Harbor Freight Tools 94723 Guía de referencia rápida

ASSEMBLY & OPERATING INSTRUCTIONS

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web Site at www.harborfreight.com

any artwork contained herein may be reproduced in any shape or form without the

express written consent of Harbor Freight Tools.

For technical questions and replacement parts please call 1-800-444-3353.

94723

Due to continuing improvement, actual product may differ slightly from the product described herein.

UTILITY STOOL

300 LB. MAXIMUM CAPACITY

SKU 94723 For technical questions please call 1-800-444-3353. Page 2

THANK YOU for choosing a HARBOR FREIGHT TOOLS product. For future reference, please

complete the owner’s record below:

Model______________ SerialNo._____________ PurchaseDate_______________

SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the

entire manual to become familiar with the unit BEFORE you begin assembly.

Technical Specifications

Wood Type: 1/2” compressed wood board

Maximum Weight: 300 Lbs. evenly distributed

Weight: 6.35

Assembled Dimensions: 14-1/4” H X 11-1/4” L X 12”W

Tool Holders: 28 for various sizes

Tool Holder Dimensions: 9-1/4” L X 3” Deep

Support Panels: 9” L X 3-5/8” H X 1/2” W

Frame Legs: 13-3/4” H X 1” X 0.04” Thick

InsideBaseArea: 10-7/8” L X 10-1/4” W

Safety Warnings and Precautions

WARNING:When using product, basic safety precautions should always be followed to

reduce the risk of personal injury and damage to equipment.

Read all instructions before using this product!

1. Keep work area clean. Cluttered areas invite injuries.

2. Check for damaged parts. Before using any product, any part that appears damaged should

be carefully checked to determine that it will operate properly and perform its intended function.

Check for any broken or damaged parts and any other conditions that may affect its operation.

Replace or repair damaged or worn parts immediately.

3. Replacement parts and accessories. When servicing, use only identical replacement parts.

Use of any other parts will void the warranty.

4. Always check hardware and assembled parts after assembling. All connections should be

tight and hardware tightened.

5. Keep children away. Children must never play on or climb on the Stool.

6. Dress properly. Gloves are recommended when assembling the Utility Stool. Wear restrictive

hair covering to contain long hair.

7. Use eye protection. Always wear ANSI-approved impact safety goggles when assembling

this product.

8. Maintain product with care. Keep the Stool in a dry location.

SKU 94723 For technical questions please call 1-800-444-3353. Page 3

9. Use the right Stool for the situation. There are certain applications for which this Utility

Stool was designed. Do not modify this Stool and do not use this Stool for a purpose

for which it was not intended.

10. Sit on the Stool in a safe fashion. Make certain that weight on the Utility Stool is evenly

distributed.

11. Do not use or assemble the Stool if under the influence of alcohol or drugs. Read

warning labels on prescriptions to determine if your judgement or reflexes are impaired while

taking drugs. If there is any doubt, do not assemble or use the Stool.

12. Do not exceed the Utility Stool’s maximum weight capacity of 300 Lbs. (evenly

distributed).

WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot

cover all possible conditions and situations that may occur. It must be understood by

the operator that common sense and caution are factors which cannot be built into

this product, but must be supplied by the operator.

Assembly/ Operation

Your Utility Stool will require complete assembly. It is important that you read the entire manual to

become familiar with the product BEFORE you assemble and use the Stool. Before assembling the

Stool be sure that you have all parts described in the Parts List and Assembly Diagram located on

page 5 of this manual.

1. Attach one Leg (4) to each side side of Side Cross Beam (5). Set the Side Cross Beam (5)

against the Leg (4) with bottom holes lined up as shown in Figure 1 and Assembly Diagram.

Secure Leg to Side Cross Beam (5) with two sets of Nuts and Bolts (10). Repeat for second

Side Cross Beam (5) and two Legs (4).

2. Attach

one

Main Cross Beam (6) to each of the sections assembled in Step 1. Secure the

one

Main Cross Beam (6) to the Legs using four sets of Nuts and Bolts (10) -see Figure 1

and Assembly Diagram. Please note: Although the Side Cross Beams (5) and Main Cross

Beams (6) may look identical, the Side Cross Beams (5) are approximately 3/8” shorter.

3. Slide the Bottom Shelf (2) onto the bottom lips of the Main Cross Beam (6) and Side Cross

Beams (5) as assembled in Steps 1 and 2. Make certain that the Bottom Shelf (2) slides in

place under the ends of the Nuts and Bolts (10) as in Figure 1.

Leg (4)

Side Cross Beam (5) Main Cross

Beam (6)

Bottom Shelf (2)

Nuts & Bolts (10)

Figure 1

Foot (7)

SKU 94723 For technical questions please call 1-800-444-3353. Page 4

4. Attach remainsing Main Cross Beam (6) to Legs (4). Secure with Nuts and Bolts (10).

5. Attach Angle Braces (8) to the StoolTop (1) making certain that outside end of Angle

Braces (8) line up with the outside of the Stool Top (1). Screw into place with Screws (9)-

see Figure 2.

6. Use Nylon Nuts and Bolts (10) to attach each Leg (4) to the Angle Braces (8) mounted to the

StoolTop (1)-see Figure 2.

7. Attach theTool Holder (3) to the front of the Utility Stool. Line upTool Holder (3) with the

holes midway up the Legs (4). Secure in place using Nylon Nut and Bolt (11) on each side.

Screw (9)

Nylon Nut and Bolt (11)

StoolTop (1)

Figure 2

Part # Description Quantity Part # Description Quantity

1 StoolTop 1 6 Main Cross Beam 2

2 Bottom Shelf 1 7 Feet 4

3 Tool Holder 1 8 Angle Brace 4

4 Legs 4 9 Screws 4

5 Side Cross Beam 2 10 Nuts & Bolts 16

11 Nylon Nuts & Bolts 6

8. Attach one Foot (7) to the bottom of each Leg (4).

Parts List

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE

TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY

KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS

QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY

STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED

TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER

REPAIRSTOTHE ORIGINAL PRODUCT OR REPLACEMENT PARTSTHERETO, OR ARISING OUT OF HIS OR HER INSTALLATION

OF REPLACEMENT PARTS THERETO.

Angle Brace (8)

SKU 94723 For technical questions please call 1-800-444-3353. Page 5

Parts Diagram

Tabla de contenidos

Otros manuales de Equipos para césped y jardín de Harbor Freight Tools

Harbor Freight Tools

Harbor Freight Tools 40129 Manual de usuario

Harbor Freight Tools

Harbor Freight Tools 90792 Manual de usuario

Harbor Freight Tools

Harbor Freight Tools 97736 Manual de usuario

Harbor Freight Tools

Harbor Freight Tools 93985 Haul-Master Guía de referencia rápida

Harbor Freight Tools

Harbor Freight Tools One Stop Gardens 92151 Guía de referencia rápida

Harbor Freight Tools

Harbor Freight Tools 40052 Manual de usuario

Harbor Freight Tools

Harbor Freight Tools One Stop Gardens 92346 Manual de usuario

Harbor Freight Tools

Harbor Freight Tools One Stop Gardens 94954 Manual de usuario

Manuales populares de Equipos para césped y jardín de otras marcas

Vertex

Vertex 1/3 HP Especificaciones técnicas

GHE

GHE AeroFlo 80 Manual de usuario

Millcreek

Millcreek 406 Manual de usuario

Land Pride

Land Pride Post Hole Diggers HD25 Manual de usuario

extraspace

extraspace GardenStore Manual de usuario

Yazoo/Kees

Yazoo/Kees Z9 Commercial Collection System Z9A Manual de programación

Premier designs

Premier designs WindGarden 26829 Manual de usuario

Snapper

Snapper 1691351 Manual de usuario

Mosquito Magnet

Mosquito Magnet Patriot Manual de usuario

Perfect

Perfect BG2 Manual de usuario

P.Lindberg

P.Lindberg LS2 Manual de usuario

Gardena

Gardena Easy 1887 Manual de usuario

Makita

Makita UM104D Manual de usuario

AQUA FLOW

AQUA FLOW PNRAD Manual de usuario

Tru-Turf

Tru-Turf RB48-11A Golf Green Roller Guía del usuario

BIOGROD

BIOGROD 730710 Manual de usuario

Land Pride

Land Pride RCF2784 Manual de usuario

Makita

Makita UM110D Manual de usuario