Honeywell HD3VC4SHR Manual de usuario

Document 900.0510 – 05/06 – Rev 1.00

Quick Install Guide

3 Inch Dome Camera

NTSC / PAL

HD3VC4SHR HD3VC4SHRX

HD3VC4SA HD3VC4SAX

Rev 1.00 ii Document 900.0510

05/06

Revisions

Issue Date Revisions

1.00 05/06 New document.

Rev 1.00 iii Document 900.0510

05/06

Warnings

Installation and servicing should be performed only by qualified and

experienced technicians to conform to all local codes and to maintain your

warranty.

WARNING! The Use of CSA Certified/UL Listed Class 2 power

adapters is required to ensure compliance with

electrical safety standards.

WEEE (Waste Electrical and Electronic Equipment). Correct disposal of

this product (applicable in the European Union and other European

countries with separate collection systems). This product should be

disposed of, at the end of its useful life, as per applicable local laws,

regulations, and procedures.

Explanation of Graphical Symbols

RISK OF ELECTRIC

SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE THE COVER.

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL

THIS SYMBOL INDICATES THAT

DANGEROUS VOLTAGE

CONSTITUTING A RISK OF

ELECTRIC SHOCK IS PRESENT

WITHIN THE UNIT.

THIS SYMBOL INDICATES THAT

IMPORTANT OPERATING AND

MAINTENANCE INSTRUCTIONS

ACCOMPANY THIS UNIT.

CAUTION

Rev 1.00 iv Document 900.0510

05/06

FCC Compliance Statement

Information to the User: This equipment has been tested and found to

comply with the limits for a Class A digital device. Pursuant to Part 15 of the

FCC Rules, these limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user will be required to

correct the interference at his own expense.

Caution Changes or modifications not expressly approved by the

party responsible for compliance could void the user’s

authority to operate the equipment.

This Class A digital apparatus complies with Canadian ICES-003.

Manufacturer’s Declaration of Conformance

The manufacturer declares that the equipment supplied with this guide is

compliant with the essential protection requirements of the EMC directive

89/336/EEC and the Low Voltage Directive LVD 73/23 EEC, conforming to

the requirements of standards EN 55013 for emissions.

Rev 1.00 Document 900.0510

05/06

Contents

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Unpack Everything . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

Cautions and Operating Notes . . . . . . . . . . . . . . . . . . . . . . . 2

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Removing the Dome Cover . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Connecting the Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Mounting the Camera. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Adjusting the Camera Position. . . . . . . . . . . . . . . . . . . . . . . . 6

Optional Camera Settings. . . . . . . . . . . . . . . . . . . . . . . . 7

Attaching the Dome Cover. . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Routine Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Product Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Warranty and Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12

Cable Guidelines. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

Rev 1.00 1 Document 900.0510

05/06

Introduction

The unobtrusive, compact design of the HD3VC4S Series CCTV Camera is

ideal for indoor installations in commercial and residential environments.

Before You Begin

Unpack Everything

Check that the items received match those listed on the order form and

packing slip. The HD3VC4S Series 3 Inch Dome Camera packing box

should include, in addition to this Install Guide:

• One fully assembled camera

• One hardware kit

• One 2nd video monitor output cable

• One mounting template

If any parts are missing or damaged, contact the dealer you purchased the

camera from or call Honeywell Customer Service.

Please read this guide carefully before

you install the HD3VC4S Series 3 Inch

Dome Camera. Keep this guide for

future reference.

Rev 1.00 2 Document 900.0510

05/06

Cautions and Operating Notes

Power Supply This dome camera can operate on 24 VAC or 12 VDC.

Operating Conditions Avoid:

• Viewing bright objects (example, light fixtures) for extended periods.

• Operating or storing the unit in the following locations:

• Extremely humid, dusty, hot/cold environments (where the

operating temperature is outside the recommended range of 14°F

to 122°F [-10°C to +50°C])

• Close to sources of powerful electromagnetic radiation, such as

radio or TV transmitters

• Close to fluorescent lamps or objects reflecting light

• Under unstable light sources (may cause flickering)

Rev 1.00 3 Document 900.0510

05/06

Installation

The HD3VC4S Series is a fully-integrated enclosure with camera and lens.

Figure 1 Camera Parts

Legend

1Conduit hole used for surface

run power/video connector

2Camera housing

3Dome cover

4Zoom lever

5Focus lever

aVideo output connector

b24 VAC/12 VDC power input

connector

Note See Figure 5 for an explanation of the camera board settings.

Rev 1.00 4 Document 900.0510

05/06

Removing the Dome Cover

1. Gently turn the dome cover (#5 on Figure 2) counter-clockwise to

unlock and pull free of the housing.

2. Remove the inner liner (#4) by gently pulling it free of the two notches

(#2) in the housing (#1). Set the dome (and liner) aside.

Figure 2 Dome Cover Removal.

Connecting the Wiring

Follow Figure 1 to connect the video output connector (#a) and 24 VAC/12

VDC power connector (#b).

Legend

1Camera housing

2Notches (x2)

3Tilt adjustment bracket and

thumbnuts

4Inner liner

5Dome cover

Rev 1.00 5 Document 900.0510

05/06

Mounting the Camera

1. Place the supplied mounting template (#2 on Figure 3) on the

mounting surface and mark the holes.

2. Drill two holes, then insert the screw anchors (#1) into the holes.

3. Secure the camera housing to the wall with the TP4 x 15 mm tapping

screws supplied (#3).

Note Depending on the material of your mounting surface, you may

require different screws and anchors than those supplied.

Figure 3 Camera Installation

Mounting Template

Logo Direction

MON

1:BLC

2:AGC

3:DC/AES

4:LL

1234

OFF

LEVEL

V PHASE

+ -

TOP

Legend

1Screw anchors (x2), supplied

2Mounting template

3TP4 x 15 mm tapping screws (x2),

supplied

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cámara de seguridad de Honeywell

Honeywell

Honeywell HCD484E Manual de usuario

Honeywell

Honeywell HSGN502 Manual de usuario

Honeywell

Honeywell ACUIX ES Manual del operador

Honeywell

Honeywell HD73 Series Manual de usuario

Honeywell

Honeywell HB273H Manual de usuario

Honeywell

Honeywell HDZ302D Manual de usuario

Honeywell

Honeywell IPCAM-WOC1 Manual de usuario

Honeywell

Honeywell HB75 Manual de usuario

Honeywell

Honeywell EQUIP Series Manual del operador

Honeywell

Honeywell HWC-D101 Manual de usuario

Honeywell

Honeywell HD60 Series Manual de usuario

Honeywell

Honeywell EXPTZ-252A Guía del producto

Honeywell

Honeywell HD4UX Manual de usuario

Honeywell

Honeywell HD273H Manual de usuario

Honeywell

Honeywell HCC334L Manual de usuario

Honeywell

Honeywell Introduces HCC-745PTW Manual de usuario

Honeywell

Honeywell ScanDome iii HSDC-251N/P Manual del propietario

Honeywell

Honeywell 2450Cm Series Manual de usuario

Honeywell

Honeywell HD4USX Manual de usuario

Honeywell

Honeywell PrimaView HD16 Manual de usuario

Honeywell

Honeywell HD251 Manual de usuario

Honeywell

Honeywell HEC12 Manual de usuario

Honeywell

Honeywell GC-715N24 Manual de usuario

Honeywell

Honeywell HD3DSX Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario