Hitachi CM 1786M-AD Manual de usuario
COLOUR MONITOR
CM 1786M-AD
17
MVX
VddSupersCan
17s
User’s Manual
:
_
READ THE
INSTRUCTION
INSIDE
CAREFULLY.
KEEP
THIS
USER’S
MANUAL
FOR
FUTURE REFERENCES.
_.’
_.
%,
.,
”
;_’
.:
),. ,
T.
,
;~’
,
,.,.
’
).
‘.,
T,.
,’
,:
For U.K. Customers
THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS
PLUG FOR USE IN MAINLAND EUROPE. FOR THE U.K.,
PLEASE REFER TO THE NOTES ON THIS PAGE.
Note:
Electrical Connection
Your monitor requires an electrical supply of 240 volts
-
50 Hertz and should
be protected by a 5 amp fuse. Your equipment is supplied with a plug
incorporating a 5 amp fuse fitted to the mains lead. If the plug that is fitted
to the equipment is not suitable for your socket outlet, it must be cut off and
the appropriate plug fitted. The cut off plug should be disposed of, do not
insert it into a 13 amp socket to prevent the hazard of electric shocks. With
plugs not incorporating a fuse, the circuit must be protected by a 5 amp fuse.
Warning: This equipment must be earthed.
Important
Your equipment is supplied with a mains lead, the wires of which are
coloured
in accordance with the following code: Green and Yellow
-
Earth,
Blue
-
Neutral, Brown
-
Live.
Green
&
Yellow
to Earth
Blue to Neutral
Brown to Live
Fuse
Cord Clamp
As the
colours
of the wires in your mains lead in this equipment may not
correspond with the markings identified with the terminals of your plug,
proceed as follows:
The wire which is coloured Green and Yellow must be connected to the
terminal in the plug which is marked with the letter E or by the symbol or
coloured Green or Green and Yellow.
The wire which is coloured Brown must be connected to the terminal which
is marked with the letter L or coloured Red.
The wire which is coloured Blue must be connected to the terminal which
is marked N or coloured Black.
The plug moulded on to the cord incorporates a fuse. For replacement, use
a 5 amp BS1326 fuse. Only ASTA approved fuses should be used. The fuse
cover
/
carrier must be refitted when changing the fuse. In the event of
losing the fuse cover
/
carrier, the plug must not be used until a replacement
has been obtained from your nearest electrical
stockist
and fitted. The
colour
of the fuse cover
/
carrier is that of the coloured marks on the insert
in the base of the plug.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Important Safety
Instructions
Read all of these instructions.
Save these instructions for later use.
Follow all warnings and instructions marked on the product.
Unplug this product from the wall outlet before cleaning. Do not use
liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Do not use this product near water.
Do not place this product on an unstable cart, stand, or table. The
product may fall, causing serious damage to the product.
Slots and openings in the cabinet and the back or bottom are provided
for ventilation, to ensure reliable operation of the product, and to
protect it from overheating; these openings must not be blocked or
covered.
The openings should never be blocked by placing the product on a bed,
sofa, rug, or other similar surface. This product should never be placed
near or over a radiator or heat register. This product should not be
placed in a built-in installation unless proper ventilation is provided.
This product should be operated from the type of power source
indicated on the marking label. If you are not sure of the type of power
available, consult your dealer or local power company.
This product is equipped with a three-wire grounding type plug, a plug
having a third (grounding) pin. This plug will only fit into a grounding
type power outlet. This is a safety feature. If you are unable to insert
the plug into the outlet, contact your electrician to replace your
obsolete outlet. Do not defeat the purpose of the grounding-type plug.
Do not allow anything to rest on the power cord. Do not locate this
product where persons will walk on the cord.
If an extension cord is used with this product, make sure that the total
ampere ratings on the products plugged into the extension cord do not
exceed the extension cord ampere rating. Also, make sure that the
total of all products plugged into the wall outlet does not exceed 15
amperes.
12.
Never push objects of any kind into this product through cabinet slots
as they may touch dangerous voltage points or short out parts that
could result in a risk of fire or electric shock. Never spill liquid of any
kind on the product.
13.
