Hama TS39H Manual de usuario

185850

TS39H

Outdoor Sensor

Außensensor

RUS

FIN

Instrukcja obsługi

Használati útmutató

Manual de utilizare

Návod kpoužití

Návod na použitie

Manual de instruções

Bruksanvisning

Руководство по эксплуатации

Работна инструкция

Οδηγίες χρήσης

Käyttöohje

Operating Instructions

Bedienungsanleitung

Mode d‘emploi

Instrucciones de uso

Gebruiksaanwijzing

Istruzioni per l‘uso

GOperating instruction

Controls and displays

1. Temperatureindicator

2. Air humidity indicator

3. Celsius /Fahrenheit setting key

4. Channel setting key

5. Battery compartment

6. Cut-out for wall mounting

Thank you for choosing aHama product.

Take your time and read the following instructions and information

completely.Please keep these instructions in asafe place for futurereference.

If you sell the device, please pass these operating instructions on to the

new owner.

1. Explanation of warning symbols and notes

Warning

This symbol is used to indicate safety instructions or to draw your attention

to specichazards and risks.

Note

This symbol is used to indicate additional information or important notes.

2. Package contents

•TS39H outdoor sensor

•These operating instructions

3. Safety instructions

•The product is intended for private, non-commercial use only.

•Do not operate the product outside the power limits specied in the

technical data.

•Do not use the product in adamp environment and avoid splashing water.

•Do not use the product in the immediate vicinity of heaters, other heat

sources or in direct sunlight.

•Do not use the product in areas in which electronic products arenot

permitted.

•Do not place the product near interference elds, metal frames,

computers, TVs, etc. Electronic devices and window frames can negatively

affect the product’sfunctionality.

•Do not drop the product and do not expose it to any major shocks.

•Do not open the device or continue to operate it if it becomes damaged.

•Do not attempt to service or repair the product yourself.Leave any and all

service work to qualied experts.

•Keep the packaging material out of the reach of children due to the risk

of suffocation.

•Dispose of packaging material immediately in accordance with the locally

applicable regulations.

•Do not modify the product in any way.Doing so voids the warranty.

•Protect the product from dirt, moistureand overheating and use it in dry

environments only.

•As with all electrical products, this device should be kept out of the reach

of children.

•Only use the article under moderate climatic conditions.

•Use the product only for the intended purpose.

Warning -Batteries

•When inserting batteries, note the correct polarity (+ and -markings)

and insert the batteries accordingly.Failure to do so could result in the

batteries leaking or exploding.

•Only use batteries (or rechargeable batteries) that match the specied

type.

•Beforeyou insert the batteries, clean the battery contacts and the

polarity contacts.

•Do not allow children to change batteries without supervision.

•Do not mix old and new batteries, or batteries of different types or from

different manufacturers.

•Remove the batteries from products that arenot being used for an

extended period (unless these arebeing kept ready for an emergency).

•Do not short-circuit batteries.

•Do not charge batteries.

•Do not burn batteries.

•Keep batteries out of the reach of children.

•Never open, damage or swallow batteries or allow them to enter

the environment. They can contain toxic, environmentally harmful

heavy metals.

•Remove spent batteries from the product and dispose of them without

delay.

•Avoid storing, charging and using in extreme temperatures and at

extremely low atmospheric pressures (such as at high altitudes).

4. Getting started

•Open the battery compartment (5) and insert two AA batteries observing

the correct polarity.

•Inside the battery compartment, you will also nd the channel setting

switch (4) that allows you to switch between channels "CH1, CH2 and

CH3". Press the button (4) until the desired channel has been set. The

display (1) shows CH1, CH2 or CH3.

•Then close the battery compartment cover.

Changing batteries

•Open the battery compartment (5), remove and dispose of the spent

batteries and insert two new AA batteries observing the correct polarity.

Then close the battery compartment cover.

Note

Please remember,during commissioning, to always insert the batteries

into the measuring station rst and then into the base station.

5. Installation

Note -Installation

•We recommend initially positioning the base station and measuring

station at the preferred setup locations without installing them and

carrying out all the settings -asdescribed in 6. Operation.

•Do not install the station(s) until the settings arecorrect and the radio

connection is stable.

Note

•The range of the radio transmission between the measuring station and

the base station is up to 30m in unobstructed areas. Beforeinstalling,

make surethat the radio transmission is not inuenced by interfering

signals or obstacles such as buildings, trees, vehicles, high-voltage

power lines, etc.

•Before nal installation, make surethat thereissucient reception

between the desired installation locations.

•When installing the measuring station, take caretoensurethis is

positioned so that it is protected from direct sunlight and rain.

•The international standardheight for measuring air temperatureis1.25

m(4ft) above ground.

Warning

•Buy special or suitable installation material from aspecialist dealer

for wall-mounting.

•Ensurethat you do not install any faulty or damaged parts.

•Never apply force during installation. These can damage the product.

•Beforemounting, check that the wall you have chosen is suitable for

the weight to be mounted. Also make surethat thereare no electric,

water,gas or other lines running through the wall at the mounting site.

•Do not mount the product above locations wherepersons might sit

or stand.

•We recommend mounting the measuring station securely and rmly onto

an outdoor wall.

•Securethe dowel, screw,nail, etc. in the wall provided.

•Hang the measuring station onto it using the cut-out (6) provided.

6. Operation

6.1. Connection to the measuring station

•Place both devices as close together as possible to connect the base

station and the measuring station with each other.

•After the batteries areinserted, the base station automatically searches

for aconnection to the measuring station and carries out the initial

setup routine.

•If the device does not connect automatically,the manual search process

must be started on the base station.

Note

•Initial setup takes around 3seconds.

•The radio symbol on the measuring station ashes during the

connection attempt.

•Avoid any operation of the buttons during this time! Otherwise, errors

and inaccuracies may occur in the values and their transmission.

•The process is nished as soon as the indoor and outdoor measurement

data aredisplayed on the base station.

•The measured value is automatically updated by the base device about

every 30 seconds.

•If the temperaturevalue is outside of the measuring range, LLL.L (for

temperatures below the measuring range) or HH.H (for temperatures

above the measuring range) will be displayed in the temperature

indicator.

6.2. Channel selection/additional measuring stations

Note

•When doing so, ensurethe same channel setting on the base station

and each measuring station. Suitable base stations can be found at

www.hama.com

•The transmitter channel of the supplied measuring station can be

changed/set (CH1, CH2, CH3).

•The measuring station is suitable for the following base stations:

186380, 186412

6.3.

Low battery

Measuring station

If the batteries need to be replaced, the icon for the low battery level appears

next to the outside temperatureindicator of the base device .Change

the battery immediately.

Note -Changing the batteries

•Be awarethat, after every battery change on the measuring station or

base station, the stations will need to be resynchronised.

•To do this, remove the batteries from the other station and re-insert

them or change them completely if required.

7. Care and maintenance

•Only clean this product with aslightly damp, lint-free cloth and do not use

aggressive cleaning agents.

•Ensurethat no water is able to enter the product.

8. Warranty disclaimer

Hama GmbH &CoKG assumes no liability and provides no warranty for

damage resulting from improper installation/mounting, improper use of

the product or from failuretoobserve the operating instructions and/or

safety notes.

9. Technical data

Measuring station

Power supply 3.0 V

2xAAbatteries

Measuring range

Thermometers

Hygrometer

-20°C –+60°C /

-4°F –140°F /

20% –95%

Measuring increments

Temperature

ambient humidity

0.1°C /0.2°F

Measuring cycle

Thermometer/

Hygrometer

CH1: 57 s

CH2: 67 s

CH3: 79 s

Hygrometer Yes

Thermometers Yes

Frequency 433 MHz

power transmitted 60 µW

Range ≤60 m

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Accesorios de Hama

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario