Haier HP200S1 Hoja de especificaciones

Heat pump Water Heater

Operation and Installation Manual

Model

HP200S1

HP300S1

Please read this manual carefully prior to

your use of this water heater.

The appearance of the water heater given

in this manual is for reference only.

English

ELECTRICITE

English

Operation and functions

Display

:/3+8

9+:

(559:

35*+

BOOST

SET

ACT

START

STOP

VAC

ERROR

ECO ECO+

AUTO

HP HC

SET

ACT

Symbol Description

Timer adjust:press this key, then Press the + and - to adjust the

time.

Power ON/OFF switch

When turned oﬀ, the display shows the time and the actual water

temperature. When turned on, the display shows the working

mode.

The default temperature setting is 55°C in the factory. It can be

adjusted simply by pressing + & - directly on the default display.

Working mode selection:Press the key, the AUTO mode, ECO

mode, ECO+ mode,VAC mode is displayed in turn.

Press SET or wait 6 seconds the mode is selected.

Conﬁrm button

Turn on or oﬀfast heating function：Heat pump and Auxiliary

electrical heater are activated at same time.

Description of the pictograms

- In this mode ,priority using heat pump,start the Auxiliary

electrical heater only in oﬀ-peak time;

- In two ways using heat pump,should set in the installer

settings in advance ;

01- timer refer to LP parameter;

02-switch signals by power companies.

- In 01 mode, Press SET, press + and - to set Start time of ﬁrst

Low price L1. Than,set Colsed time of L1.

And than, press SET, to deﬁned for L2.

- In 02 mode, HC light up in Time of use hours, HP light up in

Peak hours.

ECO (oﬀ-peak) mode

Symbol Description

Auto mode

-Optimised management of the heat pump and the electrics

for guaranteed comfort；

- Prior using heat pump;

- If compressor works more than the default 8 hours , start

the auxiliary power；

- The compressor maximum continuous working time( )

can be adjust in the installer settings.

Description of the pictograms

- In this mode ,priority using heat pump, heat pump and Auxiliary

electrical heater are activated only in oﬀ-peak time;

- In two ways using heat pump,should set in the installer

settings;

01- timer refer to LP parameter;

02-switch signals by power companies.

- In 01 mode, The Start time and Colsed time settings as the

ECO (oﬀ-peak) mode .

ECO+ (oﬀ-peak) mode

- According to the vacation dates in advance to prepare

hot water;

- For example, you leave home for vacation on January 1st and

return home on January 5th. The date shall be set as

(5-1) =4 days, and corresponding temperature shall also be set.

The heat pump will start heating on 00:00 o’clock of January

5th automatically.

Holiday mode

English

Symbol Description

Description of the pictograms

Hot water volume display.

Boost mode. Heat pump and Auxiliary electrical heater

are activated at the same time.

Heat pump working icon．

Auxiliary electrical heater working icon．

Time of peak/oﬀ-peak hours. In Time of peak/oﬀ-peak hours

mode, the symbol corresponding to the mode is displayed.

Alarm display icon．

Anti-legionella

- Anti-legionella function will be activated every 7 days to

heat the tank to 65°C automatically .

Note: Under certain conditions, ECO mode and ECO+ mode may result in shortages of hot

water (mainly due to air temperatures outside the operating range).

Operating functions

Installer settings

Parameters

Description

- To open the installer settings, press switch oﬀthe system, then press and

at the same time for 10 seconds.

- When menu is open, press or to change the value of the settings.

- Press to conﬁrm the settings.

- Press to close the menu.

Oﬀ-peak signal type

Oﬀ-peak logic type

When you use oﬀ-peak time clock control, ﬁrst determine

the type of signals,Only allow professional installers to operate.

- In two ways using heat pump,should set in the installer

settings

-01 manually set oﬀ-peak time;

-02 switch signals by power companies.

NO , NC

01 , 02

ON , OF

8h 5-10h

Compressor maximum continuous working time

- If

the maximum continuous working time

of the

compressor

more than Set Time, start auxiliary power.

Factory

setting

Adjustment

range

Avoid Legionella

- This parameter is used to activate the legionella protection

mode.

- Once every 7 days, all domestic hot water is heated to 65℃.

- NO corresponds to Normally Open Signal.

- NC corresponds to Normally Close Signal.

Auxiliary Heating in oﬀ-peak time

- ON corresponds to turned on uxiliary Heating.

- OF corresponds to turned off uxiliary Heating.

ON ON , OF

English

Checking and maintenance

Checking of the Safety valve

- Installation and maintenance of the appliance must be done by a qualiﬁed

professional .

- Before working on the appliance,Shut down the machine and cut oﬀthe power

supply .

- Do not touch with wet hands.

- Maintenance operations are important to guarantee optimum performance

and extend the life of the equipment.

Checking of the hydraulic circuit

Cleaning of the fan

- Check the watertightness of the water connections.

- Because the evaporator ﬁns is very sharp.Risk of injury on your ﬁnger.

- Do not damage the ﬁns. Avoid aﬀecting the performance.

- Check the cleanliness of the fan one time per year.

Checking of the evaporator

- Clean the evaporator at regular intervals using a soft-haired brush.

- If they are bent.Carefully realign the evaporator using a suitable comb.

- Operate the safety valve at least once a month to check if it is running

correctly. Otherwise check for blocking and replace the safety valve if necessary.

Checking of the condensates discharge pipe

Checking of the Magnesium rod

- Check the pipe cleanliness .

- An obstruction by dust may cause poor condensates ﬂow or even a risk accumulation of

water in the heat pump plastic base.

- The magnesium anode should be replaced in time, avoid tank corrosion.

- Checking magnesium anode once every 2 years .In poor water areas need to shorten the

time.

Drain the water tank to empty

-Cut oﬀpower supply and shut down water inlet valve, then drain the water tank to empty

via the sewage outlet. Please stay away from the sewage outlet if there is hot water inside

the water tank to avoid injury.

English

Faults and protection

Digital

indication Release

Compressor protection

Operating temperature protection

After fault is solved,

switch on power

supply for release

Air exhaust temperature protection

Evaporation high temperature

protection

Compressor over-current

protection Over-current protection

Electricity leakage alarming The system will automatically cut oﬀ

power supply if any line fault occurs E1

After fault is solved,

switch on power

supply for release

Over temperature alarming The actual water temperature≥85℃E2

Fault of the inner

temperature sensor

If short circuit or circuit break occurs

to the sensor E3

Fault of the ambient

temperature sensor

If short circuit or circuit break occurs

to the sensor E4

Fault of the evaporation

temperature sensor

If short circuit or circuit break occurs

to the sensor E5

Fault of the air exhaust

temperature sensor

If short circuit or circuit break occurs

to the sensor E6

Communication fault Communication of main control panel

and display panel is abnormal E7

Pressure switch protection Action of the pressure switch at the

exhaust outlet E8

Ambient temperature

protection

Ambient or outdoor temperature

<-7℃or>45℃E9

The symbol on the product or on its packaging indicates that this product is

not to be treated as regular household waste. Instead, it must be taken to a

recycling collection point for electrical and electronic equipment. By properly

disposing of this product, you are contributing to the preservation of the

environment and the wellbeing of your fellow citizens. Improper disposal is

hazardous to health and environment. You can obtain further information on how to

recycle this product from your municipality, your waste management service or the

shop where you purchased it.

Fault type Action

Fault of the Off-peak power

switching signal

If not received the Off-peak signal

when selecting switch signals by

power companies

Fault of the air intake

temperature sensor

If short circuit or circuit break occurs

to the sensor ED

English

Otros manuales para HP200S1

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Calentador de agua de Haier

Haier

Haier S110ENF Manual de usuario

Haier

Haier Sea Elephant PJF2-150W Manual de usuario

Haier

Haier HP200S1 Hoja de especificaciones

Haier

Haier FCD-JTLD200 Manual de usuario

Haier

Haier FCD-JTLD100 Manual de usuario

Haier

Haier ES100V-G1 Manual de usuario

Haier

Haier TP180REL Hoja de especificaciones

Haier

Haier Little Sea-ox FCD-JTHC80-III (E) Manual de usuario

Haier

Haier ES25V-P1 Manual de usuario

Haier

Haier ES6VQ1 (R) Manual de usuario

Haier

Haier ES10V-E1 Manual

Haier

Haier FCD-JTHC100A-III (E) Manual de usuario

Haier

Haier EI39G1M(W) Manual de usuario

Haier

Haier FCD-JLD245 Manual de usuario

Haier

Haier ES8V-Q1(EU) Manual de usuario

Haier

Haier GV270REMB Manual de usuario

Haier

Haier ES15V-Q1(R) Manual de usuario

Haier

Haier FCD-SHX200A30 Manual de usuario

Haier

Haier FCD-JTHMG100-III Instrucciones de montaje

Haier

Haier ES45V-A1 Manual

Haier

Haier FCD-HTHMG50-III(E), FCD-HTHMG60-III(E), FCD-HTHMG80-III(E),... Manual de usuario

Haier

Haier ES10V-M1 Manual de usuario

Haier

Haier SILVER SEA-OX FCD-JTHMG100- E Manual de usuario

Haier

Haier GV100RNF Manual de usuario

Manuales populares de Calentador de agua de otras marcas

Kenmore

Kenmore 153.582400 Manual de usuario

Applimo

Applimo Edel AIR Manual de usuario

STIEBEL ELTRON

STIEBEL ELTRON Eltronom SHU 5 S Manual de usuario

clage

clage E-Mini Series Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-180 Manual de usuario

Bradford White

Bradford White EF Series Manual de usuario

Eccotemp

Eccotemp 40-H Manual de usuario

Dimplex

Dimplex ECSd125-580 Guía

Dux

Dux 32FCR6N Manual de usuario

Toyotomi

Toyotomi Oil Miser OM-148 (Type D) Guía de solución de problemas

Noritz

Noritz N-132M Manual de instrucciones

TESY

TESY GCV7/4S 10047 Hoja de especificaciones

A.O. Smith

A.O. Smith Gphe 50 Manual de usuario

Koryo

Koryo KWHZF15Y Manual de usuario

Pentair

Pentair PSC-14-4-02 Manual de usuario

GE 40M06AAG Instrucciones de montaje

Thermor

Thermor AEROMAX SPLIT 2 Manual de usuario

American Hometec

American Hometec AHQ-B03X Manual de usuario