Do not attempt to service this product yourself, as opening or removing
covers may expose you to dangerous voltage points or other risks.
Refer all servicing to service personnels.
14. Unplug this product from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
l
When the power cord or plug is damaged or frayed.
lIf liquid has been spilled into the product.
l
If the product has been exposed to rain or water.
l If the product does not operate normally when the operating
instructions are followed. Adjust only those controls that are
covered by the operating instructions since improper adjustment
of other controls may result in damage and will often require
extensive work by a qualified technician to restore the product to
normal operation.
l
If the product has been dropped or the cabinet has been damaged.
lIf the product exhibits a distinct change in performance, indicating
a need for service.
15.
Plug on the power supply cord is used as the disconnect device, the
socket-outlet shall be installed near the equipment and the shall be
easily accessible.
ii
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and
on?
the user is encouraged to try to correct the
interference by one or more of the following measures:
a
Reorient or relocate the receiving antenna.
a
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a
circuit
different from that
to which the receiver is connected.
e
Consult the dealer or an experienced radio/TV technician for help.
Warning: A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It is essential that only the supplied power cord be
used.
Use only shielded cables to connect I/O device to this equipment.
You are cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void your authority to operate
the equipment.
DOC compliance notice
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus as set out in the Radio Interference
Regulations of the Canadian Department of Communications.
DOC avis de conformation
Le present appareil
numerique
n’cmet
pas de bruits radioelectriques
depassant
les limites
applicables
aux appareils numeriques de la Class B
prescrites
dans le reglement sur le brouillage radioclectrique
edict6
par le
MinistrCr des Communications du Canada.
Low Radiation
Following the trend in the computer market toward low radiation, this
equipment has been tested and found to comply with Swedish regulatory
agency guidelines.
Research has shown that magnetic field emissions from computer monitors
may pose a very real health hazard to users, and this has become a great
concern to many people. Consequently, we are offering this low- radiation
display in response to the magnetic field emission issue.
The Swedish guidelines defines a level of induction and strength permissible
for magnetic field emissions. Magnetic field emissions for the equipment is
significantly lower than the Swedish guideline of
25
nT.
Liabiliiy Disclaimer
The product described in this manual is warranted in accordance with the terms of the
applicable manufacturer product specifications. Product performance is affected by
system configuration, software, application, customer data, and operator system control,
among other factors. While the product is compatible with the standards for which they
are advertised, product implementation may vary from user to user.
The suitability of this product for a specific application must be determined by the
customer and is not warranted by the manufacturer. This manual aims to teach the user
how to install and operate the product. The information contained herein is as accurate as
possible; however, updates may have been made since the time of printing. The
manufacturer assumes no responsibilities for damage incurred directly or indirectly from
errors, omissions, or discrepancies between the product and the manual.
Trademarks
Product and brandnames mentioned in this manual are for identification purposes only
and may be trademarks and/or registered trademarks of their respective holders.
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Monitor de Hitachi
Hitachi
Hitachi 32PD5000 Manual de usuario
Hitachi
Hitachi DT3130E Manual de usuario
Hitachi
Hitachi CML153XW Manual de usuario
Hitachi
Hitachi 55PMA550A Manual de usuario
Hitachi
Hitachi CM1785ME Manual de usuario
Hitachi
Hitachi CMP4221 Manual de usuario
Hitachi
Hitachi CML174SXW Manual de usuario
Hitachi
Hitachi StarBoard T-17SXL Manual de usuario
Hitachi
Hitachi CM625ET Manual de usuario
Hitachi
Hitachi CPX2102MS Manual de usuario
Hitachi
Hitachi CPX14QE Manual de usuario
Hitachi
Hitachi CMP421 Series Manual de usuario
Hitachi
Hitachi CMP5000WXJ Manual de usuario
Hitachi
Hitachi PW2 42PD7A10A Manual de usuario
Hitachi
Hitachi CMP4212E Manual de usuario
Hitachi
Hitachi CM811ETPlus Manual de usuario
Hitachi
Hitachi CM2073A Manual de usuario
Hitachi
Hitachi CML181SXW Manual de usuario
Hitachi
Hitachi 42HDM12 Manual de usuario
Hitachi
Hitachi CM621FET Manual de usuario
