Hama TS34A Manual de usuario

RUS

Operating Instructions

Bedienungsanleitung

Mode d‘emploi

Instrucciones de uso

Руководство по эксплуатации

Istruzioni per l‘uso

Instrukcja obsługi

Návod kpoužití

Návod na použitie

Manual de utilizare

176931

TS34A

Outdoor Sensor

Außensensor

REMOTE SENSOR

RF WIRELESS

°C

REMOTE SENSOR

RF WIRELESS

°C

GOperating instruction

Controls and Displays

AMeasuring station

1. LED indicator

2. Battery compartment

3. CHANNEL slide switch =selects channel

4. Recess for wall mounting

5. LCDdisplay

Thank you for choosing aHama product.

Take your time and read the following instructions and information

completely.Please keep these instructions in asafe place for future

reference. If you sell the device, please pass these operating instructions

on to the new owner.

1. Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructions or to draw your

attention to specic hazards and risks.

Note

This symbol is used to indicate additional information or important

notes.

2. Package Contents

•TS34A Outdoor Sensor

•These operating instructions

3. Safety Notes

•The product is intended for private, non-commercial use only.

•Do not operate the product outside the power limits given in the

specications.

•Do not use the product in moist environments and avoid splashes.

•Do not use the product in the immediate vicinity of heaters or other

heat sources or in direct sunlight.

•Do not use the product in areas wherethe use of electronic devices

is not permitted.

•Do not put the product near interference elds, metal frames,

computers, TVs, etc. Electronic devices and window frames can

negatively affect the product’sfunctionality.

•Do not drop the product and do not expose it to any major shocks.

•Do not open the device or continue to operate it if it becomes

damaged.

•Do not attempt to service or repair the product yourself.Leave any and

all service work to qualied experts.

•Keep the packaging material out of the reach of children due to the

risk of suffocation.

•Dispose of packaging material immediately according to locally

applicable regulations.

•Do not modify the product in any way.Doing so voids the warranty.

Warning –Batteries

•Immediately remove and dispose of dead batteries from the

product.

•Only use batteries (or rechargeable batteries) that match the

specied type.

•Do not mix old and new batteries or batteries of adifferent type

or make.

•When inserting batteries, note the correct polarity (+ and -

markings) and insert the batteries accordingly.Failure to do so

could result in the batteries leaking or exploding.

•Do not overcharge batteries.

•Keep batteries out of the reach of children.

•Do not short circuit the batteries/rechargeable batteries and keep

them away from uncoated metal objects.

4. Getting started

•Unscrew the screws on the battery compartment (2) on the back of the

measuring station and open it.

•Move the CH slide switch (4) to the left or right to select the channel

on which the measuring station transmits.

•Insert two AAA batteries with the correct polarity.

•Then close the battery compartment cover.

Replacing the batteries

•Open the battery compartment (2), remove and properly dispose of

the dead batteries and insert two new AAA batteries with the correct

polarity.Then close the battery compartment cover.

Note

Beforeuse, make surethat you insert the batteries in the measuring

station rst and then in the base station.

5. Installation

Note –Installation

•We recommend initially placing the base and measuring stations

in the intended locations without installing them and making all

the settings described in 6. Operation.

•Only install the stations once the appropriate settings have been

made and astable wireless connection is established.

Note

•The wireless transmission range between the measuring and base

stations is up to 30 metres in open spaces.

Beforeinstallation, ensurethat wireless transmission will not

be disrupted by interference or obstacles like buildings, trees,

vehicles, high-voltage lines, etc.

•Beforethe nal installation, ensurethat thereissucient

reception between the intended installation locations.

•When installing the measuring station, ensurethat it is protected

from direct sunlight and rain.

•The international standardheight for measuring air temperatureis

1.25 m(4ft) above ground.

Warning

•Buy special or suitable installation material from aspecialised

dealer for wall-mounting.

•Ensurethat no faulty or damaged parts areinstalled.

•Never apply force during installation. This could damage the

product.

•Beforeinstallation, ensurethat the chosen wall is suitable for

the weight to be installation, and make surethat thereare

no electrical wires, water,gas or other lines in the wall at the

installation site.

•Youcan position the measuring station on alevel outdoor surface

using the base.

•We recommend installing the measuring station securely on an

outdoor wall.

•Install an anchor,screw,nail, etc. in the wall of your choice.

•Hang the measuring station using the opening intended for this

purpose (4).

6. Operation

6.1. Connection to the measuring station

•To connect the base station and the measuring station, place the two

devices as close together as possible.

•After you insert the batteries, the base station automatically searches

for aconnection to the measuring station and performs initial setup. If

the device does not connect automatically,the manual search program

on the base station must be started.

Note

•Initial setup takes approximately 3minutes.

•During the connection attempt, the radio symbol and the LED

indicator (1) on the measuring station will ash.

•Do not press any buttons during setup. Otherwise, values may

not be transmitted correctly and thereisarisk of value errors and

inaccuracies.

•The setup process is completed when the indoor and outdoor

measurement data is displayed on the base station.

•The measured value is automatically updated by the base device

about every 57 seconds.

6.2. Selecting the channel/Other measuring stations

Note

•Youcan connect up to three different base stations to the

measuring station. Ensurethat the base station and measuring

station areset to the same channel. Suitable base stations can be

found at www.hama.com

•The transmission channel on the supplied measuring station can

be changed/set (CH1, CH2, CH3).

•The measuring station is suitable for the following base stations:

76045, 113964, 123126, 123127,123128, 123129, 136256,

136257, 136258, 136259

6.3. Low battery charge

Note –Replacing the batteries

•Note that the stations have to be resynchronised each time after

you change the batteries in the measuring or base station.

•To do this, remove the batteries from the other station and then

reinsert them, or change them as required.

7. Care and Maintenance

•Only clean this product with aslightly damp, lint-free cloth and do not

use aggressive cleaning agents.

•Make surethat water does not get into the product.

8. Warranty Disclaimer

Hama GmbH &CoKG assumes no liability and provides no warranty for

damage resulting from improper installation/mounting, improper use of

the product or from failuretoobserve the operating instructions and/

or safety notes.

9. Service and Support

Please contact Hama Product Consulting if you have any questions about

this product.

Hotline: +49 9091 502-115 (German/English)

Further support information can be found here:

www.hama.com

Otros manuales para TS34A

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Accesorios de Hama

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario