Hawking HWREG1 Manual de usuario

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate thisequipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth

for an uncontrolled environment. This equipment should be installed

and operated with minimum distance 20cm between the radiator &

your body.

This transmitter must not be co-located or operating in conjunction with any other

antennaortransmitter.

Table of Contents

Chapter 1 Introduction...................................................................................1

1.1 Package Contents...................................................................................2

1.2 Features.................................................................................................2

1.3 Specifications.........................................................................................2

1.4 Physical Description...............................................................................3

Chapter 2 Wireless Range Extender Connection......................................5

Chapter 3 Wireless Range Extender Configuration.................................6

3.1 Getting Started.......................................................................................6

3.2 Configuring the Range Extender........................................................... 11

3.2.1 Status and Information ....................................................................................... 12

3.2.2 Basic Settings..................................................................................................... 13

3.2.3 Security.............................................................................................................. 18

3.2.4 MAC Address Filtering...................................................................................... 23

3.2.5 Advanced Setting ............................................................................................... 25

3.2.6 System Utility .................................................................................................... 27

3.2.7 Configuration Tool............................................................................................. 30

3.2.8 Firmware Upgrade ............................................................................................. 31

3.2.9Reset................................................................................................................... 31

Chapter 4 Troubleshooting..........................................................................33

Introduction

Chapter 1 Introduction

Congratulations on purchasing your Hi-Gain Wireless-G Range Extender. The

HWREG1 is the simplest way to repeat your wireless network signal for increasing

the range of your network. The advanced features in the second generation Range

Extender from Hawking Technologies will ensure a significant increase in your

wireless operating range as well as the easiest installation possible.

The Hi-Gain Wireless-G Range Extender features support for the latest in wireless

security. WEP, WPA, WPA2 and Radius are all supported by the Range Extender.

The new setup wizard and setup features allow you to simply scan for a wireless

network to extend, select it and you are ready to go.

Whether your application is to eliminate a wireless dead spot within your home or

extend your wireless connection to another room or building, the HWREG1 can

easily double the effective range of your current network.

For more wireless range and distance, upgrading to Hawking’s array of Hi-Gain Wi-

Fi Range Extending Antennas is possible by removing the antenna attached to the

HWREG1 and replacing it.

Introduction

1.1 Package Contents

The Range Extender includes the following items:

ŸOne Hi-GainWireless-G Range Extender

ŸOne Power Adapter

ŸOne Quick Installation Guide

ŸOne CD with Setup Wizard and Users Manual

1.2 Features

ŸComplies with the IEEE 802.11b/g (DSSS) 2.4GHz specification.

ŸHigh data rate 54Mbps network speed.

ŸSeamlessly integrate wireless and wired Ethernet LAN networks.

ŸAuto rate fallback in case of obstacles or interferences.

ŸProvide 64/128-bit WEP,WPAand WPA2 Data Encryption function to

protectwireless data transmissions.

ŸBuilt-in DHCP server supports auto IP addresses assignment.

ŸSupports Web-based configuration.

1.3 Specifications

ŸStandards: IEEE 802.11b/g (Wireless), IEEE 802.3 (Wired)

ŸDataRate: 54/48/36/24/18/12/11/9/6/5.5/2/1Mbps auto fallback

ŸSecurity: 64/128-bit WEP and WPAData Encryption

ŸFrequency Band: 2.400~2.4835GHz (Industrial Scientific Medical Band)

ŸModulation: CCK@11/5.5Mbps, DQPSK@2Mbps and DBPSK@1Mbps

ŸRadio Technology: Direct Sequence Spread Spectrum (DSSS)

ŸAntenna:Externaldetachable dipole antenna (with RP-SMAconnector)

ŸConnectors: 10/100Mbps RJ-45 x 1

ŸPower: 12VDC, 0.5A

ŸTransmit Power: 15dBm (Typical)

ŸLEDs: Power, LANLink/Activity, Wireless Activity

ŸDimension: 30(H) x 127(W) x96(D) mm

ŸTemperature:

Operating: 32~131°F (0~55°C)

Introduction

Storage: -4~158°F(-20~70°C)

ŸHumidity: 10-90% (Noncondensing)

ŸCertification: FCC, CE

1.4 Physical Description

Front Panel

On theRange Extender’s front panel there are LED lights that inform you of the

Range Extender’s current status. Below is an explanation of each LED.

LED Color Status Description

Lit Power is supplied.

PWR Green Off NoPower.

Flash Antenna is transmitting or receiving data.

WLAN Green Off Antenna is not transmitting or receiving data.

On A valid link is established.

Flash It is transmitting or receiving data.

LAN

Link/Activity

Green Off No link is established.

Back Panel

Range Extender’s connection ports are located on the back panel. Below is the

description of each connection port.

Introduction

ŸAntenna Connector (ANT)

This round connection is a standard Reverse SMAantenna connector. The

antenna included in your packaging screws on here. Upgradeable to Hi-Gain

antennas.

ŸDC AdapterPort

Insert thepower jack of the power adapter into this port.

ŸLAN Port

The Range Extender’s LAN port is the connector port for connecting the

HWREG1 to your local network or computer during the setup procedure. (Uses

Included Ethernet Cable)

ŸReset

The Reset button allows you to do one of two things.

1) If problems occur with your Range Extender, press the reset button witha

pencil tip (for less than 4 seconds) and theRange Extenderwill re-boot

itself, keeping your original configurations.

2) If problems persist or you experience critical issuesor have forgotten your

password, press the reset button for longer than 4 seconds and the Range

Extender will reset itself to the factory default settings (warning: your

original configurations will be replaced with the factory default settings).

Wireless LAN Access Point Connection

Chapter 2 Wireless Range Extender

Connection

1. Locate an optimum location for the Wireless Range Extender.

The best locationfor your RangeExtenderis usually at the center ofyour wireless

network, with line of sight to all of your local computers.However, depending on

the application, you may place your Range Extender at any location that is

between your original wireless router or access point and your wireless trouble

spot. Do not place the Range Extender in your desired location yet. You must

first connect it to your network for configuration.

2. Connect the Wireless Range Extenderto your router, hub or switch.

Connect one end of standard Ethernetcable to the Range Extender’s LAN Port

and connect the other end of the cable to a switch, a router or ahub.The Range

Extender will then be connected to your existing Network.

3. Connect the DC Power Adapter to the Wireless Range Extender’s Power

Socket.

Only use the power adapter supplied with the RangeExtender. Using a different

adapter may damage theproduct.

The Hardware Installation is complete.

Hawking Technologies Hi-Gain Wireless-GRange ExtenderConfiguration

Chapter 3 Wireless Range Extender

Configuration

3.1 Getting Started

This Range Extender provides two options for installation: 1)a Web-Based

configuration tool for basic and advanced configurations via a web browser or 2)

basic configurations using a software CD based Setup Wizard. Follow the

instructions below to get started with the Web-Based configuration.(The Quick

Installation Guide covers how to install your product via the Setup Wizard)

From Wired Computer

1. Make sure your wiredcomputer is in the same subnet with the Range Extender.

The default IP Address and Sub Mask of the Range Extender is:

Default IP Address: 192.168.1.235

Default Subnet: 255.255.255.0

Configure your PC to be in the same subnet with theRange Extender.

1a) Windows 95/98/Me

1. Click theStartbutton and selectSettings, then clickControlPanel. The Control Panel

window will appear.

2. Double-click Network icon. TheNetwork window will appear.

3. Check your list of Network Components. If TCP/IP is not installed, click the Add button to

install it now. If TCP/IP is installed, go tostep 6.

4. In the Network Component Typedialog box, select Protocol and click Add button.

5. In the SelectNetwork Protocol dialog box, select Microsoft and TCP/IP and then click the

OK button to start installing the TCP/IP protocol. You may need your Windows CD to

complete theinstallation.

6. After installing TCP/IP, go back to the Network dialog box. SelectTCP/IPfrom the list of

Network Components and then click theProperties button.

