lip.

6- Using either the supplied double sided tape (GOOD) or 3M gray

double sided tape (BETTER) , attach the appropriate sized

mounting tape to the underside of the mounting base (Approx. 90%

the size of the base) being sure to leave the exposed tape area still

pprotected until you are ready to install.

7- Locate a suitable area on the door or window to be protected,

keeping in mind a few important items:

a) Door- The contact should be mounted on the upper corner of the door, vertically at the

edge so the magnet will be within 1/2” of the contact when mounted on the door trim.

b) Window - On double hung windows the contact can be mounted on the top ledge of the

bottom window, away from the locks or tilting releases, and the magnet can be mounted

Continued...

www.FoxGuardSecurity.com

INSTALL WIRELESS DOOR & WINDOW CONTACTS

INSTRUCTIONS - INSTALLING A WIRELESS DOOR OR WINDOW CONTACT - continued.

b) Window - (continued) on the lower frame of the upper window, aligned with the

mounting base magnet alignment tab.

a) Optional - For a more permanent mounting of the contact, run a small bead of GE

silicone around the base and wipe bead with a wet sponge or paper towel for a clean,

professional ﬁnish.

a) Optional - For a more permanent mounting of the magnet,

run a small bead of GE silicone around the outside and wipe

bead with a slightly wet sponge or paper towel for a clean,

professional ﬁnish.

8- Once a suitable location is determined, remove the protective layer

from the double sided tape on the mounting base, and place the

base on a clean, grease free surface with the magnet

alignment tab facing the direction the magnet will be placed. Optimal

gap between contact and magnet is less than 1/2”. Tap the base

with moderate pressure to help the adhesive ﬁrmly take hold of the surface.

9- Install the cover on the contact by aligning the two tabs on the end opposite of the thumb

release and closing the cover until it locks positively over the release tab.

10- Install the contact on the previously installed base, by aligning the two female mounting

holes with the two male tabs on the base and sliding the contact up or down 1/4” until it locks

over the base plate.

11- Install the supplied magnet on the door frame/trim or window trim by applying the supplied

mounting tape (GOOD) or 3M gmounting tape (GOOD) or 3M gray mounting tape (BETTER) to the bottom of the magnet

mounting base, align with the two small marks on the contact and keep within 1/2” of contact

itself. Be sure magnet or contact will not interfere with opening or closing of the door or window.

12- Be sure to place the small sticker from the side of the contact with

the RFID # a___-_____ on the next page, and keep that page accessible for programming.

DO NOT mix this up with any other contacts RF numbers.

www.FoxGuardSecurity.com

INSTALL WIRELESS DOOR & WINDOW CONTACTS

INSTRUCTIONS - INSTALLING A WIRELESS DOOR OR WINDOW CONTACT

Window 1_______________

Window 2_______________

Window 3_______________

Window 4_______________

Door 4_______________

Door 3_______________

Door 2_______________

Door 1_______________

1- Wireless door & window documentation - use back of page if more zones are needed.

Tabla de contenidos

Otros manuales de Sistema de seguridad de Honeywell

Honeywell

Honeywell TCPA1BS Manual de usuario

Honeywell

Honeywell ADEMCO 745VSD3 Instrucciones de montaje

Honeywell

Honeywell ADEMCO 6150V Manual de usuario

Honeywell

Honeywell Lynx Plus Series Instrucciones de funcionamiento

Honeywell

Honeywell NetAXS NX4S1 Manual de usuario

Honeywell

Honeywell L5200 Series Manual de usuario

Honeywell

Honeywell RCWL200A Manual de usuario

Honeywell

Honeywell Lyric Manual de usuario

Honeywell

Honeywell LYNX Touch Security System Manual de usuario

Honeywell

Honeywell Le Sucre Manual de usuario

Honeywell

Honeywell Galaxy 2 Series Manual de usuario

Honeywell

Honeywell Ademco VISTA-50P Instrucciones de funcionamiento

Honeywell

Honeywell ADEMCO Vista-12C Instrucciones de montaje

Honeywell

Honeywell ADEMCO VISTA-20PSIA Manual de usuario

Honeywell

Honeywell 3-144 Manual de usuario

Honeywell

Honeywell First Alert 145C Manual de usuario

Honeywell

Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security... Instrucciones de montaje

Honeywell

Honeywell Ademco VISTA-20P Instrucciones de funcionamiento

Honeywell

Honeywell SI800M Manual de usuario

Honeywell

Honeywell XC70 Manual de usuario

Honeywell

Honeywell Lynx Plus Series Manual de usuario

Honeywell

Honeywell 4219 Manual de usuario

Honeywell

Honeywell Fire-Lite Alarms W-BG12LX(A) Manual de usuario

Honeywell

Honeywell LYNX Touch Security System Manual de usuario

Manuales populares de Sistema de seguridad de otras marcas

Inner Range

Inner Range Concept 2000 Manual de usuario

Climax

Climax Mobile Lite R32 Instrucciones de montaje

CADDX

CADDX NX-6 Manual de usuario

FBII

FBII XL-31 Series Manual de usuario

Johnson Controls

Johnson Controls PENN Connected PC10 Manual de usuario

Aeotec

Aeotec Siren Gen5 Manual de usuario

Blaupunkt

Blaupunkt SA 2700 Manual de usuario

IDEAL

IDEAL Accenta Manual del propietario

AJAX

AJAX DoubleButton Manual de usuario

Swann

Swann SW-P-MC2 Manual de usuario

Ecolink

Ecolink Siren+Chime Manual de usuario

Digital Monitoring Products

Digital Monitoring Products XR150 Manual de usuario

EDM

EDM Solution 6+6 Wireless-AE Manual de usuario

Highway Safety Group

Highway Safety Group EA401 Manual de usuario

Siren

Siren LED GSM Manual de usuario

Detection Systems

Detection Systems 7090i Instrucciones de montaje

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manual de usuario

Siemens

Siemens FDM273 Manual de usuario