HIK VISION DS-19A08-BNG Manual de usuario

Title:

How to Confirm Fault Type When

Control Panel in Zone Fault Status

Version:

v1.0

Date:

7/11/2017

Product:

Alarm Device

Page:

1 of 3

Description

When control panel is in disarm status, it shows “Zone Fault” for some zones. In

this case, control panel can not arm system successfully.

Problem Checking Flow

Zone Fault

Detector is in

alarm

Remove Detector,

Replaced with an

EOL directly

Connect to zone

terminal

Fault

Disappears?

Measure Voltage

between zone’s

terminal Z and G

故障是否消失

Keep Detector in

Normal Statues,

Fault

Disappears?

NO Problem in

Detector and

Control Panel

探测器故障

Detector Fault or

Wiring Fault

总线接线问题

Voltage in

Normal Range Detector Fault or

Wiring Fault

Control Panel Fault

Yes

Title:

How to Confirm Fault Type When

Control Panel in Zone Fault Status

Version:

v1.0

Date:

7/11/2017

Product:

Alarm Device

Page:

2 of 3

Detail Steps

Step 1: Check whether the Detector is in Alarm Status

If detector is in alarm status, eliminate all the factors that will cause alarm for detector.

If detecor still can not go back to normal status, we can confirm it is detector fault; If

detector is in normal status, but control panel is still in “zone fault”, go on next

checking step.

Step 2: Connect Corresponding End of Line Resistor to Terminal Z and G for the

Fault Zone

If “Zone Fault” disappears, we can confirm it is a wiring fault between detector and

control panel. Check wire poor contact, short circuit, open circuit between detector and

control, or signal cable is too close to power cable. After all these wiring issue have

checked, but control panel is still in “zone fault” status, go on next step.

Step 3: Measure Voltage between Z and G for the Fault Zone

According to the chart below, if voltage between Z and G is out of normal range, we

can confirm it is a control panel fault. Please ask technical support team for further

help.

Control Panel Input

Voltage(V)

EOL Resistor(Ω)

Voltage between Z and G

Min

Max

14.3

2.2K

5.6

9.68

3.3K

7.24

11.32

5.6K

8.58

12.66

8.2K

9.34

12.55

10.5

2.2K

4.04

6.98

3.3K

5.21

8.15

5.6K

6.18

9.12

8.2K

6.73

9.05

Note：This voltage range is measured without tamper-proof EOL resistor

Title:

How to Confirm Fault Type When

Control Panel in Zone Fault Status

Version:

v1.0

Date:

7/11/2017

Product:

Alarm Device

Page:

3 of 3

First Choice for Security Professionals

HIKVISION Technical Support

Otros manuales de Sistema de seguridad de HIK VISION

HIK VISION

HIK VISION DS-19A Series Manual de usuario

HIK VISION

HIK VISION DS-2TD6537T-50H4LX/W Manual de usuario

HIK VISION

HIK VISION AX HYBRID PRO Manual de usuario

HIK VISION

HIK VISION AX PRO M2 Manual de usuario

HIK VISION

HIK VISION AX PRO Manual de usuario

HIK VISION

HIK VISION DS-KD8003-IME1 Manual de usuario

HIK VISION

HIK VISION DS-K1T604M Manual de usuario

HIK VISION

HIK VISION Pyronix Enforcer 64 Manual de usuario

HIK VISION

HIK VISION DS-PWA32-HR Manual de usuario

HIK VISION

HIK VISION DS-PEA Series Manual de usuario

HIK VISION

HIK VISION MV-PD030001-01 Manual de usuario

HIK VISION

HIK VISION DS-PHA20-P Manual de usuario

HIK VISION

HIK VISION DS-K3B802BX Series Manual de usuario

HIK VISION

HIK VISION Pyronix Enforcer V10 Manual de servicio

HIK VISION

HIK VISION DS-PWA96-DB-WE Manual de usuario

HIK VISION

HIK VISION DS-MI9605-GA Series Manual de usuario

HIK VISION

HIK VISION Blazer Express 16 Manual de usuario

HIK VISION

HIK VISION NB V6 Manual de usuario

HIK VISION

HIK VISION Blazer Express Station Manual de usuario

HIK VISION

HIK VISION DS-PEA102S Manual de usuario

HIK VISION

HIK VISION ITS Instrucciones de uso

HIK VISION

HIK VISION DS-1901I Guía del administrador

HIK VISION

HIK VISION DS-PEA102S Manual de usuario

HIK VISION

HIK VISION AX PRO Series Guía de instalación

Manuales populares de Sistema de seguridad de otras marcas

Inner Range

Inner Range Concept 2000 Manual de usuario

Climax

Climax Mobile Lite R32 Instrucciones de montaje

CADDX

CADDX NX-6 Manual de usuario

FBII

FBII XL-31 Series Manual de usuario

Johnson Controls

Johnson Controls PENN Connected PC10 Manual de usuario

Aeotec

Aeotec Siren Gen5 Manual de usuario

Blaupunkt

Blaupunkt SA 2700 Manual de usuario

IDEAL

IDEAL Accenta Manual del propietario

AJAX

AJAX DoubleButton Manual de usuario

Swann

Swann SW-P-MC2 Manual de usuario

Ecolink

Ecolink Siren+Chime Manual de usuario

Digital Monitoring Products

Digital Monitoring Products XR150 Manual de usuario

EDM

EDM Solution 6+6 Wireless-AE Manual de usuario

Highway Safety Group

Highway Safety Group EA401 Manual de usuario

Siren

Siren LED GSM Manual de usuario

Detection Systems

Detection Systems 7090i Instrucciones de montaje

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manual de usuario

Siemens

Siemens FDM273 Manual de usuario