7. Check each of the tabs and verify the following settings:

•Bindings: CheckClient for Microsoft Networks and File and printer sharing for

Microsoft Networks.

•Gateway: All fields are blank.

Hawking Technologies Hi-Gain Wireless-GRange ExtenderConfiguration

•DNSConfiguration: SelectDisable DNS.

•WINS Configuration: SelectDisable WINS Resolution.

•IP Address: Select Specify an IP Address. Specify the IP Address and Subnet Mask

as following example.

üIP Address: 192.168.1.235 (any IP address within 192.168.1.2~192.168.1.234 is

available, do not setup 192.168.1.1 or 192.168.1.235)

üSubnet Mask: 255.255.255.0

8. Reboot the PC. Your PC will now have the IP Address you specified.

1b) Windows XP

1: Click the Start button and select Settings, then click Network Connections. The Network

Connections window will appear.

2: Double-click Local Area Connection icon. The Local Area Connection window will appear.

3: Check your list of Network Components. You should seeInternet Protocol [TCP/IP] on your list.

Select it and click the Properties button.

4: In the Internet Protocol (TCP/IP) Properties window, selectObtain an IP address automatically and

Obtain DNS server address a utomaticallyas shown on the following screen.

Otros manuales para HWREG1

Tabla de contenidos

Otros manuales de Extensor de Hawking

Hawking

Hawking HWREG1 Manual de usuario

Hawking

Hawking Hi-Gain HWREN2 Manual de usuario

Hawking

Hawking HWUR54G Manual de usuario

Hawking

Hawking Hi-Gain HD45X Manual de usuario

Hawking

Hawking HWREN1 Rev 1 Manual de usuario

Hawking

Hawking HSB2 Manual de usuario

Hawking

Hawking HSB2 Manual de usuario

Hawking

Hawking HWREN1 Rev 1 Manual de usuario

Hawking

Hawking HSB2 Manual de usuario

Hawking

Hawking Hi-Gain HWREN15 Manual de usuario

Hawking

Hawking HWUR54G Manual de usuario

Hawking

Hawking Hi-Gain HWREN15 Manual de usuario

Hawking

Hawking Hi-Gain HD45X Manual de usuario

Hawking

Hawking Hi-Gain HWABN25 Manual de usuario

Hawking

Hawking HWREN1 Rev 1 Manual de usuario

Hawking

Hawking HWREN1 Rev 1 Manual de usuario

Hawking

Hawking HWUR54G Manual de usuario

Hawking

Hawking HWUR54G Manual de usuario

Hawking

Hawking HWBA54G Manual de usuario

Hawking

Hawking HSB1 Manual de usuario

Hawking

Hawking Hi-Gain HWABN25 Manual de usuario

Hawking

Hawking HOW12ACM Manual de usuario

Hawking

Hawking HWREN25 Manual de usuario

Hawking

Hawking Hi-Gain HWREN1 Manual de usuario

Manuales populares de Extensor de otras marcas

SY HDBT-60T Manual de usuario

Appsys ProAudio

Appsys ProAudio ADX-16 Manual de usuario

Atlona

Atlona RS232 Manual de usuario

IDK

IDK OPF-TH1000-A Manual de usuario

Enable-IT

Enable-IT 824WP Manual de usuario

Worx

Worx Landroid RadioLink WA0864 Hoja de especificaciones

TP-Link

TP-Link TL-WA730RE Manual de usuario

Camplex

Camplex CMX-HDMI-SFPL Manual de usuario

SC&T

SC&T HE03-4K Manual de usuario

Marmitek

Marmitek MegaView70 Manual de usuario

Samsung

Samsung SCS-26UC4 Manual de usuario

Foxun

Foxun SX-GES24 Manual de usuario

MuxLab

MuxLab 500771 Manual de usuario

foxunhd

foxunhd SX-AEX01 Manual de usuario

TERK Technologies

TERK Technologies LFIRX2 Manual de usuario

Devolo

Devolo Audio Extender Manual

Edimax

Edimax EW-7438RPn V2 Manual de usuario

Shinybow USA

Shinybow USA SB-6335T5 Manual de usuario