Before you connect up your system, please ensure that you complete the following:
●Ensure that any manufacturer HDMI link, HDMI control or CEC protocol settings such as Samsung
Anynet Link, Sony Bravia Link, Panasonic Viera Link etc are switched to “off” on both the source
devices and HDTVs that are to be connected to system. This setting is likely to be found in the
HDMI menu settings of the devices you are using.
●After you have changed the CEC setting, switch off all your HDMI source devices and HDTVs and
unplug them from the mains.
●Please ensure that you only connect and disconnect HDMI cables while the central hub and TV
receivers are powered off.
Steps for connecting up your system
1. Power off all products: all source devices, HDTVs and the mHub 2K PoE.
2. Now connect your HDMI source devices to the desired HDMI input ports on the mHub 2K PoE central
hub; 1, 2, 3 or 4, using appropriate HDMI cabling.For Blu-ray 3D, ‘High Speed’ HDMI cables must be
used (usually under 8m in length). Passive (not Active) HDMI cables over 15m in length are not
recommended under any circumstances.
3. Connect your most commonly watched source device to HDMI input 1. It is recommended that if a
Satellite HD Receiver is being used that this is connected to HDMI input 1.
4. If you wish to send 10/100 Ethernet over the Cat cable, then connect one of the Ethernet output
ports of your broadband router to the LAN input port on the central hub using any network cable.
5. Connect any network or LAN connections between the 10/100 Ethernet ports on the TV receivers
(see page 8) and the chosen network devices. i.e. your TVs Ethernet port for smart TV capability
6. Connect HDMI cables between the TV receivers and your chosen TVs / Displays / Projectors on the
first HDMI port.
7. Now connect the Cat cabling from the corresponding TV Receiver locations to the HDBaseT (RJ45) TV
output ports (1, 2, 3 or 4.) (see page 8).
8. Before turning on your system for the first time, go to pages 11 and 12. Read them carefully and
complete all necessary steps.
Notes:
When placing the TV Receivers at your TV locations, please take care not to block the vents on the TV receiver
casing.
HDanywhere product warranty does not cover damage due to electrical disturbances. If possible safeguard
your equipment by connecting all provided power supplies to an electrical surge suppressor / line
conditioner.
10
