Highland MC-K03A Manual de usuario
Single Serve Coffee Maker
MODEL #MC-K03A
ITEM #3738508
866-994-1024
TM
SM21235
HIGHLAND and logo design are trademarks or
registered trademarks of LF, LLC. All rights reserved.
TM
12
1000W
3
4
6
9
11
Package Contents ...........................................................................................................................
Safety Information ...........................................................................................................................
Assembly Instructions ......................................................................................................................
Cleaning and Maintenance ..............................................................................................................
Warranty ........................................................................................................................................
A
B
C
Water Tank Lid
Water Tank
Brew Button
1
1
1
PART DESCRIPTION QUANTITY
D
Cartridge lid 1
E
Cartridge 1
F
Spout 1
G
Cup Tray 1
A
G
E
F
BC
D
1. Read all instructions before using.
2. Do not touch hot surfaces. Use handles and knobs when available.
3. To protect against fire, electric shock and injury to persons do not immerse
cord, plugs, or(state specific part or parts in question) in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near
children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after the
appliance Malfunctions, or has been damaged in any manner. Return
appliance to the nearest authorized service facility for examination, repair or
adjustment.
7. The use of accessory attachments not recommended by the appliance
manufacturer may result in fire, electric shock or injury to persons.
8. Do not use outdoors (this item may be omitted if the product is specifically
designed for outdoor use).
9. Do not let cord hang over edge of table or counter, or touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect, turn any control to “off,”then remove plug from wall outlet.
12. Keep the lid in close poistion, and do't open it during working.
13. Scalding may occur if the lid is removed during the brewing cycles.
Warning: When using the appliance (following also as “the Brewer”) especially
when children are present, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and / or injury to persons, including the
following:
SAVE THESE INSTRUCTIONS
5
14. This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized
outlet only one way. If the plug does not fit fully into the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not attempt to
modify the plug in any way.
a) A short power‐supply cord (or detachable power‐supply cord) is to be
provided to reduce risks resulting from becoming entangled in or tripping over
a longer cord.
b) Longer detachable power‐supply cords or extension cords are available and
may be used if care is exercised in their use.
c) If a long detachable power‐supply cord or extension cord is used:
1) The marked electrical rating of the detachable power-supply cord or
extension cord should be at least as great as the electrical rating of the
appliance;
2) If the appliance is of the grounded type, the extension cord should be a
groundingtype3‐wire cord; and
3) The longer cord should be arranged so that it will not drape over the
countertop or tabletop where it can be pulled on by children or tripped over.
15. Do not use the appliance for other than its intended use.
16. Household Use Only.
17. In order to avoid damage, please use the suitable portion pack in fine quality
and store them with closed package.
18. Fill the Water Tank with fresh water; clean any other washable parts before
beginning brewing coffee.
Unpacking :
Set-up & First brew :
6
1. Plug the appliance into its own grounded outlet. If the electric circuit is
overloaded with other appliance, the Brewer may not function properly.
2. Water quality varies from place to place. For the best tasting gourmet coffee, we
recommend using bottled or filtered water.
3. De-scale the Brewer regularly. Please see the Cleaning and Maintenance
section for instructions.
1. Place the Brewer box on a large steady surface (such as a table or countertop)
or on the floor. Open and turn the box on its side with front of box face down.
2. Reach into the box, carefully grasp and pull the plastic bag out of the box.
Remove the cardboard packaging on both sides of Brewer.
3. Lift plastic bag off Brewer, remove tape holding Water Tank and Brewer head in
place.
Warning: Save all packing materials in case future necessary. Keep all plastic
bags away from children.
Note: Before using the Brewer, please follow the instructions below. The Brewer
will not function properly unless these steps are followed.
1.Fill Water Tank with bottled or filtered
water, and make sure the water level is
higher than the “MIN” line, and does not
exceed the “Max” fill line.
Important: The temperature of the added
water should be below 95˚F. For great
taste, we suggest to use 77˚F water. And,
if the water lever is lower than the “MIN”
line, the brew button will be flashing
speedily as warning.
7
2. Put a mug (10oz. minimum) on the cup
tray.
3. Unwrap cord and plug the Brewer into a
grounded outlet.
4. Place the cartridge to the right position
without portion pack.
5. Press and release the Brew button to turn
on the Brewer (light‐on, and flashing
slowly). The water comes out from the
spout after finishing preheating (about 95s,
light steady). Wait until it auto-stop.
Stopping the brew process:
Turning off :
If you need to stop the brewing after process has started, press and release the
Brew button to turn the Brewer “OFF”. The flow of coffee, tea or hot cocoa will
stop; the heating element will shut off. If any residual water in the tank, be sure to
run a process without portion pack. Please do not reverse the machine for empty.
The Brewer is programmed to automatically power itself off after brewing. To turn
off the Brewer off manually simply press and release the Brew button.
8
6. Remove and dispose of the used portion pack in
time. Enjoy the coffee!
Caution: Portion pack will be hot, wait at least 5
minutes before removing.Caution: To avoid risk
of injury or scald by the hot water, do not take
out the cartridge from the Brewer Head during
the brew process. Once the cartridge is taken
out during the brew process, the brew button will
be flashing speedily as warning, and the hot
water will stop running.
Regular cleaning of the Brewer’s external components is recommended.
1. Never immerse the Brewer in water or other liquids. The housing and other
external components may be cleaned with a soapy, damp, non-abrasive cloth.
2. The cup tray should be periodically inspected and clean by cloth.
The Cartridge can be placed onto the top shelf
of a dishwasher. After cleaning, simply insert
the cartridge back; be sure the cartridge is
firmly in place.
Note: Use low temperature cycles in the
dishwasher.
The exit needle is located on the inside bottom
of the cartridge.Should a clog arise due to coffee
grinds, it can be cleaned using a paper clip or
similar tool. Remove cartridge, insert the paper
clip into the needle to loosen the clog and push
it out.
Caution: There are sharp needles that puncture
the portion pack above the cartridge and in the
bottom of the cartridge. To avoid risk of injury,
do not put your fingers in the cartridge.
9
Cleaning the cartridge
Cleaning the exit needle
CLEANING AND MAINTENANCE
Mineral content in water varies from place to place. Depending on the mineral
content of the water in your area, calcium deposits or scale may build up in your
Brewer. Scale is non-toxic, but left unattended, it can hinder Brewer performance.
De-scaling your Brewer helps maintain the heating element and other internal
parts that come in contact with water.
The Brewer should be de-scaled every 1-2months to ensure optimal
performance. It is possible for calcium deposits to build up faster, making it
necessary to de-scale more often.
1. Pour 10oz. of mix de-scale liquid into the Water Tank. Place a large mug on
the Cup Tray.
2. Do not put any portion pack or coffee grounds, press and release the Brew
button to start the process.
3. Refill the Water Tank with fresh water; repeat the above 3steps for rinsing the
Brewer.
Turn the Brewer off, unplug it and empty the Water Tank before
storing/moving, and take care to ensure that you store your Brewer in a safe
and frost free environment. Please be sure to store/move your Brewer in its
upright position. To avoid any leakage, please run one Rinse cycle before
Storage or Movement.
When you prepare to use it after storage, we recommend rinsing the Water
Tank with fresh water and running 3-5 process without a portion pack.
De-scale the Brewer:
Storage:
10
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
