Hamilton Beach 840066300 Instrucciones de instalación

840066300

Use & Care for Irons ..........................2

USA: 1-800-851-8900

• During first use of the iron, it may

appear to smoke. This will stop and

does not indicate a defect or hazard.

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS

CONSUMER SAFETY INFORMATION

When using your flat iron, basic safety precautions should always be followed, including

the following:

READ ALL INSTRUCTIONS BEFORE USING

1. Use iron only for its intended use.

2. To protect against risk of electric shock, do not immerse the iron in water or other liquids.

3. The iron should always be turned to OFF (O)before plugging or unplugging from outlet.

Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.

4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away.

Loop cord loosely around iron when storing.

5. Always disconnect iron from electrical outlet when filling with water or emptying and

when not in use.

6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged.

To avoid the risk of electric shock, do not disassemble the iron. Contact an authorized

service facility for information on examination and repair. Incorrect reassembly can cause

a risk of electric shock when the iron is used.

7. Close supervision is necessary for any appliance being used by or near children. Do not

leave iron unattended while connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water, or steam. Use caution when

you turn a steam iron upside down – there may be hot water in the reservoir.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage appliance on the

same circuit.

2. If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords

rated for less amperage may overheat. Care should be taken to arrange the cord so that

it cannot be pulled or tripped over.

This product is intended for household use only.

This appliance is equipped with a polarized plug. This type of plug has one blade wider

than the other. The plug will fit into an electrical outlet only one way. This is a safety feature

intended to help reduce the risk of electrical shock. If you are unable to insert the plug into

the outlet, try reversing the plug. If the plug should still fail to fit, contact a qualified electrician

to replace the obsolete outlet. Do not attempt to defeat the safety purpose of the polarized

plug by modifying the plug in any way.

Use the iron on an ironing board. Ironing on any other surface may damage that surface.

Before First Use:

• Steam vents should be cleaned

before first use. Prepare iron for

steam ironing, then iron over an

old cloth for a few minutes. This

will clean the vents.

• Many irons spit or sputter during

the first few uses with tap water.

This happens as the steam chamber

becomes conditioned. This will stop

after a few uses.

Parts and Features

1. Spray/Blast

2. Adjustable Steam Switch

3. Water Tank Opening

4. Spray Nozzle

5. Water Window

6. Temperature Control Dial

7. Sole Plate

8. Automatic Shutoff

Reset Button and

Power On Light

9. Heel Rest

10. Cord

To Dry Iron

1. Plug in iron.

2. Set the Adjustable Steam Switch

to 0(the Dry

Iron position).

3. Turn Temperature Control Dial to

desired

temperature.

Allow 3 minutes

for iron to

reach desired

temperature.

4. To turn iron OFF, turn Temperature

Control Dial to O. Unplug iron.

Spray/Steam Selector – Turn knob to

select Spray or

Steam. On Spray,

push to release a

fine spray of water

for difficult wrinkles

in cotton or linen.

On Steam, push

for an extra blast

of steam.

Automatic Shutoff Reset Button –

After the iron has

been on for 1 hour,

the orange light

will go out and the

iron will automati-

cally turn off. To

continue ironing,

push the Reset

Button again and

the iron will reset

for 1 hour.

Wrap & Snap Cord – When finished

ironing, let the iron cool then wrap cord

and secure with the Wrap & Snap on

the plug.

Power Light – This red light indicates

the iron is

plugged in.

Adjustable Steam Switch – Set the

switch at 0to dry

iron. Move switch

to steam or

when using blast.

Power

Light

Reset

Button

Features (on selected models)

To Steam Iron

1. Unplug iron. Using a cup, slowly

pour 5 ounces

of tap water

into water

tank opening

as illustrated.

2. Plug in iron.

3. Set the Adjustable Steam Switch to

desired amount

of steam. Turn

the Temperature

Control Dial to

desired setting

in the steam

range.

Opening

4. Allow 3 minutes for the iron to reach

desired temperature.

5. To turn iron off, turn Adjustable

Steam Switch to 0 (Dry Iron). Turn

the Temperature Control Dial to O

(OFF). Unplug iron.

6. Empty water from the iron following

directions in “Caring for Your Iron.”

Water

Please use ordinary tap water. If you

have extremely hard water, alternate

between tap water and distilled water

for use in the iron.

Fabric Setting Chart

To Iron

Off/O

Nylon

Silk

Wool

Polyester

Rayon

Cotton

Linen

Ironing Instructions

Steam Setting

Dry iron on the wrong side of the fabric.

Steam iron on the wrong side of fabric.

Iron with fabric still damp.

Iron on the wrong side of fabric.

Iron while still damp using steam and/or spray.

Iron on wrong side of fabric while still damp.

Troubleshooting

PROBLEM

Iron won’t heat.

Water is leaking

out of the iron.

Iron won’t steam.

Iron leaves spots

on clothing.

Wrinkles not

removed.

Iron too hot.

THINGS TO CHECK

• Is the iron plugged in and the outlet working? Check

the outlet by plugging in a lamp.

• Is the Temperature Control Dial turned to a

fabric setting?

• If auto shutoff model, is the Reset Button light

illuminated? If not, push to reset.

• Do not overfill the water tank.

• If steam ironing, is Adjustable Steam Dial in a steam

position, the Temperature Control Dial in the steam

range, and did the iron have enough time to preheat?

• If dry ironing, make sure the Adjustable Steam Dial is

in the DRY IRON position.

• Check the water level.

• Is the Adjustable Steam Dial in the STEAM position?

• Has the iron had enough time to preheat?

• ALWAYS empty the water tank of the iron after using.

Water left in the tank may discolor clothing and

soleplate.

• Check Temperature Control Dial is set to correct fabric.

• Check Temperature Control Dial and set to lower

setting. Let iron cool down 5 minutes before continuing.

Customer Service

If you have a question about your iron, call our toll-free customer service number.

Before calling, please note the model, type, and series numbers and fill in that

information below. These numbers can be found on the bottom of your iron. This

information will help us answer your question much more quickly.

MODEL: ______________ TYPE: _______________ SERIES: _________________

TWO YEAR LIMITED WARRANTY

Hamilton Beach/Proctor-Silex, Inc. warrants this appliance to be free from defects in

material and workmanship for a period of two (2) years from the date of original purchase,

except as noted. There is no warranty with respect to the following, which may be supplied

with this appliance: glass parts, glass containers, cutter/strainer, blades and/or agitators.

This warranty extends only to the original consumer purchaser and does not cover damage

from abuse, neglect, use for commercial purposes, or any other use not found in the print-

ed directions. HAMILTON BEACH/PROCTOR-SILEX, INC. EXPRESSLY DISCLAIMS ALL

RESPONSIBILITY FOR CONSEQUENTIAL DAMAGES OR INCIDENTAL LOSSES CAUSED

BY USE OF THIS APPLIANCE. Some states or provinces do not allow this exclusion or limita-

tion of incidental or consequential losses, so the foregoing disclaimer may not apply to

you. If you have a claim under this warranty, DO NOT RETURN THE APPLIANCE TO THE

STORE! Please call our CUSTOMER SERVICE NUMBER. (For faster service please have

model, series, and type numbers ready for operator to assist you.)

CUSTOMER SERVICE NUMBERS

In the U.S. 1-800-851-8900

In Canada 1-800-267-2826

Web site address: www.proctorsilex.com

KEEP THESE NUMBERS FOR FUTURE REFERENCE!

This warranty gives you specific legal rights, and you may also have other legal rights

which vary from state to state, or province to province.

Caring for Your Iron

Iron

1. The Water Tank of your iron should

be emptied after each use. Turn

Temperature Control Dial to O.

Unplug the iron and hold over a

sink. Slowly tilt pointed end of iron

down over sink. Water will run out

of water tank opening.

2. After iron has completely cooled,

wrap cord loosely around the iron

and store in an upright position. Do

not store iron laying flat on soleplate.

Soleplate

1. Never iron over zippers, pins, metal

rivets, or snaps, as these may

scratch the soleplate.

2. To clean occasional build-up on the

soleplate, wipe with a sudsy cloth.

Do not use abrasive cleansers or

metal scouring pads.

3. Always store iron upright in the heel

rest position.

Web site address: www.proctorsilex.com

HAMILTON BEACH PROCTOR-SILEX,INC.PROCTOR-SILEX CANADA,INC.

Washington, North Carolina 27889 Picton, Ontario K0K 2T0

12/99

840066300

Tabla de contenidos

Otros manuales de Hierro de Hamilton Beach

Hamilton Beach

Hamilton Beach 840087000 Manual de usuario

Hamilton Beach

Hamilton Beach 14340 - Digital Iron A O Spray Manual del propietario

Hamilton Beach

Hamilton Beach 14289 Manual de usuario

Hamilton Beach

Hamilton Beach 14885C Manual de usuario

Hamilton Beach

Hamilton Beach Durathon 19803 Manual del propietario

Hamilton Beach

Hamilton Beach 10092 Manual del propietario

Hamilton Beach

Hamilton Beach 840105500 Manual de usuario

Hamilton Beach

Hamilton Beach Durathon 19900 Manual de usuario

Hamilton Beach

Hamilton Beach UltraSteam Manual de usuario

Hamilton Beach

Hamilton Beach 840104900 Manual de usuario

Hamilton Beach

Hamilton Beach Easy Fill 19752 Manual de usuario

Hamilton Beach

Hamilton Beach HIR400 - Hospitality Iron 1 EA Manual de usuario

Hamilton Beach

Hamilton Beach 840164201 Manual de usuario

Hamilton Beach

Hamilton Beach Pro SteamMax HB608WB Manual de usuario

Hamilton Beach

Hamilton Beach HIR200R Manual de usuario

Hamilton Beach

Hamilton Beach 840068700 Manual de usuario

Hamilton Beach

Hamilton Beach 14975 - Professional Iron Manual de usuario

Hamilton Beach

Hamilton Beach 14010 Manual de usuario

Hamilton Beach

Hamilton Beach 840154800 Manual de usuario

Hamilton Beach

Hamilton Beach 14280 Manual de usuario

Hamilton Beach

Hamilton Beach 19801 Manual de usuario

Hamilton Beach

Hamilton Beach 840172800 Manual de usuario

Hamilton Beach

Hamilton Beach 14551 Manual del propietario

Hamilton Beach

Hamilton Beach 14506 Manual del propietario

Manuales populares de Hierro de otras marcas

Clatronic

Clatronic DB 3703 Manual de usuario

TEFAL

TEFAL FV4093Z0 Manual de usuario

Gorenje

Gorenje SIH 2200 BS Manual de usuario

Philips

Philips GC6012 Manual de usuario

Bosch

Bosch 2 Series Manual de usuario

Riffel

Riffel Catena KB-819 Manual de usuario

Texi

Texi Hestia Manual de usuario

Maxwell

Maxwell MW-3010 Manual de usuario

TREVIDEA

TREVIDEA Girmi ST60 Manual de usuario

Philips

Philips HI5914/30 Manual de usuario

Primula

Primula Vapormat Manual de usuario

Magio

Magio MG-541 Manual de usuario

Scarlett

Scarlett SC-1334S Manual de usuario

Bosch

Bosch Sensixx B22L Manual de usuario

Philips

Philips GC651 Manual de usuario

Vitek

Vitek VT-1247 VT Manual de usuario

Cleanmaxx

Cleanmaxx 3397 Manual de usuario

Philips

Philips GC800 Manual de usuario