
Clean your face with cleanser and
spread the lotion* over your entire
face.
・You can use the lotion before, during, and
after irradiation.
*You can use basic skin-care products such as
lotion and cream.
Please connect the AC
adaptor into the device.
Press a button on the control panel to turn
on power.
(1) Go off a startup-sound.
(2) Program number on display monitor. (First time is P01.
Last operation of program number is shown after the 2nd
time.)
※No sound during silent mode.
Please check the program you
use and select the program
with the UP/DOWN button on
the control panel.
(1) Select irradiation program with UP/Down button.
(2) UP button: Click to show P01 to P10 → P01 in order.
(3) DOWN button: Click to show P10 to P1 → P10 in order.
(4) Press START button without select program will start irradiating immediately.
Press SET.SELECT button
for time setting after you
decide the using program.
Please set the time (maximum for 30
minutes) with the UP/DOWN button on
the control panel while checking
displayed monitor for irradiation time.
(1) The initial display shows for default value program (Standard irradiation time). It can be operated
by procedure 7 if there is no change.
(2) The UP/DOWN button can change the irradiation time.
(3) UP Button: Click to show 1 to 30 → 1 in order by every 1 minute.
(4) DOWN Button: Click to show 30 to 1 → 30 in order by every 1 minute.
(5) It memorizes previous action time when you press the start button during set to irradiation time.
(6) It changes configuration of previous action of irradiation program time during irradiation time.
(7) Program number and selecting time on the display-monitor can be confirmed. To do so press the
set button with set to program and time in a series of operations without the UP/DOWN button.
Adjust for irradiation angle
and irradiation distance.
※Please close eyes
even wearing the
goggles.
Please wear the goggles if the
programs require.
Please use Exidéal dedicated goggles when you use
this product.
●Programs that require the goggles
P01, P03, P05, P07, P08, P09, P10
Start irradiation by pressing
the START button. To abort
the program, please press the
START button again.
(1) After setting the irradiation program and time, press the START button to start the program.
Press the start button and the light indicated irradiate (red) will turn on.
(2) Irradiation starts after 5 second countdown on the display monitor when choosing a program that uses
goggles. (Please wear the goggles within the 5 seconds.)
(3) Programs that do not require goggles will start irradiation after pressing the START button.
(4) It shows remaining time on display monitor for 5 seconds during irradiation.
(5) Press the SELECT button during a program stops irradiation with a pause sound. the light indicated irradiate
(red) will flash.
(6) Press the SELECT button again to restart irradiation.
(7) Press the start button during program and pause will stop the program. It becomes possible to reset the
program and irradiation time.
(8) Press the start button memorizes the time of executed program. It always memorizes the previous program
and shows it in the next time primely.
※Silent Mode
(1) Press POWER button, SET, SELECT / II button, START / STOP button at same time.
(2) Press START/STOP button to begin irradiation.
※Please repeat progress (1) to stop silent mode.