Hand Held Products 2020/5620 Guía del usuario

™

IMAGETEAM™ 2020/5620

Cordless System

System Manual

Disclaimer

Hand Held Products, Inc. d/b/a HHP (“HHP”) reserves the right to make changes

in specifications and other information contained in this document without prior

notice, and the reader should in all cases consult Hand Held Products to

determine whether any such changes have been made. The information in this

publication does not represent a commitment on the part of Hand Held Products.

Hand Held Products shall not be liable for technical or editorial errors or

omissions contained herein; nor for incidental or consequential damages

resulting from the furnishing, performance, or use of this material.

This document contains proprietary information which is protected by copyright.

All rights are reserved. No part of this document may be photocopied,

reproduced, or translated into another language without the prior written consent

of Hand Held Products.

Web Address: www.handheld.com

Microsoft Pocket PC 2002, Windows, Windows NT, Windows 2000, Windows ME,

Windows XP, ActiveSync, Outlook, and the Windows logo are trademarks or registered

trademarks of Microsoft Corporation.

The Bluetooth trademarks are owned by Bluetooth SIG, Inc., U.S.A.

Statement of Agency Compliance

The IT2020/IT5620 system meets or exceeds the requirements of all applicable

standards organizations for safe operation. However, as with any electrical

equipment, the best way to ensure safe operation is to operate them according

to the agency guidelines that follow. Please read these guidelines carefully

before using your IT2020/IT5620 system.

Regulatory and Safety Approvals for the IT2020/IT5620

FCC Class B Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class

B digital device pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

•Consult the dealer or an experienced radio or television technician for

help.

Parameter Specification

USA FCC Part 15, Class B

Canada ICES-003

European Community EN 55022 (CISPR 22) Class B

EN60950

EN60825-1

EN55024:1998

If necessary, the user should consult the dealer or an experienced radio/

television technician for additional suggestions. The user may find the following

booklet helpful: “Something About Interference.” This is available at FCC local

regional offices. Hand Held Products, Inc. is not responsible for any radio or

television interference caused by unauthorized modifications of this equipment

or the substitution or attachment of connecting cables and equipment other than

those specified by Hand Held Products, Inc. The correction is the responsibility

of the user. Use only shielded data cables with this system.

In accordance with FCC 15.21, changes or modifications not expressly approved

by the party responsible for compliance could void the user’s authority to operate

the equipment.

This device and its antenna must not be co-located or operating

in conjunction with any other antenna or transmitter. To maintain

compliance with FCC RF exposure guidelines for body-worn

operation, do not use accessories that contain metallic

components and ensure that the device is at least 15mm (0.6

inches) from the body.

Canadian Compliance

This Class B digital apparatus compiles with Canadian ICES-003. Operation is

subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference

that may cause undesired operation.

3. To prevent radio interference to the licensed service, this device is intended

to be operated indoors and away from windows to provide maximum shield-

ing. Equipment (or its transmit antenna) that is installed outdoors is subject

to licensing.

Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du

Canada.

CE Compliance

The CE mark on the product indicates that the system has been tested to

and conforms with the provisions noted within the 89/336/EEC Electromagnetic

Compatibility Directive and the 73/23/EEC Low Voltage Directive.

For CE-related inquiries, please contact:

Hand Held Products, Inc.

Nijverheidsweg 9

5627 BT Eindhoven

The Netherlands

Hand Held Products shall not be liable for use of our product with equipment (i.e.,

power supplies, personal computers, etc.) that is not CE marked and does not

comply with the Low Voltage Directive.

Regulatory Approvals for Bluetooth Radio Devices

RF devices are designed to comply with the most current applicable standards

on safe levels of RF energy developed by the Institute of Electrical and

Electronics Engineers (IEEE) and the American National Standards Institute

(ANSI) and have been recommended for adoption by the Federal

Communications Commission (FCC).

Bluetooth Radio Device R&TTE Compliance Statement

These devices are in conformity with all essential requirements of the R&TTE

Directive (1999/5/EC). This equipment has been assessed to the following

standards:

This product is marked with in accordance with the product

requirements specified in the R&TTE Directive, 1999/5/EC.

The equipment is intended for use throughout the European Community.

Bluetooth Qualified Product

Bluetooth Qualified Body approved as a Bluetooth Class II radio.

Parameter Specification

RF Approvals

U.S.A. FCC Part 15.247

Canada RSS 210

Parameter Specification

R&TTE EN 300 328-2:2000

EN 301 489-1 (2002-08)

EN 301 489-17 (2002-08)

EN 60950:2000

EN 50361:2001

UL and cUL Statement

UL listed UL1950 and CSA 22.2 No.950. cUL listed UL1950 and CSA 22.2 No

950.

TÜV Statement

TÜV or GS marked to EN60950 and EN60825-1.

C-Tick Statement

Conforms to AS/NZS 3548. C-Tick number: N10410.

Mexico

Patents

Please refer to the IT5620 packaging for patent information.

Solids and Water Protection

The IT5620 has a rating of IP41, immunity of foreign particles and dripping water.

Certified

Required Safety Labels

IT5620

FCC ID: HD5MX2702B

Canada IC1693BMX2702B

Hand Held Products, Inc.

Skaneateles Falls, NY 13153

www.hhp.com

"Made in China"

E153740

US and Foreign Patents Pending

0682

I.T.E.

ACCESSORY

7D21

IT2020

Chapter 1 - Getting Started

About This Manual ............................................................... 1-1

Unpacking the System .......................................................... 1-2

Models .................................................................................. 1-2

Cordless System: Main Components.................................... 1-3

About the Battery.................................................................. 1-3

Proper Disposal of the Battery ....................................... 1-4

Base Charge Mode................................................................ 1-5

Linking Scanner to Base....................................................... 1-6

Unlinking the Scanner.................................................... 1-6

Link Modes........................................................................... 1-6

Locked Link Mode......................................................... 1-7

Open Link Mode ............................................................ 1-7

Out-of-Range Alarm............................................................. 1-8

Duration.......................................................................... 1-8

Alarm Sound Type ......................................................... 1-8

Data Accumulation Mode..................................................... 1-9

Beeper and LED Sequences and Their Meaning.................. 1-9

IT5620 LED Sequences and Their Meaning.................. 1-9

IT2020 LED Sequences and Their Meaning.................. 1-9

Basic Operation of the Cordless System ............................ 1-10

System Conditions ....................................................... 1-11

Communication Between the Cordless System and

the Host ........................................................................ 1-12

Connecting the Base When Powered by Host

(Keyboard Wedge)........................................................... 1-12

Reading Techniques............................................................ 1-14

Resetting the Standard Product Defaults ............................ 1-14

Plug and Play ...................................................................... 1-14

Keyboard Wedge Connection............................................. 1-15

Laptop Direct Connect ................................................. 1-15

RS-232.......................................................................... 1-15

Wand Emulation Plug & Play ...................................... 1-16

IBM 4683 Ports 5B, 9B, and 17 Interface .......................... 1-17

Table of Contents

Connecting the Base with USB........................................... 1-18

IBM SurePos ................................................................ 1-19

USB PC or Macintosh Keyboard.................................. 1-19

USB HID ...................................................................... 1-20

USB Com Port Emulation ............................................1-20

Connecting the Base with Serial Wedge............................. 1-21

Chapter 2 - Terminal Interfaces

Terminal ID........................................................................... 2-1

Supported Terminals ............................................................. 2-2

Keyboard Country................................................................. 2-4

Keyboard Style...................................................................... 2-5

Keyboard Modifiers .............................................................. 2-6

Connecting the Base with RS-232 Serial Port ...................... 2-7

RS-232 Baud Rate .......................................................... 2-8

RS-232 Word Length: Data Bits, Stop Bits, and Parity .2-9

RS-232 Handshaking.................................................... 2-10

Host ACK Selection ..................................................... 2-10

Host ACK Enable ......................................................... 2-11

Wand Emulation.................................................................. 2-13

Wand Emulation Connection........................................ 2-13

Wand Emulation Transmission Rate ............................ 2-14

Wand Emulation Polarity ............................................. 2-14

Wand Emulation Idle.................................................... 2-15

Wand Emulation Data Block Size ................................ 2-15

Wand Emulation Delay Between Blocks ..................... 2-15

Wand Emulation Overall Checksum ............................ 2-16

Chapter 3 - Output

Good Read Indicators............................................................ 3-1

Beeper – Good Read....................................................... 3-1

Beeper Volume – Good Read......................................... 3-1

Beeper Pitch – Good Read.............................................. 3-2

Beeper Duration – Good Read........................................ 3-2

LED – Good Read .......................................................... 3-2

Number of Beeps – Good Read...................................... 3-3

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Lector de código de barras de Hand Held Products

Hand Held Products

Hand Held Products IT4000 Manual de uso y cuidado

Hand Held Products

Hand Held Products IMAGETEAM 4410 Manual de usuario

Hand Held Products

Hand Held Products 4800p Manual de usuario

Hand Held Products

Hand Held Products 2020 Manual de usuario

Hand Held Products

Hand Held Products 4820 Manual de usuario

Hand Held Products

Hand Held Products HandHeld 3800 Linear Series Manual de usuario

Hand Held Products

Hand Held Products HandHeld 3800 Linear Series Manual de usuario

Hand Held Products

Hand Held Products Quick Check 200 Series Manual de usuario

Hand Held Products

Hand Held Products HandHeld 3800 Linear Series Manual de usuario

Hand Held Products

Hand Held Products IMAGETEAM 3800E Manual de usuario

Hand Held Products

Hand Held Products 4230 Manual de usuario

Hand Held Products

Hand Held Products DOLPHIN RF Manual de usuario

Hand Held Products

Hand Held Products IMAGETEAM 3800E Manual de usuario

Hand Held Products

Hand Held Products QUICK CHECK 890 Manual de usuario

Hand Held Products

Hand Held Products Valueteam 3060 Manual de usuario

Hand Held Products

Hand Held Products 2020 Guía del usuario

Hand Held Products

Hand Held Products 3200 Manual de usuario

Hand Held Products

Hand Held Products 3800ESD Manual de usuario

Hand Held Products

Hand Held Products 4600g Manual de usuario

Hand Held Products

Hand Held Products HANDHELD 3800G Manual de usuario

Hand Held Products

Hand Held Products IMAGETEAM 3900 Manual de usuario

Hand Held Products

Hand Held Products 4X00 Guía de inicio rápido

Hand Held Products

Hand Held Products IMAGETEAM 4400 Manual de usuario

Hand Held Products

Hand Held Products IMAGETEAM 3800i Instrucciones de instalación y funcionamiento

Manuales populares de Lector de código de barras de otras marcas

POSMicro

POSMicro Datalogic PowerScan D7100 Manual de usuario

Marson

Marson MT780 Guía de configuración rápida

NCR

NCR RealPOS Manual de usuario

Motorola

Motorola SE3300 Guía de configuración rápida

Element

Element P130BT Manual de usuario

Motorola

Motorola Symbol LS3008 Manual de instalación y operación

Meec tools

Meec tools OBD-II / VAG Manual de usuario

SICK

SICK CLP 100 Manual de usuario

Royal Tag SA

Royal Tag SA I-Read Manual de usuario

Welch Allyn

Welch Allyn IMAGETEAM 3800 Manual de usuario

Meteor

Meteor 8310 Manual de usuario

Denso

Denso BHT-500B Manual de usuario

Datalogic

Datalogic Heron HD3130 Manual de usuario

Motorola

Motorola MP6000 Instrucciones de montaje

Newland

Newland NLS-HR15-BT Manual de usuario

ARTDEV

ARTDEV AS-1310 Manual de usuario

Aopos

Aopos AS290 Manual de usuario

ENS

ENS 367-5455 Manual de usuario