Honeywell UMC800 Manual de usuario

Form 51-52-33-100 Page 1 of 3

UMC 800

Operator Interface Disk Drive Assembly

Replacement Instruction

Disk Drive Assembly Kit (Part Number 51404557-501)

Document Number Form: 51-52-33-100

Effective: 6/98

Supersedes: None

Summary Enclosed is a new disk drive assembly for the Operator Interface (OI) of

your UMC 800 Controller. Use the following procedure to install it.

WARNING Never access components inside the operator interface with

power applied.

CAUTION This equipment contains devices that can be damaged by

electrostatic discharge. It is imperative that assemblies containing static-

sensitive devices be carried in conductive plastic bags. When adjusting or

performing any work on such assemblies, grounded work stations and

wrist straps must be used.

Tools Needed You will need a small Phillips-head screwdriver to perform this procedure.

Component Location Refer to Figure 1 for the location of the disk drive assembly and Table 1

for the installation procedure.

OI Housing Disk Drive

Assembly

Screws

(2 places)

J10

J3A

J3B

OI Housing

(Front Panel

Removed)

Figure 1 – Location of Disk Drive Assembly

Kit Instruction, continued

Page 2 of 3 Form 51-52-33-100

Replacement Follow the procedure in Table 1 to upgrade your operator interface to add

Procedure the floppy disk drive feature or to replace the disk drive assembly in the

OI.

Table 1 – OI Disk Drive Assembly Replacement. (Refer to Figure 1.)

Step Action

1Open the door on the righthand side of the OI unit. If OI is equipped with a disk drive,

press the button on the front to eject the diskette from the disk drive.

2Remove power from the operator interface by removing the cable from the back of the unit.

3Remove the front cover by removing two screws at the right, next to the disk drive.

See figure.

ALARM

ESC

1 5

⇐Screw

4Angle the right side of the front panel away from the unit and release it from the hinge at

the left.

5Unplug the following cables from connectors on the CPU board and remove the front panel.

a) OI display cable from J1.

b) Keypad cable from J2.

c) Twisted pair cable from J9.

6Remove two screws securing the disk drive assembly at the top and bottom of the OI

housing.

7Unplug the twisted pair cable from J3B of the CPU board. Carefully slide the disk drive

out of the housing.

8Unplug the following cables from the CPU board and remove the disk drive from the

housing:

a) The ribbon cable from J10.

b) The four-pin connector cable from J6.

Procedure continued on next page

Kit Instruction, continued

Form 51-52-33-100 Page 3 of 3

Table 1 – OI Disk Drive Assembly Replacement. (Refer to Figure 1.), continued

Step Action

9Install the ribbon cable and the power cable (supplied with kit) on replacement disk drive.

10 Plug in the disk drive ribbon cable to J10 on the CPU board.

Plug in the disk drive power cable to J6 (four-pin connector).

11 Carefully slide the disk drive into the OI housing. Plug in the twisted pair cable to J3B on

the CPU board.

12 Secure the disk drive to the housing at top and bottom with two screws.

13 Plug in the cables from the front panel to the following connectors on the CPU board:

a) Twisted pair cable to J9.

b) Flat ribbon cable to J2.

c) Gray ribbon cable to J1.

14 Reattach the front panel to the OI housing by hooking the tabs on the left side of the front

panel and securing it on the right side with two screws.

15 Plug in the DISPLAY cable from the controller into the OI connector at the rear of the

housing.

16 Power up the controller.

Look for start up screen.

Access the SELF-TESTS* screen under the Unit Menu.

Perform the KEYBOARD TEST and DISPLAY TEST to verify OI operation.

Open door on right side of OI front panel. Verify that display message reads “BEZEL

OPEN”.

17 Perform the DISK READ/WRITE TEST to verify OI operation.

* See UMC 800 Operator Interface User Guide, Document Number 51-52-25-62 for

more information on OI self tests and OI operation.

Otros manuales para UMC800

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Controladores de Honeywell

Honeywell

Honeywell UDC120L Manual de usuario

Honeywell

Honeywell L7124U Manual de usuario

Honeywell

Honeywell WEB-700 Manual de usuario

Honeywell

Honeywell MN7505 Manual de usuario

Honeywell

Honeywell homexpert Rondostat COMFORT+ HR30 Manual de usuario

Honeywell

Honeywell N20 Series Manual de usuario

Honeywell

Honeywell V4055A Manual de usuario

Honeywell

Honeywell S8600B Manual de usuario

Honeywell

Honeywell MP953A Manual de operación

Honeywell

Honeywell SLATE Manual de usuario

Honeywell

Honeywell R7426B Manual de operación

Honeywell

Honeywell Excel 50 Manual de usuario

Honeywell

Honeywell HC900 Manual de usuario

Honeywell

Honeywell Pneumatic Controls Manual de usuario

Honeywell

Honeywell HR 10 F Manual de usuario

Honeywell

Honeywell TheraPro HR90 Manual de usuario

Honeywell

Honeywell UDC3200 series Manual de usuario

Honeywell

Honeywell MP953D Manual de instrucciones

Honeywell

Honeywell B Manual de usuario

Honeywell

Honeywell HC900 Guía del usuario

Honeywell

Honeywell UDC3300 Manual de usuario

Honeywell

Honeywell V9055A Manual de usuario

Honeywell

Honeywell Enraf Manual de usuario

Honeywell

Honeywell ML7420A6025 Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario